A circular vitrified sewer pipe is laid on a slope of 0.0002 and it is to carry 83.5 cu. ft. per second when the pipe flows at 90% of its depth. If n = 0.015, what size of pipe in ft should be used?   Round your answer to 3 decimal places.

Q: In the context of a sewer system, your objective is to find the optimal slope (SS) of a pipe to meet…

A:

Q: Solve the following pipe network using Hazen William Method CHw =100 63 L/s 4 3 2 37.8 L/s pipe L 1…

A: Given data, CHW=100

Q: Given the data below, design a section of sanitary sewer to carry these flows at a minimum velocity…

A: minimum velocity of 0.6 m/s, n=0.013 minimum cover above the sewer pipe is 1.5m

Q: A circular pipeline stretches 202 miles from an initial elevation of 510 ft to a final elevation of…

A:

Q: A street gutter has a side slope of 25:1, a longitudinal slope of 0.03 and a Manning's "n" of 0.013.…

A: A street gutter side slope (SS:1) = 25:1  Longitudinal slope (S) = 0.03 Manning's coefficient (n) =…

Q: An industrial water-distribution system is schematically shown in Figure P4.4.4. The demands on the…

A: Steps for calculating Flow rate or pressure at each junction in industrial water -distribution are…

Q: A line source c vithin a uniform ight to left). At from the source

A:

Q: Five 25 mm diameter pipes will conduct 2.4 l/s of water (20 ºC) between two reservoirs whose surface…

A: The reduction in the total head of the water or fluid caused due to the motion in the system is…

Q: Find the diameter of a circular sewer pipe which is laid at a slope of 1 in 8000 and carries a…

A:

Q: A 250 waste water pipe is installed on a slope of 0.010 mm/mm and has a roughness n = 0.013.…

A: Hence Velocity (V) = 1.222 m/s Depth of flow = y= 0.125 mExplanation: Step 2: Step 3: Step 4:

Q: What is the flowing-full capacity and velocity for a 500-mm-diameter sewer (n = 0.013) on a slope of…

A: The formula for the full-flowing capacity of a circular pipe is given by: Q = 0.0058 * A * V where Q…

Q: Water flow through a 100 mm diameter pipe with a velocity of 0.015 m/sec. If the kinematic viscosity…

A: Diameter of pipe = 100 mmkinematic viscosiy of water = 1.13 X 10-6Velocity of water = 0.015 m/secTo…

Q: The existing configuration for a water distribution system is presently considered inefficient. A…

A:

Q: In the figure, a 2" pipe leads downhill from a reservoir and discharges into air. If the loss of…

A:

Q: An averaged vitrified sewer pipe (n = 0.015) is laid on a slope of 0.0002 and is to carry 2.36 m3/s…

A: Given: Manning's constant, n = 0.015 Channel slope, S = 0.0002 Discharge, Q = 2.36 m3/s Pipe flow, h…

Q: Q2) A circular sewer one meter in diameter conveys a discharge of water at a depth of 0.2 m during…

A:

Q: please could someone show me how U2 = 1.98m/s. This is the correct answer but i've tried a few…

A:

Q: Design a circular sewer pipe having an average discharge flow 40 lit/sec. Given: • Sewage velocity =…

A:

Q: Determine the size in ft of a circular vitrified pipe sewer which will be used to discharge 15 cfs…

A:

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.