A cantilever beam of length L and a cross section with shape factor f supports a concentrated load P as shown below:

Q: downward load of Q = 33 kN is applied to rigid bar ABD as shown in the sketch.  Axial member CDE is…

A:

Q: Consider the truss shown in (Figure 1). Suppose that F= 14 kN. Figure 4 kN 6kN G 6kN C…

A:

Q: For the frame shown above is constructed out of circular tubes for both the beam and column.  It has…

A: Value of P can be calculated using the bending equation

Q: 1. Compute the stress (ksi) in each member of the Warren truss as shown in the figure. Indicate…

A:

Q: A welded plate girder is subjected to factored bending moment 9500 kNm, having span 25 m as shown in…

A: For a welded plate girder, factored bending moment: 9500 kNmspan length  25 mk = 180

Q: X is L/2 For the frame shown above is constructed out of circular tubes for both the beam and…

A:

Q: .T-profile cross-section overhanging beam is loaded as shown in the figure .a) Calculate the support…

A:

Q: A pin-jointed 2-D truss is loaded with a vertical load of 10 kN as shown in figure. The…

A: For Given arrangement,To find the horizontal displacement at C

Q: A cantilever beam has a span of 4m and carries a uniformly distributed load throughout its span.…

A:

Q: Joists support a floor and transfer their load to beams at each end of each joist. Joists are 2 ft…

A: Given:  Spacing between Joist=2 ft. Length of Joist=30ft. Uniformly distributed load=30 lb/ft2…

Q: A load of P = 50 kN acting at an angle of ß = 32° is supported by the struct dimensions of the…

A:

Q: A downward load of Q = 33 kN is applied to rigid bar ABD as shown in the sketch.  Axial member CDE…

A:

Q: The principal stresses are incorrect but the maximum shear stress is correct.  What are the two…

A: Compressive stress is the force that deforms the material in a way that reduces the volume of the…

Q: A load of P = 50 kN acting at an angle of ß = 32° is supported by the structure shown. The overall…

A:

Q: A truss tower is subjected to the following (unfactored) actions as shown in Figure 2. All supports…

A: GIVEN: Wind load (WL) =5kN Dead load  (DLL)=25kN Dead load (DLR)=25kN Imposed load (IL)=20kN Dead…

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.