A closed cylindrical tank filled with water has a hemispherical dome and is connected to an inverted piping system as shown in Fig. C. The liquid in the top part of the piping system has a specific gravity of 0.8, and the remaining parts of the system are filled with water. If the pressure gage reading at A is 60 kPa, determine: Hemispherical dome (A) The pressure in pipe B. (B) The pressure head, in millimeters of mercury, at the top of the dome (point C). SG = 0.8 PA = 60 kPa 4 m 3 m 3 m Water 2 m B Water Fig. C

A closed cylindrical tank filled with water has a hemispherical dome and is connected to an inverted piping system as shown in Fig. C. The liquid in the top part of the piping system has a specific gravity of 0.8, and the remaining parts of the system are filled with water. If the pressure gage reading at A is 60 kPa, determine: Hemispherical dome (A) The pressure in pipe B. (B) The pressure head, in millimeters of mercury, at the top of the dome (point C). SG = 0.8 PA = 60 kPa 4 m 3 m 3 m Water 2 m B Water Fig. C

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Two pipes A and B are connected in parallel between two points. Pipe A is 200 m long and has a diameter of 16 cm, pipe B is 150 m long and has a diameter of 12 cm. Both the pipes have the same friction factor of 0.018. A partially closed valve in pipe 'A' causes the discharge in the two pipes to be the same. All other minor losses can be neglected. The value of the valve coefficient is - Valve F = 0.018 L=200m, d-16cm L,=150m, d=12cm B F = 0.018
please answer to me quickly
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 30 cm above the pipe B. The height of oil in right limb is 50 cm. Also, the mercury level difference is found in right limb as 90 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm. The difference of pressure between two pipes (PA-PB) (Unit is in kPa) ? Equivalent to Water head in mm ?
The gage pressure (psig) at point a is nearest (a) 13.7 (b) 14.7 (c) 101.3 (d) 0 (e) 1 Oil a 3 in SG = 0.69 SThe gage pressure (psig) at point c is nearest (a) 57.2 (b) 1.4 (c) 6.7 (d) 0.4 8 in Water The absolute pressure (psia) the natural gas pipeline is nearest h, = 22 in (a) 8.4 (b) 65 (c) 9 (e) 23 16 in SThe gage pressure osig) in the natural gas pipeline is Natural gas Dif the pipeline pressure was increased by 50%, what cost- effective manometer modification(s) might be needed? (b) More mercury, less oil (c) Add 2 more manometer loops (d) Replace the manometer with a high-pressure gage (e) Rotate the gas line to a vertical alignment Mercury SG = 13.6
tank contains water upto a height of 1 m above the base. An immiscible liquid of sp. gr. 0.8 is filled on the top of water upto 1.5 m height. Calculate : () total pressure on one side of the tank, () the positiom of centre of pressure for one side of the tank, which is 3 m wide.
Please explain so I can understand
please answer quickly
height of water the pressure intensity : () at the interface of the two liquids, and (ii) at the bottom of the tank. [Ans. () 1.57 N/cm", (il) 3.04 N/em 6. An open tank contains water upto a depth of 1.5 m and above it an oil of sp. gr. 0.8 for a depth of 2 m. Find 7. The diameters of a small piston and a large piston of a hydraulic jack are 2 cm and 10 cm respectively, A force of 60 N is applied on the small piston. Find the load lifted by the large piston, when: (a) the piston at the same level, and (b) small piston is 20 cm above the large piston. The density of the liquid in the jackis [Ans. (a) 1500 N, (b) 1520.5 NJ kg given as 1000 - 8. Determine the gauge and absolute pressure at a point which is 2.0 m below the free surface of water. Take [Ans. 1.962 N/cm? (gauge), 12.066 N/cm? (abs.)] - atmospheric pressure as 10.1043 N/cm?. 9. A simple manometer is used to measure the pressure of oil (sp. gr, = 0.8) flowing in a pipe line. Its right limb is open to the atmosphere and left…
5-64. A thin rubber tube of 25 mm inside diameter is used to siphon water from the large tank of Figure 5.56. To prevent the tube from collapsing, the pressure inside the tube can not be less than 50% of the pressure outside the tube. Determine the smallest value of h to prevent the siphon from stopping due to collapsing of the tube. 2.5 m 5 m Figure 5.56 System for Exercise 5-64. THANK SUNTETICE Full Michifo Nas s itset SCH
Question is in figure