A boy is playing on a playground ride as shown below. The bo is holding onto a rope as the platform of the ride spins about the vertical axis at the constant angular speed of 8 = 2 rad/s. Neglecting friction, determine the tension in the rope. 1.0 m 60 kg 135°

A boy is playing on a playground ride as shown below. The bo is holding onto a rope as the platform of the ride spins about the vertical axis at the constant angular speed of 8 = 2 rad/s. Neglecting friction, determine the tension in the rope. 1.0 m 60 kg 135°

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The air around the spinning baseball in the following figure (top view) experiences a faster speed…

A: Given data:- The given time taken to travel, 18.44 m The given traveling speed in x direction, 40…

Q: A stone weighing 45 N to one end of a cord 0.90 m long. The stone is then whirled in a vertical…

A: Consider the given data Weight of the stone=45 Nlength of the cord=0.90mBreaking strength of the…

Q: 6.122. A railway engine weighing 60 tonnes is moving with a speed of 10 m/sec on a circular track…

Q: 1. If the center of gravity of a ship in the upright position is 10 m above the center of gravity of…

Q: During a steady right turn, a person exerts the forces shown on the steering wheel. component and a…

A: To find moment about point O

Q: One of the three landing pads for a proposed Mars lander is shown in the figure. As part of a design…

Q: 2 kip 200 lb/ft A 6 ft - - 9 ft 9 ft - Sketch the bending moment diagram with relevant values on the…

Q: Given the beam shown in the figure below. 1. Write equations for the shearing force and bending…

A: GIVEN BEAM:-

Q: all button placed on a horizontal rotating p latform when the platform is brought up to ore than…

Q: During a steady right turn, a person exerts the forces shown on the steering wheel. Note that each…

Q: A truck weighing 50kN is not moving on a hill which is inclined at 22 degrees to the horizontal.…

A: Component of weight at right angle to surface of hill and parallel to it

Q: Consider the portal frame shown in the figure and assume the modulus of

Q: Example: Calculate the moment of the 250 N force on the handle of the monkey wrench about the center…

Q: Replace the forces and couple moment system acting on the structure shown in the figure below by an…

Q: Please answer

Q: The 50kg pendulum has a center of mass at G and a radius of gyration about G of kG=250mm. A)…

A: It is given that :

Q: 50 N 60 N 120 N 45 75 100 N 110 N 4.1 The diagram shows a number of forces in the same vertical…

A: Given that

Q: A cantilever beam is subjected to load as in the figure below. Based on the diagram, sketch a…

A: Given:Required:Shear force and bending moment diagram

Q: c) The engine inside the tractor as shown in Figure 4 is no longer working. You then attached a…

A: Velocity(v)=4 m/sec, Distance(s)=5 m, Kinetic friction=0.3, Tractor weight=50 kg.

Q: A boy is playing on a playground ride as shown below. The boy is holding onto a rope as the platform…

A: normal force : The normal force is a contact force. On two surfaces that are not in contact, a…

Q: Dynamics Lab is A 7.75-kg uniform disk developed in the attached to the 4.85-kg slender rod AB by…

A: Given:- Mass of disk, mD=7.75 kgMass of slender rod, mR=4.85 kgAngular velocity, =6.00 rad/sAngular…

Q: A 1-lb collar is attached to a spring and slides without friction along a circular rod in a vertical…

A: mass of collar (m) = 1 lbSpring constant (K) = 12 Undeformed length of the spring

Q: 03/ curved path described by r= (20) ft. At the instant e = 7/4 rad, the angular velocity and…

Q: A truck used to demolish a building obstructing the construction of a bridge. This truck contains a…

Q: A disk with 10 cm radius rolls without slipping down a 30°- inclined plane. At the instant shown,…

Q: Using the figure below solve the following 1.00m В 10KN 25KN 30° 15KN E 60 D 45° 8kN Determine the…

Q: The mass A starts from rest att = 0 and falls with a constant acceleration of 10.1 m/s?. When the…

A: Given, a = 10.1 m/s2 s = 0.83 m r = 147 mm

Q: Draw the shear force and bending moment diagram and label the values of the largest positive and…

Q: 3. The bob of 4-m pendulum describes an arc of circle in a horizontal plane. If the tension in the…

Q: Problem: Analyze the continuous beam shown in Figure by drawing the shear and bending moment diagram…

Q: In a stage production of Peter Pan, the 61 kg actress playing Peter has to fly in vertically, and to…

Q: Determine the reaction at the roller support. Determine the moment reaction at the fixed support.…

Q: Replace the forces and couple moment system acting on the structure shown in the figure below by an…

A: Given: As shown in diagram:point load=25kNMoment=10kNmUDL=10kN/mCalculate the…

Q: Consider the portal frame shown in the figure and assume the modulus of elasticity, E = 2.5 x 104…

Q: 150 mm M- 150 mm 60° 30° 320 N 160 mm 400 N

A: Couple force is the measuring value of the response to such a load or displacement from a template…

Q: A box of mass 5 kg is pulled vertically upward by a force of 68 N applied to a rope attached to the…

Q: 180 km/h h 10° Figure 4

Q: Draw the shear and bending moment curves for the beam and loading and the maximum absolute value of…

Q: Given the 180 mm x 360 mm rectangular beam as shown in the figure. 100 kN/m 20 kN-m 50 kN/m 360 mm…

Question

A boy is playing on a playground ride as shown below. The boy
is holding onto a rope as the platform of the ride spins about
the vertical axis at the constant angular speed of
8 = 2 rad/s. Neglecting friction, determine the tension in
the rope.
1.0 m
135°
60 kg

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A structure is subjected to forces as shown in the figure below. Assuming that the EI of the entire beam section is constant, use the Moment Distribution method to analyze the beam and draw the shear force of the beam Diagram (Shear Curve) and bending moment diagram (Moment Curve).
1. Determine the angle θ that the cord forms with pole BC in degrees. 2. Calculate the tension in the cord in N.
1
In the figure below (1st photo), find the force in member HD. (In the second photo is the clearer view of the values below)
Consider the portal frame shown in the figure and assume the modulus of elasticity, E = 3.5 x 104 MPa and the moment of inertia, I = 9 × 108 mm4 for all the members of the frame. A 2m 1650 kN/m ot - 2000 KN P E,I Q E,I R E,I S 4m 4m The rotation (in degrees, up to one decimal place) at the rigid joint Q would be
Paragraf Stiller 2.13: 4 6. 10 11 13.114 15. In Figure 2, the wheel with mass p (kg) with an inertial radius of kA (mrn), M=X.t (N.m) it has been subjected to moment (t seconds). Starting from a stationary state calculate the angular speed of the wheel after t1 seconds. Also, the reaction force that the fixed bearing a exerts on the wheel during movement calculate. (Gravity acceleration will be taken as 9.81 m/s2.) kA= 252 mm p= 13 kg x= 3 t1=2 M DOdak
Please solve this following figure and make sure to illustrate your answer into step-by step procedure,.