a) Calculate the maximum tensile bending stress (Express the stress in Pa or MPa) and determine its location with respect to neutral axis. (b) How far is the maximum tensile bending stress located from support A? (Consider x=0  at support A ) (c) Calculate the maximum compressive bending stress (Express the stress in Pa or MPa) and determine its location with respect to neutral axis. Please do question yourself, I've already had this question solved twice but both came up with diffrent results.

Q: Q/Normal and shear stresses acting at the point is shown in Figure 1- Determine the principal…

A:

Q: eter of 40 mm. It is subjected to the force normal stress that acts at point A. answer to three…

A:

Q: Which of the following analytical formula you would use to solve for the minimum principal stress: O…

A:

Q: A steel beam, of lengths a= 4 m and b=4 m and a hollow box cross section, is supported by a hinge…

A: Given  a= 4 m  b= 4 m  q= 4.2 KN/ m

Q: Determine the a) magnitude load P to be applied, and b) the normal stress on plane AB and the…

A:

Q: For the sets of given stresses on an element given in Table below, draw a complete Mohr's circle,…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: A beam under load experiences sagging with a maximum bending moment of 24 x 106 Nm. The beam has a…

A: Calculate the maximum tensile stress and the maximum compressive stress for this beam.

Q: A 3 in. D 2 in. G in.

A:

Q: For a beam with the cross-section shown and loaded as shown, find the magnitude of the maximum…

A:

Q: Part A - Average normal strain along AC Determine the average normal strain (EAC)avg along AC after…

A:

Q: 4. What is Hooke's law? a) The relation between shear stress and the corresponding strain b) The…

A: What is hooke's law ? Hooke's law is defined within elastic limit.

Q: (A) he figure below shows three metal cubes A, B, C of side 100 mm in direct contact, resting on a…

A:

Q: 3 ksi S ksi iven the state of stress above (ignore 70° plane): calculate the maximum she ress,…

A: To find maximum shear and principal stress

Q: The two bars are made of polystyrene, which has the stress-strain diagram shown. If the…

A: Given : Cross sectional area of bar AB is = 975 mm2 Cross Sectional area of bar BC = 2600 mm2…

Q: A 200 MPa shear stress is applied on along CD. Calculate diagonal strain along AC. Given modulus of…

A:

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.