A cantilever beam ABis fixed at its right end and extends L out of the edge of the pool. The board is of uniform cross-section and carries a person at its free end A. B -L- Figure 2

Q: Q1; Find the resultant of forces 5 kN F2 = 20 kN F3 = 15 kN 00

A:

Q: SOLVE the location of the Centroid from column ABC

A: Given data in question  Frame Point loads Span member lengths  Uniform columns   To find out…

Q: The truss pinned to the floor at D, and supported by a roller at point A is loaded as shown in the…

A:

Q: ne B. Determine the resultant reactions at A and B. 600 Ib 12' B A

A: To find the resultant reactions at A and B -

Q: using the truss shown below, compute the force experience by member AB, DF, BD and find the reaction…

A: support reaction: ∑MF=0RA×12-360×4=0RA=120 KN∑FY=0RA+RF=360120+RF=360RF=240 KN

Q: 5. The force in member BD A. - 48.54 KN B. - 43.51 KN C. - 38.38 KN D. - 56.89 KN 6. The force in…

A: ###Determination of forces in member BD,AD,CD ####

Q: Three structural member(AB,BC, and CA) of equal lengths L, areas A, and elastic moduli E,…

A:

Q: What is the Verticall Reaction at C in kips? add negative sign if answer is to the left/downwards

A: Note: As the student specifically asked about the vertical reaction at C only the solution of that…

Q: Q/ Determine the forces at the pin joint (F) and the roller support (G) ? 30KN 20KN 4 2m 32m D 2m E…

A:

Q: SOLVE ALSO THE ANGLE THAT A Find the reaction @ A ,B, C ,D E lo Phinge THE RESULAT AT E MAKES WITH…

A: Consider the span DE - Force in the vertical direction -  ∑FY = 0⇒RD + RE - 60×3 - 12×40×3 -…

Q: Determine the magnitude of force in member BD

A: Find the magnitude of force in member BD

Q: 155 kN 125 kN B D F 3 m H C E G 4 m 4 m 4 m 4 m A,

A:

Q: Determine the resultant moment of forces about the point O? Neglect the beam thickness *KN 15m #2kN…

A:

Q: the truss which is pin supported at A and roller supported at D is inclined at 40 degrees with the…

A: A structure is said to be in equilibrium when the: Sum of moments in the body is equal to zero. Sum…

Q: 100-lb.homogeneous plate is supported by a ball joint at A, a simple bearing at B, and a cable at C.…

A: Given:- W=100lb Vertical  force=120lb To find:- Force

Q: 20KN 3m RI R2

A: Apply equilibrium condition : ∑FX=0∑FY=0∑M=0

Q: 10 ft 20 ft A Z 10 ft y 30 k D 25 k B By 4 ft C Cy Cz €x By 5 ft 5 ft X

A: Reaction forces and members forces of a given truss are calculated using the given data: Given Data:…

Q: 6 A 72 C W 2 T 30⁰ D B 12 A beam AB of length 1 and weight w supports a load W at its free end B and…

A:

Q: 2 kN 5 kN 400 mm 700 mm 300 mm Draw the diagram of internal bending moment

A:

Q: For the simple truss in figure QI below, 9 KN 6 kN |3 kN 3 m 3 m 3 m 3 m 1 m 5 m Figure QI: Simple…

A:

Q: HW.: determine the forces in all cables H. mass positi 30 450 200 N 500 N

A:

Q: Frame ABCDE shown in Figure Q2 is supported by a fixed connection at B, roller at D and pinned at A.…

A: Solution:Solve using Moment distribution method:(a)Distribution Factor:JointMemberRelative…

Q: The rigid bar ABC shown is hinged at A and supported by a steel rod at B. E=200 x 10 N/m2 A-300mm?…

A:

Q: A 6 ft 500 lb/ft C 1500 lb ft What are the internal forces and moments for the beam at point C? 6 ft…

A: Beam loaded with UDL of 500 lb/ft over entire span of 12 ft and moment of 1500 lb-ft at center

Q: . Show complete solutions and appropriate free body diagram. The 600-kg uniform beam is subjected…

A: The free body diagram is given below,

Q: H.W Replace the loading equivalent resultant force and specify its location on the beam, measured…

A: Consider the given beam. The resultant force will be equal to the algebraic sum of all the forces.

Q: Determine the force in member CG for the truss using the method of joints. 133 kN 67 kN B F G -4 at…

A: Given Data  Find the force in member CG (FCG) using method of joint.

Q: F3-3. Determine the force in each member of the truss and state whether it is in tension or…

A: All data is given belowNeed to find find each member's force.

Q: D 2 ft -2 ft- -2 ft A 90 65 200 lb 100 lb 2. A beam AB is loaded as shown. The beam is pin-connected…

A: Determine the pin reaction at A and the tension in the rope.

Q: a R₁ B b c d e f gra R2₂ 9.60m

A: Given-A Pratt truss carrying a group of live loads at its bottom chord. Required -To calculate the…

Q: Determine (approximately) the force in each member of the truss. Assume the diagonals can support…

A: Consider the free body diagram of the truss;

Q: H.W2: Find the stability and determinacy of frame below ١٢ / ١٤ ... ...

A: Given Structure Internal hingeTo find out Indeterminacy NoteDs = total static Indeterminacy Dse=…

Q: Im 3m 3m SOLVE FOR ALL THE FOKES IN Im EACH MEMBER RADIUS OF PULEY = 0. Tm 2m 700 KN

A: When an object encounters another object, it experiences a force that pushes or pulls. When…

Q: Determine the member forces of the truss. INCLUDE NEGATIVE (-) SIGN IF FORCE IS IN COMRESSION.

A: Solution; Find Horizontal force; ∑Fx=0-HA+HB=15 KN∑MA=0 ⇒2H-25×4=0                  ⇒H=1002=50 KN…

Q: 5 @ 3m=15m- C H J K L -4 @4m=16m- A B D E 60 kips WHAT IS VERTICAL COMPONENT OF REACTION FORCE AT…

A:

Q: 20 sod 0.4 m 0.7 m 0.7m Force in Member AB in N. Round off to the nearest whole number.

A:

Q: Determine the force in each member of the truss below. Indicate whether each member is in tension or…

A: A truss is supported by rocker at A and pinned at B. A horizontal 100N force is applied at C. Degree…