A circular disc bears against a frame structure and a wall, as shown in the figure. All contacts with the disc are frictionless. The frame structure has pin supports at A and B; there is an internal pin connection at C. If the maximum allowable reaction force at either of the pin supports is 8 kN, what is the maximum allowable weight of the disk?

Q: A weight of p lb is suspended from a chain of length & while a constant force of Fw pushes the…

A: Given that:

Q: Two cables are tied together at C and are loaded as shown. Deter- mine the tension (a) in cable AC,…

A: Solution: Given that load W =400 N

Q: Consider the following sytsem and a) draw FBD for all components and lable all forces, b) determine…

A: Given:- A figure  Find:- a) Consider the following system and a draw FBD for components and label…

Q: A met stk hs a mase f 0.21 kg and bnon at s.cobtWhea ml chans upended brom one end, the balaor pont…

A:

Q: A horizontal force of of 300 N is required to maintain constant velocity of a vehicle on the level,…

A: Given : Horizontal force F = 300 N               Force = 1100 N               Speed = 6 m/s…

Q: 12 = —аў сos ф +aî sin ø 13 l1 = bê b `în = ât cos o a B = âB 14 -12 + ŷ sin o Figure 1: Geometry of…

A: Hi there! Since there are multiple subparts in the question posted and it is not mentioned what is…

Q: don't believe this is correct, because the Force is not 12 N throughout, and we must factor in the…

A: Given, mass of the particle, m = 9 kg the time-dependent force experienced by the particle, Fd = 6t…

Q: Ed is pushing with a force of 203.3 N at an angle of 0 = 57.5 degrees with respect to the vertical…

A: Given: FEC=203.3 Nθ = 57.5 °FAC=87.3 Nϕ=36.1°Mass of couch = 71 kgCoefficient of static friction =…

Q: sphere of mas 1 table caith lineat elo cily & Yo/8. fend ili eneigy - A solid keg seolls on a total…

A: Given,mass=1kgv=2 m/s

Q: An electrician holds a chandelier of mass 2.9kg upwards against a ceiling with a force of 47N…

A:

Q: 14. Wires A, B and C carries 4A, 8A and 10 A, respectively. The distance between wire A and wire B…

A: A current carrying conductor produces magnetic field around it. This magnetic field applies a force…

Q: If the resultant of the loads shown passes through point B, determine the equivalent force-couple…

A: The net force in the x-axis is calculated as:The net force in the y-axis is calculated as:

Q: (c) Water discharges into the atmosphere through a pipe junction shown in Figure Q2 (c). Determine…

A: The water discharges through a pipe junction and the pressure at the flange is 70kPa. Given that the…

Q: A ship of mass 4.5 x 100 kg starts from rest under the force a constant propeller with a thrust of…

A: Given:  Mass of the ship: m = 4.5×105 kg Thrust force F = 900,000 N Resistance force, R= 150,000 v…

Q: A beam AB is attached to a rocker at A and a pin at B. it is subjected to three forces as shown in…

A: Need to calculate the vertical component of reaction at pin B.

Q: The imoment of me For ce 40 N shown equal Iz Nim petermine me lengm of x. 25

A:

Q: 2- FBD on the crate only, consider friction.

A: Given:-  Two figure is given as    Figure a)…

Q: Please, Calculate the applied force with unitsw calculation. A box of mass 5 kg resting on a…

A: Given that:- The mass of the box is m = 5 kg  The resistance force or friction force is Fr= 6N The…

Q: 18 O A person is holding their arm out 28° above the horizontal. The mass of their arm is 4.skg the…

A:

Q: If FB = 700 N, and FC = 560 N, determine the magnitude and coordinate direction angles of the…

A:

Q: MA-2Kg Note W= mg Where g=9.81 m/s" B MB-4 kg Det. the auelerastion @ w/c the 4 kg b lock BWfill…

A:

Q: ermine the magn e (RN) IH Member BC II 396 N 54m. Round off only on the final answer expressed in 3…

A: Given, F=89396 Na= 2.75 mb=0.92 mc=4.54 mFrom figure Rc=F=89396 NHc=HBTakingmoment about…

Q: A car engine wvith a glven welght of w, Is suspended in alr by a cable that Is connecled lo a to the…

A: Questions based on the concept of force Note- mass of engine is not visible in question so force are…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A:

Q: CEE 241: Statics University of Nevada, Las Vegas Image copyright © Pearson Education, Inc. Shared…

A: Given:-  We have given that the weight of the lamp is mg = 15lbf  The lamp is substandard by the…

Q: A box of mass M = 50 kg rests on a rough (is) horizontal surface. When a force F = 100 N is acted on…

A:

Q: the hordonl ag of cement weighing 0Nhangsin um from three wes a uestedin the gure bel Tf the wmenes…

A:

Q: The collar at C slides on a frictionless bar AB, which is fixed in space. Cable CDE passes around a…

A: Given: The values of xD = 1 in The values of yD = 14 in The system's free body diagram as shown…

Q: A 5.0-kg block and a 4.0-kg block are connected by a 0.6-kg rod as shown: B 5.0 kg 0.6 kg 4.0 kg The…

A:

Q: The 1,094 kg uniform beam is subjected to the three external loads shown. Compute the force reaction…

A: Given data- weight of beam W=mg=(1094 kg)(9.8 m/s2)=10721.2 N=10.7 kN at point A=1.4 kN=1400 N…

Q: mm (geu Moelu a=20'(Presme auyle) O Determine the peeed saho i of the reducer Oseuw the free body…

A: Since you have not mentioned any specific subpart to be solved, we will be solving the first three…

Q: ore ge.co TED CCU... ect n ol.sona- om bject Pool epartment... 9. A mass m₁ = 19.0 kg is connected…

A:

Q: amons Deter mine the required weight oF block A so that block B will impend Upuard, assuming 47N…

A:

Q: Knowing that the tension is 555 lb in cable AB and 470 lb in cable AC, determine the magnitude and…

A: Given: The tension in the cable is TAB = 555 lb The tension in the cable is TAC = 470 lb The…

Q: 10. Consider the complicated arrangement below: ol mi bega aldaco wo bosce ond ltod berdos and od…

A: The heavier mass goes down. Assume mass m1 is greater than mass m2.

Q: ,how many seconds does it take to come to rest?

A:

Q: - / 1 Question 1 of 3 VICTT E VIC I Current Attempt in Progress The turnbuckle is tightened until…

A: Given: The turnbuckle is tightened until the tension in the cable equals 2.3 kN. The diagram is as…

Q: Determine the maximum force P the connection can support so that no slipping occurs between the…

A: Tension in each bolt is 4 kN There are 4 bolts used in the connection.

Q: In the figure here three ballot boxes are connected by cords, one of which wraps over a pulley…

A: Given data: Mass of box A, mA = 32 kg Mass of box B, mB = 45 kg Mass of box C, mC = 13 kg

Q: Exio the block of weight (u) is supported by arope that is warpped one and one halftimes around the…

A: Given Block of weight = W Static friction     = 0.2

Centripetal Force

A particle, body, object or certain mass while travelling in a rotational path or semicircular path, experiences an inertia force. If that inertia force pulls the towards the inward of the imaginary circle in the rotation, it is termed as centripetal force.