A circular swimming pool full of water has a diameter of 24 ft and the sides are 5 ft high. Set-up the integral for the work required to pump all of the water out over the side? ₂5 8985.6T (5-y)dy 12 1560π (12-y)dy 0 5 62.4π S (5-y)(y³-5y²-25y + 125)dy 5 748.8T S (5-y)dy

A circular swimming pool full of water has a diameter of 24 ft and the sides are 5 ft high. Set-up the integral for the work required to pump all of the water out over the side? ₂5 8985.6T (5-y)dy 12 1560π (12-y)dy 0 5 62.4π S (5-y)(y³-5y²-25y + 125)dy 5 748.8T S (5-y)dy

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: with a height of 4798.40m. If we hypothetically assume that the 471.87mol-coin is made of pure…

A: Given Data:- A coin dropped from a certain building with a height of 4798.40m If we hypothetically…

Q: L In the following model of a physiological system, find the equation in S domain relating between…

Q: 2. A steady flow system receives a 5-lb fluid with an initial properties of v = 15 ft/s, H1= 108 BTU…

A: The mass of the fluid is,

Q: A certain fluic ined in a cylinc n, the initial v 05m^3. Calcula done by the 1

A: Given : P1 =10 bar = 1000 kPa V1 = 0.05 m3V2 = 0.06 m3

Q: 7. A hemispherical tank of radius 6 feet is positioned so that its base is circular. How much work…

Q: 82. In the U-tube above, Y and X are on the same horizontal level and 30cm of air is trapped above Y…

A: Given data: The volume of air in limb Y is V1=30 cm3. The pressure is P1=75 cmHg. The new pressure…

Q: A hand-driven tire pump has a piston with a 3.00 cm diameter and a maximum stroke of 25.0 cm. (a)…

Q: A circular swimming pool has a diameter of 12 m, the sides are 4 m high, and the depth of the water…

A: Given, Diameter=12m Side's are 4m high. Depth of water=3m Workdone=?

Q: A 10kg mass sits inside a cylinder of cross-sectional area 0.05m² and is attached to one end by a…

A: Frequency in physics refers to the number of waves passing a fixed point in a unit of time. Periodic…

Q: 1. The potential energy of water in a cylindrical tank located on toe of a building 15 m high is 150…

A: Height (h) of building = 15 m Potential energy = 150 kJ height of water level = 3 m

Q: If a gas in a cylinder pushes back a piston against a constant opposing pressure of 3.86 × 105…

A: Constant Pressure (P) = 3.86×105 Pascals Change in volume (∆V) = 0.657 m3

Q: A hand-driven tire pump has a piston with a 2.9 cm diameter and a maximum stroke of 28 cm. a) How…

Q: Calculate the work done in breaking a mercury drop of radius 1 mm into one thot all of the same…

A: To find-Work done in breaking a mercury drop =?Given data-Radius R=1 mm R=10-3 mSurface…

Q: Gas in a container is at a pressure of 1.7 atm and a volume of 8.0 m3. (a) What is the work done on…

Q: You have 100.0 m3 of an ideal gas at 300.0 Pa, and it expands, doing 6000.0 J of work. What is the…

A: The initial volume of the gas, Vi = 100.0 m3 Pressure, P = 300.0 Pa Work-done, W = 6000.0 J

Q: One mole of an ideal gas does 1700 J of work as it expands isothermally to a final pressure of 1.00…

A: One mole of an ideal gas does 1700 J of work as it expands isothermally to a final pressure of 1.00…

Q: What is the pressure of the gas in the cylinder, in kPa (kiloPascal)? h = 0.700 m, Pmercury = 13,600…

Q: Gas in a container is at a pressure of 1.2 atm and a volume of 7.0 m3. (a) What is the work done on…

A: The pressure in the container is given as, P = 1.2 atm The pressure in Pascal is calculated as, P =…

Q: Using the pump selection table below to determine the best pump for the given condition: • A flow of…

A: A point is the basic relationship displayed on a graph. Each point is defined by a pair of numbers…

Q: 5. A semicircular cylindrical tank holds water. The semicircular cross sections have radius 3m and…

A: Given Data: Radius of tank, r=3 m Length of the tank, L=10 m Density of water, ρ=997 kg/m3 volume of…

Q: 21 // In an isothermal procedure, if the fluid pressure at the beginning is equal to (200 kp) and…

A: Solution:-Given thatInitial pressure (P1)=200 kPa=200×103 PaInitial volume (V1)=2 m3Final volume…

Q: conical container of radius 9 ft and height 36 ft is filled to a height of 33 ft with a liquid…

Q: a vacuum pump is used to raise water from a well a distance h below the pump. (a) what is the…

A: At the same level, the pressure would always be the same unless our system is accelerating…

Q: A tank is full of water. Find the work W required to pump the water out of the spout. (Use 9.8 m/s2…

A: Step 1:Step 2:Step 3:

