(a) Calculate the tension (in N) in a vertical strand of spiderweb if a spider of mass 7.00 x 10-5 kg hangs motionless on it. (Enter a number.)N(b) Calculate the tension (in N) in a horizontal strand of spiderweb if the same spider sits motionless in the middle of it much like the tightrope walker5.0°T₂WTRT₁ +WTR-5.0°The strand sags at an angle of 15 below the horiz ntal. (Enter a number.)NCompare this with the tension in the vertical strand (find their ratio). (Enter a number.)(tension in horizontal strand)/(tension in vertical strand) =Xthe figure.

Answered: Image /qna-images/answer/a7c721e1-7c5b-472c-8186-ae43f441b769.jpg

(a) Calculate the tension (in N) in a vertical strand of spiderweb if a spider of mass 7.00 x 10-5 kg hangs motionless on it. (Enter a number.) (b) Calculate the tension (in N) in a horizontal strand of spiderweb if the same spider sits motionless in the middle of it much like the tightrope walker in the figure. 5.0⁰ T₁ TR T↓ TR -5.0° Q The strand sags at an angle of 15.0° below the horizontal. (Enter a number.) N Compare this with the tension in the vertical strand (find their ratio). (Enter a number.) (tension in horizontal strand)/(tension in vertical strand) = X

(a) Calculate the tension (in N) in a vertical strand of spiderweb if a spider of mass 7.00 x 10-5 kg hangs motionless on it. (Enter a number.) (b) Calculate the tension (in N) in a horizontal strand of spiderweb if the same spider sits motionless in the middle of it much like the tightrope walker in the figure. 5.0⁰ T₁ TR T↓ TR -5.0° Q The strand sags at an angle of 15.0° below the horizontal. (Enter a number.) N Compare this with the tension in the vertical strand (find their ratio). (Enter a number.) (tension in horizontal strand)/(tension in vertical strand) = X

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Help
PROBLEM 1: A body is being held by a single rope attached in between points A and B as shown in the figure; determine the required coefficient of friction, u, between the body and the rope. 45 70°
Determine the tensions in cables AB, BC, BD, and DE if the weight W = 176 N. You will need a free- body diagram at B and another at D to solve this problem. Round all answers to one decimal place. A TAB TBC TBD TDE 34% 36% B N Z Z N N 18 E 11 D
CM4: A 58 kg circus performer hangs from a bar suspended from a ceiling as shown in the figure. If the bar masses 12 kg (and its weight acts at its center) and has a length of 1.4 m, what is the tension T₂ in the rope? The rope is attached 0.85 m along the bar. تل T₂ 50°
In the following figure m_1 = 20.0 kg and angle = 51.4 degrees. The coefficient of kinetic friction between the block and the incline is μ_k = 0.40. a) What must be the mass (m_2) of the hanging block if it is to descend 13.5 m in the first 3.00 s after the system is released from rest?
A fish has been hooked and is pulling on the line as shown in the figure below. 25.0⁰ N.m 25.0⁰ 35.0⁰ T If the pole makes an angle of 25° with the horizontal, the distance between the point where the line is attached to the pole and the anglers hand is L = 2.00 m, and the fish pulls on the line such that the tension in the line is T = 130 N at an angle 35.0⁰ below the horizontal, determine the magnitude (in N m) of the torque exerted by the fish about an axis perpendicular to the page and passing through the angler's hand.
In the figure shown below, the 4 forces are being supported by an eyebolt. Determine the force F2 (in kN, roundoff to 2 decimal places) that would produce a net effect on the bolt of R direct pull along the horizontal. F1=2KN R=3KN F3=1.2kN a=30° F4=1.8KN B=30° F1 y -F2 F3 F4 α В Ꮎ
QUESTION 5 A 250 kg man climbe a 10 m, 40 kg ladder successfully to its top. The ladder is not at 60 degrees between the ladder and the flat ground. The contact between the ladder and the vertical wall is frictionless. What is the smallest value of statio friction between the ladder and the floor that would allow him NOT to slip? O0.50 Ob.0.55 Oc.0.60 Od.0.65 O0.70 QUESTION 6 A 2000 kg beam is attached to a wall at the beam's left end by a hinge to the wall. The beam is supported by a cable anchored in the wall and attached to the right ond of the 20 m beam. The cable is attached to the beam making a 40 degree angle between the horizontal beam and the cable. What must the tension in the cable be? Oa 8762 N Ob. 10540 N OC. 12793 N od 13647 N Oe. 15246 N
B1
P1a please help me with the answer and full solution
Q4) The Great Valerio is performing his high wire act. He stands on a (massless wire) exactly in the middle of two posts a distance d = 50.1 m apart. The wire buckles under his weight and he ends up h = 1.25 m below the vertical location where %3D the wire is attached to the posts. Valerio has a mass of my= = 73.5 kg. What is the tension of the wire ? h d/2 d/2 E
1O C A cart for hauling ore out of a gold mine has a mass of 439 kg , including its load. The cart runs along a straight stretch of B Track track that climbs a shallow 4.75° incline. A donkey, which is Rope trudging along and to the side of the track, has the unenviable job of pulling the cart up the slope with a 441 N force for a distance of 185 m by means of a rope that is parallel to the slope but makes an angle of 14.5° with the track. A „Track incline Model the rolling resistance of the cart as though it were Horizontal ground sliding on the track with a coefficient of friction of 0.0163. Use g = 9.81 m/s, and note that angle A in the image is the angle of the incline while angle B is the angle the rope makes %3D with the track. Find the work Wa that the donkey performs on the cart during this process. %3D Find the work W, that the force of gravity performs on the cart during this process. = "M Calculate the work W done on the cart by friction during this process. 87