A board of mass M = 2.00 kg and thickness t = 0.200 m is placed on top of a cylinder of mass m = 1.00 kg and radius r = 0.100 m on level ground. The board is accelerated to the right with a constant acceleration a0 = 1.00 m/s^2, causing the cylinder below it to roll as well. Assume that there is no slipping between any of the two contact surfaces. What is the magnitude of the acceleration of the center of mass of the cylinder?

A board of mass M = 2.00 kg and thickness t = 0.200 m is placed on top of a cylinder of mass m = 1.00 kg and radius r = 0.100 m on level ground. The board is accelerated to the right with a constant acceleration a0 = 1.00 m/s^2, causing the cylinder below it to roll as well. Assume that there is no slipping between any of the two contact surfaces. What is the magnitude of the acceleration of the center of mass of the cylinder?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A hoop of mass 3.00 kg and radius 1.00 m is moving at 3π rad/s across a horizontal surface. The coefficient of friction between the hoop and the surface is 0.65. Calculate how far the hoop will travel before it comes to rest.
A sufficiently long platform of mass m rests on frictionless ground. A cylinder of mass m and radius R = 2 (m) rotating around its center of mass at an angular velocity w = 50 (rad/s) is slowly dropped onto the platform at t =0. The coefficient of friction between the cylinder and the platform is u = 0.2. After how many seconds does the cylinder start to roll without slipping? Iem =;mR?, g = 10 (m/s²) m R m
In the figure, two blocks, of mass m1 = 257 g and m2 = 337 g, are connected by a massless cord that is wrapped around a uniform disk of mass M = 492 g and radius R = 10.1 cm. The disk can rotate without friction about a fixed horizontal axis through its center; the cord cannot slip on the disk. The system is released from rest. Find (a) the magnitude of the acceleration of the blocks, (b) the tension T1 in the cord at the left and (c) the tension T2 in the cord at the right. M R T2 (a) Number i 0.095238 Units m/s^2 (b) Number Units (c) Number i Units
A girl of mass 20.3 kg stands on the rim of a frictionless merry-go-round of radius 1.29 m and rotational inertia 455 kg-m2 that is not moving. She throws a rock of mass 584 g horizontally in a direction that is tangent to the outer edge of the merry-go-round. The speed of the rock, relative to the ground, is 5.22 m/s. Afterward, what are (a) the angular speed of the merry-go-round and (b) the linear speed of the girl? (a) Number i Units (b) Number i Units
0.1/1E: In the figure, two blocks, of mass m1 = 257 g and m2 = 337 g, are connected by a massless cord that-is wrapped around a uniform disk of mass M = 492 g and radius R = 10.1 cm. The disk can rotate without friction about a fixed horizontal axis through its center; the cord cannot slip on the disk. The system is released from rest. Find (a) the magnitude of the acceleration of the blocks, (b) the tension T in the cord at the left and (c) the tension T2 in the cord at the right. %3D %3! R. (a) Number i Units m/s^2 (b) Number i Units (c) Number Units eTextbook and Media 898 MAY 1 PDF 8 tv .. DD 80 000 000 888 F9 F10 F11 F6 F7 FB F2 F3 F4 F5 @ 23 2$ & 2 3 4 7 8 9
A can full of soda (total mass is about 375 g, where 355 g comes from the liquid and 20 g from the aluminum can, radius is about 33 mm) is released on a slope. The slope has an angle of 30° of inclination and a length of 40 cm. Due to friction, the can roll over the slope without slipping. Determine the time it takes for the can to reach the bottom of the slope.Repeat the calculation for the empty can (m = 20 g and R = 33 mm). Note: In both cases, ignore the contribution from the top and bottom metallicparts of the can (disks) to the moment of inertia.
The uniform disk of mass m is rotating with an angular velocity of v0 when it is placed on the floor. Determine the initial angular acceleration of the disk and the acceleration of its mass center. The coefficient of kinetic friction between the disk and the floor is μk.
A 1.5 kg mass is sitting on a horizontal disk being rotated. The mass is not moving relative to the disk. The mass has a tangential velocity of 3 m/s and is sitting 0.5 m from the center of the disk. This is the fastest the disk can rotate without the mass slipping. Find the coefficient of static friction between the mass and the disk.
A solid sphere is released from the top of a ramp that is at a height h, = 1.85 m. It rolls down the ramp without slipping. The bottom of the ramp is at a height of h, = 1.48 m above the floor. The edge of the ramp is a short horizontal section from which the ball leaves to land on the floor. The diameter of the ball is 0.12 m. h2 (a) Through what horizontal distance d, in meters, does the ball travel before landing? (b) How many revolutions does the ball make during its fall? rev
A uniform disk of mass M is rotating freely about its center. On its rim lie a cockroach of mass M/9. Initially the cockroach and disk rotate together with an angular velocity of 3.2 rad/s. Then the cockroach walks halfway to the center of the disk. What is the new angular velocity of the system?
A point mass of O.4 kg is set to rotate about a fixed axis 0.7 m away. The mass is initially at rest and undergoes a constant angular acceleration of 9.3 rad/s². What is the magnitude of the total acceleration after 0.2 revolutions?
In the figure, two blocks, of mass m₁ = 289 g and m₂ = 362 g, are connected by a massless cord that is wrapped around a uniform disk of mass M = 533 g and radius R = 11.3 cm. The disk can rotate without friction about a fixed horizontal axis through its center; the cord cannot slip on the disk. The system is released from rest. Find (a) the magnitude of the acceleration of the blocks, (b) the tension T₁ in the cord at the left and (c) the tension T₂ in the cord at the right. M (a) Number i (b) Number (c) Number i Units Units Units 081 R Ng