A certain engineering equipment is supported by the foundation shown in figure 3.49. The diameter of the circular pin is 25 mm o. Fy = 345 MPa. Which of the following gives the value of P so as not to exceed the allowable bearing stress of the circular pin. Which of the following gives the value of P so as not to exceed the allowable shearing stress of the circular pin. 3, Which of the following gives the value of P so as not to exceed the Circalar pin 50 100 50 1 allowable bending stress of the circular pin. P/2 P/2

Q: Discuss the potential of 3D printing in architectural design and its applications in construction

A: Discuss the potential of 3D printing in architectural  design and its applications in construction.

Q: Which of the following is the largest scale? O 1cm:1mile O 1 mm:10m O. 1:1000 1cm:1km

A: to check largest or smallest scale firstly convert all numerator and denominator in same unit of all…

Q: How can I find GH, EG and FH

A:

Q: What is the most common scale used for temperature

A: The Celsius and fahrenheit scale is used most commonly used.. Kelvin scale is primarily used in…

Q: XXXX W₂ W₁ Which of the following most nearly gives the external degree of indeterminacy? 2 4 O 1

A:

Q: Step 5 incomprehensiable

A: In the step 5Settlement can be calculated using as below

Q: What is specific gravity (sp gr)

A: Given data in question  Specific gravity  To be discussed  What is specific gravity    Specific…

Q: Which is the most common type of BIM model where a specification constrains what can be modeled?…

A: This question is related to the Building design from Civil Engineering.