A cast-iron pipe transports water from a reservoir A and discharge it into air through a rotary valve at a location 100 m below the water surface elevation at the reservoir. a)  Draw the HGL and the EGL b)  Determine the discharge if the temperature of the water is 10°C. Consider minor losses

Q: STH /A- PAFT

A: Given: To solve this problem, we have to apply the Bernoulli equation between the headrace and the…

Q: For a spiral membrane filtration system, the membrane was fabricated by adding additional shims to…

A: step 1-

Q: d) e) f), with full solution

A: d) The yield point is the point on a stress-strain curve that indicates the limit of elastic…

Q: For the hydraulic system shown below. 1- Determine the resistance and discharge of each pipe. CLO1,…

A: Given, PA=100 KPa Head=PA9.81=10.19 m Net head =10.19+40=50.19 m Let head loss in pipe 1 =△h1 Head…

Q: Q2 A) For a flow rate of 300 liters/second at a velocity of 1.3 meters/second, design a seamless…

A: Fluid is an important part of the fluid mechanic's sector. Fluid can be compressible or…

Q: 8. Energy is not conserved throughout the pipe. a) True b) False

A: Energy is not conserved throughout the pipe.a) Trueb) False

Q: 7. A PFR is not meeting effluent requirements so baffles are going to be added to the tank to…

A: Given data:- The given tank size, deep=12 feet wide=40 feet long=120 feet The given influent…

Q: The head in a vessel with vertical sides and a height of 4m at the instant of opening an prifice was…

A: We have to determine the value of constant head under which on the same time the orifice would…

Q: Problem 2. A reverse osmosis membrane has a kw values of 2.5-10 L/(m²-s-bar) and an average ks value…

A: Step 1:

Q: n open storage vessel has 3m of oil (specific gravity=0.82) and 6m of water. Find the pressure at…

A: Given:Specific gravity of oil=0.82oil head=3 mwater head=6 m

Q: a-) Is the flow field given in (1) incompressible? b-) Is the flow field given in (1) irrotational?…

A:

Q: 6. If the two reservoirs are kept at the same level, the head loss is a) Z1-Z2 b) Zero c) T2-T1 d)…

A: (b)  is the correct answer When reservoirs are at same elevation their piezometric heads are same…

Q: Q3 - A WSP system is going to be designed for a new town that receives 10000+(Y×1000) m/d with…

A: i}  For effective removal of BOD and upto 99% pathogens (E.Colli}  we can arrange on design…

Q: You are designing a storm drain for a new parking lot. The topographic conditions at the site…

A: Pipe slope = 0.013Flowrate = 17 cfsConsider, the use of concrete pipe (n= 0.013)use of corrugated…

Q: Glycerin (specific gravity 1.26) in a processing plant flows in a pipe at a rate of 805 L/s. At a…

A: Given data:

Q: Plot Xa and S/Sº vs Theta for So= 2000, 200, 20, and 2.

A: Given that :-Required that :-

Q: 7.30 FLUS For this refinery pipe, DA = 20 cm. Dg = 14 cm, and L= 1 m. If crude oil (S = 0.90) is…

A:

Q: The tidal turbines are placed.. O a. Under the sea water O b. Under the ground O c. On the ground O…

A: Tidal turbines are like similar to that wind turbines which is used to generate power  Tidal…

Q: Find the discharge Q of oil from the setup

A: solution: we know that, p1γ + V122g + z1 = p3γ + V322g + z3 + HL 0 + 0 + 5.00 = 0+ V322 x 9.81 +0 +…

Q: A rigid, well-insulated tank contains a two-phase mixture of ammonia with 0.0028 ft3 of saturated…

A:

Q: A PFR is not meeting effluent requirements so baffles are going to be added to the tank to increase…

A: solution Given data The tank is 12 ft deep, 40 ft wide, and 120 ft long. current HRT is 0.5 d Ci= 9…

Q: Oil of specific gravity 0.70 and dynamic viscosity of 0.05Pa-s flows at a rate of 100lit/sec through…

