A circular conducting loop of radius b = 10 cm exists adjacent to an infinitely long power line carrying 50 Hz current as shown in figure. If the separation d = 15 cm, the total impedance of the loop is 0.012 and the current flowing in the loop is measured to be 0. 5 mA. a) Find the magnitude of the power line current b) find the angle of rotation of the circular loop around the dotted axis that is needed to decrease the loop current by 50%

A circular conducting loop of radius b = 10 cm exists adjacent to an infinitely long power line carrying 50 Hz current as shown in figure. If the separation d = 15 cm, the total impedance of the loop is 0.012 and the current flowing in the loop is measured to be 0. 5 mA. a) Find the magnitude of the power line current b) find the angle of rotation of the circular loop around the dotted axis that is needed to decrease the loop current by 50%

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

In the figure, a 140-turn coil of radius 3.3 cm and resistance 6.9 Q is coaxial with a solenoid of 240 turns/cm and diameter 4.1 cm. The solenoid current drops from 1.7 A to zero in time interval At = 28 ms. What current is induced in amperes in the coil during At? Coil Solenoid Number i Units
Two resistors of resistance R1and R2 are placed in series across a battery with voltage V, such that a current I=V/(R1+R2) flows around the circuit. If a coil with inductance L is then placed inparallel withR1, what is the new currentIa long time after the coil has been added? Give your final answer.
An inductance L, a capacitance C, and a resistance R are connected in series with a voltage source V(t). Given that q(0) i(0) 0, what is the second order differential equation whose solution is the current i(t) where t> 0? a. L+ IR + = 0 b. L+ iR + = v(t) +R d. e. None of the above
Q01
1. A coaxial cable is made of a metal wire of radius a surrounded by a thin metal tube of radius b. The space between the conductors is evacuated. a) Find the capacitance per unit length of this coaxial cable (Hint: Imagine equal but opposite charges to be on the wire and the tube), b) Find the inductance per unit length of this coaxial cable (Hint: Imagine a current i flowing down the center wire and back along the tube.)
The current in a long solenoid of radius 6 cm and 22 turns/cm is varied with time at a rate of 3 A/s. A circular loop of wire of radius 8 cm and resistance 7 0 surrounds the solenoid. Find the electrical current induced in the loop (in HA). HA
Two coils are placed close together in a physics lab to demonstrate Faraday's law of induction. A current of 8.00 A in one is switched off in 2.00 ms, inducing a 3.00 V emf in the other. What is their mutual inductance (in mH)? mH Additional Materials Reading
N:41)
Coil A is a large 300 turn circular coil of radius 77 cm. Circular coil B has 390 turns, a radius of 5 cm and is located L=99 cm from coil A along the same axis. The planes of the two coils are parallel. A) Find the approximate mutual inductance of this pair of coils. for my answer I got 3.527E-10 H which was wrong B) If the current in coil A varies with time according to I=3t3−8t2−1, where I is in amps and t is in s, find the magnitude of the EMF induced in coil B at time t=2 s.
1. An AC generator has 85 rectangular loops on its armature. Each loop is 11 cm long and 8 cm wide. The armature rotates at 1500 rpm about an axis parallel to the long side. If the loop rotates in a uniform magnetic field of 0.8 T, which is perpendicular to the axis of rotation, what will be the maximum output voltage of this generator? Volts
What is the radius of a tightly wound solenoid of circular cross-section that has 170 tusifa change in its internal magnetic field of 40T/s causes a 70 A current to flow/ The restance of the circuit that contains the solenoid is 150. The only emf source for the circuit is the induced eml. a) 0.22 m b) 0.059 m c) 0.015 m d) 0.79 m