A closed circular tank filled with water and connected by a U-piezometric tube as shown in figure below. At the beginning, the pressure above the water table in the tank is atmospheric, and then the gauge that connected with tank read an increasing in pressure that caused falling in the water level in the tank by 3 cm. a) calculate the deference in height that accrued between water levels inside the tank and in the external tube leg. b) Determine the final pressure that was reading by the gauge.

A closed circular tank filled with water and connected by a U-piezometric tube as shown in figure below. At the beginning, the pressure above the water table in the tank is atmospheric, and then the gauge that connected with tank read an increasing in pressure that caused falling in the water level in the tank by 3 cm. a) calculate the deference in height that accrued between water levels inside the tank and in the external tube leg. b) Determine the final pressure that was reading by the gauge.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: re of water in a pipeline by means of a simple m mercury. The mercury l s 160 mm higher than t ne…

Q: An open vessel contains water up to a depth of 5.29 m and above it an oil of SG = 0.8 %3D for a…

Q: 1. If the level of the liquid measured by using capacitive probe and buoyant force is same, find the…

A: Buoyant force: It is the force applied on the object when any object is fully or partially submerged…

Q: A simple rainwater collector used for home garden use is show below. It is comprised of an open-air…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: A simple rainwater collector used for home garden use is show below. It is comprised of an open-air…

A: Since you have asked a multi-part question thus we can provide you the solutions to the first three…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

A: PA+ρwghw=ρmghmPA=13600×10×0.16-1000×10×0.035=21410 N/m2=2.141 kN/m2

Q: Find the pressure in kPa at the bottom of an 8m column of water

Q: A circular rod 5 m long and 20 cm² in cross section is attached to a block of volume 0.025 m³…

Q: A barometer at the top of the tank reads 101.35 KPa. A pressure gage 2 m from the bottom of the tank…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: A tank is filled with a certain liquid to height of 1.25 m from its bottom. If the pressure gauge at…

A: Given:Height of fluid in the tank, h=1.25 mPressure gauge reading at the botton, P=1.46 psi2.…

Q: b) At time t= 0 the height of water in the tank is h0. Find an expression for the height as a…

A: For the solution refer below images.

Q: The pressure at point 1 in Figure A is 60KPa. Afterwards, the pressure at point 1 is increased and…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: QI:: A- The absolute pressure in water at a depth of 5 m is read to be 145 kPa. Determine the…

Q: QUESTION 3 When valve A is closed, the pressure difference between A and B is -27 kPa. Find h when…

A: The pressure exerted by the fluid at a point which is located at a depth of h from the free surface…

Q: Find the pressure in kPa in the water pipe shown if x = 9.411 cm. Oil 5 cm 10 cm Water 7 cm Mercury…

Q: A closed pressurized tank shown below is filled with oil and mercury. Mercury is confined in an…

Q: A container shown is at 90 deg F, The pressure at point A was measured at 41 in of Hg. Find the…

A: Given Pressure at point A=PA=41 in Hg=4112 ft in Hg

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: A simple rainwater collector used for home garden use is show below. It is comprised of an open-air…

Q: 1.) An open tank is filled with three different columns of fluid shown in the figure. Fluid 1 is a…

Q: A circular hatch of diameter d = 1,84m is mounted on an inclined wall in a pool, which indicated on…

A: Given:Diameter of the hatch, d=1.84 mSpecific weighgt of water, γ=10 kN/m3Inclination angle of the…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: s) A cylinder that is 750 mm in diameter and 2.5 m long has a specific weight of 835 N/m³. It eid…

Q: 3. A container shown is at 90 deg F, The pressure at point A w. the pressure at point B, C and D in…

A: Temperature = 90°FPressure at point A (pA)=41 in of Hg = 2900 lbf/ft2 To-Find:- Pressure at point…

Q: 5. Two vertical cylindrical storage tanks are full of liquid water, density atmoshere. One is 10 m…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: Your work is to study the following well-type manometer that will be used for students in the fluid…

A: Data given- The manometer is built with a tube diameter of 20 mm reservoir diameter of 10 cm

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: here the temperature is use where the tempera ults in infiltration even

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

EXAMPLE 4:
A closed circular tank filled with water and connected by a U-piezometric
tube as shown in figure below. At the beginning, the pressure above the water table
in the tank is atmospheric, and then the gauge that connected with tank read an
increasing in pressure that caused falling in the water level in the tank by 3 cm.
a) calculate the deference in height that acerued between water levels inside the
tank and in the external tube leg. b) Determine the final pressure that was reading
by the gauge.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An open tank contains water up to a depth of 1.2m from the bottom and above it mercury for a depth of 0.7m and above it an oil of specific gravity 0.8 for a depth of 1.1m. Assume the atmospheric pressure is 1 bar. Find the gauge pressure and absolute pressure i) at the bottom of the container, ii) at the interface of water and mercury and iii) at the interface of an oil and mercury.
Question 3 pls. Complete solution and units
The pressure of water in a pipeline was measured by means of a simple manometer containing mercury. The mercury level in the open tube is 175 mm higher than that of the left tube. The height of water in the left tube is 37mm. Determine the static pressure in the pipe in a).kN/m². b) Head of water in meters, The static pressure in the pipe in kN/m2 Head of water in meters =
Pls show step by step solution thank you
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 35 cm above the pipe B. The height of oil in right limb is 25 cm. Also, the mercury level difference is found in right limb as 90 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm.
A tank open to the atmosphere contains oil of sp. gr. = 0.80, gasoline sp.gr. =0.90 and seawater sp.gr. = 1.03. If the depths of the liquids are 0.65 m., 0.92 m., and 1.15 m. for oil, gasoline and sea water respectively. Find the absolute pressure at a depth of 2 m.