A circular coil enclosing an area of 200 cm2 is made of 210 turns of copper wire. The wire making up the coil has resistance of 3.0 2, and the ends of the wire are connected to form a closed circuit. Initially, a 1.6-T uniform magnetic field points perpendicularly upward through the plane of the coil. The direction of the field then reverses so that the final magnetic field has a magnitude of 1.6 T and points downward through the coil. If the time required for the field to reverse directions is 0.50 s, what is the average current in the coil during that time? A

A circular coil enclosing an area of 200 cm2 is made of 210 turns of copper wire. The wire making up the coil has resistance of 3.0 2, and the ends of the wire are connected to form a closed circuit. Initially, a 1.6-T uniform magnetic field points perpendicularly upward through the plane of the coil. The direction of the field then reverses so that the final magnetic field has a magnitude of 1.6 T and points downward through the coil. If the time required for the field to reverse directions is 0.50 s, what is the average current in the coil during that time? A

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A magnetic field is perpendicular to the plane of a single-turn circular coil. The magnitude of the field is changing, so that an emf of 0.61 V and a current of 2.1 A are induced in the coil. The wire is then re-formed into a single-turn square coil, which is used in the same magnetic field (again perpendicular to the plane of the coil and with a magnitude changing at the same rate). What (a) emf and (b) current are induced in the square coil?
Consider a thin rod of resistance R = 12.0 Ohm, mass m = 60.0 g and length L = 20.0 cm. It is free to slide without friction on a vertical U-shaped wire. There is a uniform magnetic field of magnitude B = 1.20 T directed into the page, and the rod is stationary at t = 0 s.
A coil consisting of 88 windings of insulated wire is circular in shape with a radius r = 9.5 cm. The magnetic field is uniform throughout the coil and perpendicular to the coil's area, but it is changing with time. The magnitude of the magnetic field is initially 0.45 T and then changes at a constant rate until it has the same magnitude in the opposite direction. This change occurs over a time interval At =0.20 s. What is the magnitude of average emf induced in the coil during this time interval? E = V If instead the magnetic field in the same coil remains constant at B = 0.45 T (in the same direction perpendicular to the coil's area, initially) and the coil itself is then rotated at a constant rate until it has inverted (gone through a rotation of 180°) during a time interval At = 0.10 s, what is the magnitude of the average emf induced in the coil during this time interval?
At a certain place, Earth's magnetic field has magnitude B =0.806 gauss and is inclined downward at an angle of 71.1° to the horizontal. A flat horizontal circular coil of wire with a radius of 13.1 cm has 939 turns and a total resistance of 73.9 Q. It is connected to a meter with 130 Q resistance. The coil is flipped through a half-revolution about a diameter, so that it is again horizontal. How much charge flows in coulombs through the meter during the flip? Number Units
A flexible conducting loop of diameter d0 and resistance R lies perpendicular to a uniform magnetic field B⃗ . At time t=0 the loop begins to expand, with its diameter given by d(t)=d0+bt, where b is a constant. The loop's resistance doesn't change as it expands.
You wish to construct a solenoid with a diameter of 2.00 cm that will produce a magnetic field of 6.20 × 10¬2 T at its center when a current of 14.0 A is passing through the coils. You want the resistance of the coil wire to be 5.60 . The resistivity of the wire used is 1.70 x 10-8 N:m (at 20.0°C), and you are using a wire that has a cross sectional area of 3.14 × 10¬8 m². (Note that this solenoid may not necessarily be so tightly wound that the adjacent loops of wire will touch each other. Nonetheless, you may assume that it behaves like an ideal solenoid.) Determine the following. (a) number of turns needed on the solenoid turns (b) length of the solenoid
A circular loop of radius 12.4 cm is placed in a uniform magnetic field. (a) If the field is directed perpendicular to the plane of the loop and the magnetic flux through the loop is 8.50 ✕ 10−3 T · m2, what is the strength of the magnetic field? T(b) If the magnetic field is directed parallel to the plane of the loop, what is the magnetic flux through the loop? T · m2
As shown in the figure, a rectangular loop with a length e of 20.0 cm and a width w of 15.0 cm has 20 turns and carries a current of 0.41 A counterclockwise around the loop when viewed from the positive x-axis. A horizontal (parallel to the x-z plane) magnetic field of magnitude 0.047 T is oriented at an angle of 65° relative to the perpendicular to the loop (the positive x-axis). (Assume the length and width are measured along the z and y-axes, respectively.) -x-z plane
A magnetic field is perpendicular to the plane of a single-turn circular coil. The magnitude of the field is changing, so that an emf of 0.45 V and a current of 2.8 A are induced in the coil. The wire is then re-formed into a single-turn square coil, which is used in the same magnetic field (again perpendicular to the plane of the coil and with a magnitude changing at the same rate). What (a) emf and (b) current are induced in the square coil? (a) Number (b) Number MI Units Units
A 150-turn rectangular coil having dimensions of 6.0 cm by 3.0 cm is placed in a uniform magnetic field of magnitude of 1.4 T. Assume the max torque exerted on the wire by the magnetic field is 0.15 . Find the magnitude of the torque on the coil when the magnetic field makes an angle of 33º with the normal to the plane of the coil. 2.72319518 0.23691798 1.36159759 1.36159759
At a particular point on Earth, the magnitude of the Earth's magnetic field is 2.50 ✕ 10−5 T. At this point, the field through a small square loop is essentially uniform. The area of the loop is 40.0 cm2. What is the magnitude of the magnetic flux (in T · m2) through the loop when the loop is at the following orientations? (a) the magnetic field is perpendicular to the plane of the loop (b)the magnetic field and the normal to the plane of the loop are at a 23.0° angle (c) the magnetic field and the normal to the plane of the loop are at a 90.0° angle
A coil of wire containing four circular loops with radius 0.4 m lies in the plane of the page. A uniform magnetic field points into the page, increasing from 0.4 T to 0.6 T in 0.2 s. Find the magnitude and direction of the emf generated in the coil.