a) Calculate IR and Ic. b) Determine re. using h-parameter model. c) Determine Z, and Z.

Q: Design a microstrip line on a 0.5 mm alumina substrate (er = 9.9, tan o = 0.001) for a 50…

A:

Q: If a current I given by Imsin(wt-/2) flows across an AC circuit with potential e = Emsinwt, then…

A: Given, Current is  I = Imsin(wt-2) A Potential is e = Emsin(wt)

Q: 2. Explain why a hollow waveguide can't support a TEM mode of an electromagnetic wave? Given a…

A: We need to explain  why a hollow waveguide can't support a TEM mode of an electromagnetic wave. We…

Q: Q/Let aunidorm Surface chargedensity of 5nc/m? be present at Z=oplane, auniform line charge density…

A:

Q: Derive the Boolean function for the combinational network shown in Figure E6.1.4(a). B (a) B Figure…

A: Given Data;Required Data:Here, we need to find the boolean function of the given combinational…

Q: how sommerfield model overcomes the limitations of Drude and Lorentz, drude model

A: Both the theories i.e Somerfield theory and Drude and Lorentz model are based on the atom and its…

Q: For the circuit below with input voltage V1, a step function of magnitude 15 volts at time t=0, find…

A:

Q: P6.98 For abrupt silicon p-n juntion at 300K has acceptor atom Na=10^(18)cm^(-3) and donor density…

A: The conductivity of semiconductor is lies in between conductor and insulator. The conduction in…

Q: 5. Given Ipss - 6 mA and V, = -4.5 V: a. Determine Ip at Ves = -2 and-3.6 V. b. Determine Ves at Ip…

A:

Q: Discuss the key parameters to be considered in the design of a microwave link.

A:

Q: If we consider the resistor, capacitor and inductor as the load connected to the two voltage…

A:

Q: what are exambles of low linear energy transfer (LET) and high (LET) radiation?

A:

Q: During the first month of work, you get an assignment to perform a measurement campaign to estimate…

A: Average signal power decreases logarithmically with distance. Path loss measurements: PL (d1), PL…

Q: Discuss the concept of light propagation in optical fibers. What are the principles of total…

A: Light propagation in optical fibers involves the transmission of data via light signals through…

Q: A modulating signal m(t) is given by: (b) m(t)=sin(100) sin (500x) (i) Sketch the spectrum of m(t).…

A: Given:modulating signal, we need to do:i) sketch the spectrum of m(t). ii) Sketch the spectrum of…

Q: Calculate the Vp-p with a given 4div vertical deflection reading, 0.5volts/div and 10 probe…

A:

Q: When we can say to the beam of light coherent? What is the property of HE-NE laser? Define the beam…

A: 1. Two beams of light are said to be coherent when the phase difference between their waves is…

Q: An isotropic radiator is: O A device that stores electromagnetic signals in the form of heat. An…

A: We need to select correct option for given statement

Q: Explain the Beam radiation and diffusive radiation with necessary diagram.

A: Beam radiation: Direct radiation is another name for beam radiation. The rays in this radiation fly…

Q: Discuss the theoretical principles governing the propagation of electromagnetic waves in different…

A: The propagation of electromagnetic waves in different media is explained through several key…

Q: a. Find the frequency of 3 cm wavelength EM radiation. What band o phenomenon does this radiation…

A: According to the question we have to find the value of frequency.

Q: A 10kHz sinusoidal is used to frequency modulate a 120kHz carrier signal; peak frequency deviation…

A:

Q: olve quickly Antenna and Wave Propagation Detemine basic antenna parameters with examples.

A: An Antenna is a type of transducer that converts the AC (Alternating current) into an RF (radio…

Q: A sinusoidal message signal has a frequency of 250 Hz. This signal is the input to an FM modulator…

A:

Q: 3. What are the losses in a laser cavity? Explain the meaning and significance of the term threshold…

A:

Q: A shunt generator supplies a 23kW load at 220V through cables of resistance, R = 114mQ. If the field…

A: The solution can be achieved as follows.

Q: (a) A signal at 900 MHz is mixed with a local oscillator signal at 1.0 GHz. What is the frequency of…

A: Given: To find the frequency of the VHF output signal and unwanted output signal.

Q: c) What is the most important parameter that needs to be very accurate during optical fibre…

A: According to the question, we need to discuss about the most important parameter that needs to be…

Q: s an assignment for antenna course work, you are asked to design a mobile phone antenna which is…

A: We need to tell about Design issues for mobile antenna .

Q: An optical fiber has a core radius 2µm and a numerical aperture of 0.1. Will this fiber operate at…

A: The given question is as follows:-

Q: An FM modulator has a carrier frequency of 100 MHz, is frequency modulated by a sine wave signal at…

A: Since you have posted a question with multiple subparts we will provide the solution only to the…

Q: When we talk about electromagnetic energy, what parameter is used to describe it if it represents…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: first order system,

A: Laplace transform of- ut=1se-atut=1s+a

Q: Explain what miller theorem is confused? What is millers capacitance?

A: Miller theorem : ? Miller capacitance :?

Q: Derive the Boolean function for the combinational network shown in Figure E6.1.4(a).

A: It is given that:

Q: 4. Determine the unmodulated carrier power for the FM modulator given that ß =1, Vc=10 V, R = 50 Q.…

A:

Q: Discuss “additive white Gaussian noise” in the conventional way and convince your audience that…

A:

Q: Qs: An ordinary end-fire array of 10 isotropic elements with the spacing between the elements is…

A: (a) Progressive Phase Excitation: In an end-fire array, progressive phase excitation means that each…

Q: 1a.) What electric and magnetic fields correspond to the TM modes of a 1D ideal metallic waveguide?…

A: Transverse mode is a mode of operation in an electromagnetic field perpendicular to radiation wave…