A bucket hangs off the end of a rod rigidly attached to a pulley. A spring acts as a counterbalance. The spring has a spring constant of 250 N/m. The bucket has a mass of 2 kg. When the angle a is 0°, the spring is unstretched. What is the volume of water (in liters) that must be put in the bucket in order to for the rod AB to be horizontal? What are the reactions at pin A in that case? Note that the density of water is 1000 kg/m³. .75 m ZZZZ A a .3 mA

A bucket hangs off the end of a rod rigidly attached to a pulley. A spring acts as a counterbalance. The spring has a spring constant of 250 N/m. The bucket has a mass of 2 kg. When the angle a is 0°, the spring is unstretched. What is the volume of water (in liters) that must be put in the bucket in order to for the rod AB to be horizontal? What are the reactions at pin A in that case? Note that the density of water is 1000 kg/m³. .75 m ZZZZ A a .3 mA

Name: A bucket hangs off the end of a rod rigidly attached to a pulley. A s
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: A bucket hangs off the end of a rod rigidly attached to a pulley. A spring acts as a counterbalance. Thespring has a spring constant of 250 N/m. The bucket has a mass of 2 kg. When the angle a is 0°, the springis unstretched. What is the volume of w

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The spring clamp of Fig. block Fagainst the floor. The force in the spring is F = k(e – lo), where e is the present length of the spring, lo = 3 in. is the unstretched length of the spring, and k = 240 lb/ft is the spring constant. Determine all forces acting on mem- ber ÁBC of the spring clamp and the force exerted by the spring clamp on the block E. is used to hold the 8 in. D E 8 in. 6 in -6 in.- 6 in.
A barge floating in fresh water (ρ = 1000 kg/m3) is shaped like a hollow rectangular prism with base area A = 650 m2 and height H = 2.0 m. When empty the bottom of the barge is located H0 = 0.55 m below the surface of the water. When fully loaded with coal the bottom of the barge is located H1 = 1.8 m below the surface. Find the mass of the coal in terms of the given data.
Problem 2.93 - Enhanced - with Hints and Feedback The bent plate is 1.8 m wide and is pinned at A and rests on a smooth support at B. The fluid is water. p = 1000 kg/m³. (Figure 1) Figure 1 m 4 m X A -2 m -3 m B < 1 of 1 Part A Determine the y reaction at the smooth support B for equilibrium. Express your answer to three significant figures and include the appropriate units. ► View Available Hint(s) By = 155 Submit Part B 0 A₂ = Submit Part C HA X Incorrect; Try Again; 5 attempts remaining _O Previous Answers Determine the component of reaction at A. Express your answer to three significant figures and include the appropriate units. ► View Available Hint(s) 3 μA KN Value Ċ ? Units P ?
A 0.2 m wide (out of plane) gate in a sea wall is hinged at A and bolted at B. Given the density of sea water is 1,019 kg/m³ and the depth of water hA= 2.6 m, determine the magnitude of the reactions at A and B that act normal to the gate. RA- Ba Number Number Units Units A * 1.0 mi * B 0.6 m (magnitude only; tolerance 5 N) (magnitude only; tolerance 5 N)
Consider the two boxes suspended from a combination of ropes in the figure to the right. (a) If the mass of box B is mB=3.80 kg, calculate the tension in each rope T1, T2, and T3. (b) What is the mass of box A, mĄ?
Question 3) The position of the head and neck and the forces acting on the head are shown in the figure. the center of gravity of the head with a mass of m-9 kg is located at point C. Neck extensor muscles November 21, 2016 by making a y=55° angle with the vertical from point B to the skull, the neck muscle force with a intensity of FmNovember85N is affected. The center of the atlantooccipital joint is located at point B takes. For this flexion position of the head, F, which makes an angle a with the bed from point A, is influenced by the joint response force. (g take the gravitational acceleration as 9.81 m/s2.) According to this; a) Calculate the angle a where the Fjeklem reaction force is built with the horizontal. b) Calculate the Fjeklem reaction force. (Write your result in unit N.) W FM
Determine the reaction forces at the support A and the tension force T in the cable needed to support the 225 kg mass as shown in the figure below. Neglect the weight of the arm AB. 2.5 m |350 225 kg
at the bottom of a container, which forms an angle A with the horizontal, is a cube of edge a, as shown in the figure, made of a material of density p. Determine the force with which the cube presses on the bottom, if a liquid of density p0 is poured into the container. The top edge of the cube is h from the surface of the liquid. There is no liquid between the bottom of the container and the cube. The atmospheric pressure is P and the acceleration of gravity g (neglect the thrust).