Q: A circular swimming pool has a diameter of 12 m, the sides are 4 m high, and the depth of the water…

Q: a. -7.848, 4.905, 4.905, 21.67

A: a. -7.848, 4.905, 4.905, 21.67

Q: The tank shown is full of water.(a) Find the work required to pump the water out of thespout.; (b)…

Q: An oxygen tank contains 96.0 g of oxygen that has 6.00 atm of pressure at 77.0 °F. After some of the…

A: The initial pressure P1=6 atm=61.013×105 Pa=6.1×105Pa The initial temperature T1=77.0°F=298.15 K…

Q: A circular swimming pool has a diameter of 14 m, the sides are 3 m high, and the depth of the water…

Q: A hand-driven tire pump has a piston with a 3.00 cm diameter and a maximum stroke of 35.0 cm. (a)…

A: (a) The area of the pump is, A=πr2=πd24=3.140.03 m24=7.07×10-4 m2 The volume of the piston is,…

Q: An aquarium 9 m long, 1 m wide, and 1 m deep is half-filled with water. Find the work needed to pump…

A: Given: Length of aquarium (l) = 9 m. Width of aquarium (w) = 1 m. Height of aquarium (h) = 1 m.…

Q: 24. A hot air balloon with a mass of 700kg ascends at a constant rate of 1.60m/s for 20.0s. How much…

Q: A piston has an external pressure of 12.0 barbar. How much work has been done in joules if the…

A: Write the expression for the work done. W=P(V2−V1)

Q: A tank is full of water. Find the work W required to pump the water out of the spout. (Use 9.8 m/s²…

Q: A hand-driven tire pump has a piston with a 2.50-cm diameter and a maximum stroke of 30.0 cm. (a)…

A: Given: Diameter of the piston is d = 2.50 cm = 0.025 m. Maximum height is hmax = 30.0 cm = 0.3 m.

Q: A hand-driven tire pump has a piston with a 2.8 cm diameter and a maximum stroke of 24 cm. Part (a)…

Q: A tank has the shape of an inverted circular cone with height 11 m and base radius 8 m. The tank is…

Q: The equation for calculating the work performed when a piston in a cylinder expands against a…

A: Given data: Pressure (P) = 1.21 atm Change in volume (ΔV) = 2.56 mL 1 atm = 101325 Pa Required:…

Q: A cylinderis fitted with a piston beneath which is a spring, as in the attachment. The cylinder is…

A: Given: r=0.032m K=4300 N/m P=1.01325×105pa

Question

A circular swimming pool full of water has a diameter of 24 ft and the sides are 5 ft high. Set-up the integral for the work required to pump
all of the water out over the side?
₂5
8985.6T
(5-y)dy
12
1560π (12-y)dy
0
5
62.4π
S
(5-y)(y³-5y²-25y + 125)dy
5
748.8T
S (5-y)dy

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A snorkeler takes a deep breath at the surface, filling his lungs wit 4.0 L of air. He then descends to a depth of 5.0 m, where the pressure is 0.50 atm higher than at the surface. At this depth, what is the volume of air in the snorkeler's lungs? [
The tank shown contains water to a level1 meter from the top. The tank is 3-meter wide at the top, and it has a depth of 3 meter and a length of 8 meter. Find the work required to pump all the water out of the spout, 2 meter above the top of the tank (the density of p = 1000; acceleration due to gravity at the earth's surface is 9.8) 14. kg and the m3 m TA十al
If during an expansion process the volume of a gas changes from 0.2 to 0.5 m^3 and pressure changes according to equation P= 1500(v/100+1) where P is in Pa and V is in m^3. What is the work done by gas in kJ?
A hand-driven tire pump has a piston with a 2.50-cm diameter and a maximum stroke of 30.0 cm. (a) How much work do you do in one stroke if the average gauge pressure is 2.40 × 105 N/m2 (about 35 psi)? (b) What average force do you exert on the piston, neglecting friction and gravitational force?
A rigid tank contains 9.744 kg of a saturated mixture of liquid and vapour water at 500 kPa. The dryness fraction x is 0.10. The volume of the tank will be?
5) The given tank is filled with diesel, 850 kg/m. a) Setup the force on the circular face of the tank. 0.8 m 10 m 1.2 m b) Setup the work draining the fuel through the spout?
ASAP
Please answer the table below.
A trough full of water is 20ft. long and its cross section is in the shape of an isosceles triangle 4ft. wide across the topand 4ft. deep. How much is the work done in pumping all the water out of the trough over the top?
Assume that a raindrop has a volume of 0.05 cm^3 and you need an Avogadro's number of raindrops to fill up the cubic water tank. What is the length of the edge of the tank?
6.2
A coin dropped from a certain building with a height of 4975.27m. If we hypothetically assume that the 371.57μmol-coin is made of pure nickel and that nickel has a molar mass of 59g/mol, what is the force of the coin as it hits the asphalt? Use 9.81m/s squared for the gravity