A: Given:- Oil specific gravity, Go=0.70Dynamic viscosity, μ=0.05 Pa-sRate of flow, Q=100 lit/secLength…

Q: A pump pumps 0.200 ft /s of brine solution having a density of 1.15 g/cm from an open feed tank…

A: ρ = 1.15 x 1000 = 1150kg/m3 Q = 0.2ft3/s = 0.2 x (0.30483) m3/s = 0.00566 m3/s Ho (total head) = H…

Q: Obtain the diameter of the pipe outlet of a non-modular outlet

A: Discharge through the outlet (Q) = 0.02 m3/s Length of the outlet (L) = 15m FSL of the distributary…

Q: An open tank contains 5.70 m of water covered with 2.80 m of kerosene (y = 8.0 kN/m³). Find the…

A: Height of water in tank (h1) = 5.70 m Height  of Kerosene in tank (h2) = 2.80  m Specific weight of…

Q: A full scale agitation system that has a flat blade turbine impeller with six blade-disk is used in…

A: The volume of the scale down system is one-fourth of the large scale volume. The ratio of the volume…

Q: A reaction turbine works under 30m head of water. The atmospheric pressure at the location of…

A:

Q: As shown in the figure compute the amount and location of the vertical and horizontal components of…

A: Given data,radius is 7.5mL=10mFINDAmount and location of vertical and horizontal component

Q: The system in Fig 2 pumps water from a lower reservoir to a higher reservoir. The pipe diameter is…

A:

Q: (1)V =- (1) u = -2xyî i = y? - x2 w = 5k %3D K (アーー 2tr 2tr a-) Is the flow field given in (1)…

A: ū = -2xy î,   v= (y2 - x2 ) ĵ  ,  w = 5 k̂   For Fluid to be irrotational,  (∂u/∂x + ∂v/∂y) = 0…

Q: A groundwater borehole at USM engineering campus contains 3000 mg/L of TDS. The flow is 0.32 m3 /s.…

A: Discharge, Net pressure, Water flux rate coefficient,

Q: a ) show that : pr 21E (5- 40)v (cylindrical thin wall) b) Show that 3pr öv = P(1-v)v (spherical…

A: t=thickness E=modulus of elasticity P=internal pressure

Q: of particulate matter left in soluthon during a filtering pro p(n)=400(2)-0.4n, where nis then ps.…

A: This question is related to Filtration from Environment Engineering from Civil Engineering. In this…

Q: For flow in a pipe with Reynolds number of Re=10^7: a)The flow is laminar in some regions of the…

A: We know that:                                              Laminar        transition      Turbulent…

Q: Determine the reaction at B, C and E 10 k 20 k Rk 1/

A: Given : This is a problem of Structure analysis where we are asked to determine the reaction at B,…

Q: 1.1 AN SPECIFIC ACTING VERTICALLY OPEN WEIGHT ON IN THE CUBICAL 8 kN/m³ SIDE UPWARD TANK OF UP A AND…

A: Width of Open Cubical Tank, w=1.8m ,Height of Open Cubical Tank, h=1.8m Specific weight of oil, ρg…

Q: 8. Which one of the follflowing is correct? a) the frictional resistance is always dependent on the…

A: To Determine Which one of the 4 given options are correct.

Q: Fluidlis oil CEG= 0.87) ond fluid 2is gycerin at 20 °C (SG =1,26 If Pa = 98 kPa. Deter mine the %3D…

A: Po=98kPa

Q: 22) Calculate The head loss due to friction in The Piping system shown below. The pipe is (5o mm) in…

A: Given data  Discharge 0.13 m3/sec Length 150 m Diameter 0.15 m To find Head loss due to friction.…

Q: 7. An Undamped spring mass system is used at a high efficient mixer. The Srping in the system as a…

A:

Q: Flowrate of water through bend pipe (90°) is 0.21 m³/s. The pipe diameter at the inlet is 150 mm and…

A: Consider the free body diagram of water supply and Distribution system; Velocity…

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.