A biomechanical model of the bones and biceps muscles of a person's arm supporting a mass m=2 kg is shown below. The weight of the forearm is 9 N. If the cross section of the tendon AB is 28 mm' what is the average normal stress in the tendon? ufi 290 mm 50 mm 9N 200 mm 150 mm

Q: 1. A steel rod (initial diameter: 3.2 mm, initial length: 42 mm) is extended by a uniaxial tensile…

A: Given: Steel rod diameter, D= 3.2 mm Tensile load, F = 4800 N'

Q: Common sports injuries result in the tearing of tendons and ligaments due to overstretching. If the…

A:

Q: A 557-N force is applied to stretch a cable, 66-m long and has a cross-sectional area of 2.8 mm^2.…

A: Given that-Force, F=557 NLength, L=66marea, A=2.8 mm2Y=1×1011  N/m2We know that,Hook's law :…

Q: A steel cube of side length L = 0.5 m is subjected to a shearing force of 5000N along the top…

A:

Q: Determine the Young's modulus of a 1.50 x 10^-1 m long tendon if it is stretched by 3.70 x10^-3 m by…

A:

Q: The cross-sectional dimensions of the beam shown in the figure are a = 5.0 in., b = 5.5 in., d = 4.6…

A: Concept: To determine the Maximum Tension and Compression Bending Stress we will divide the Cross…

Q: A 557-N force is applied to stretch a cable, 66-m long and has a cross-sectional area of 2.8 mm^2.…

A: The force applied in the cable is given as, F=557 N, The original length of the cable is given as,…

Q: Don't skip please

A: Given that-Density of aluminium wire, ρ=2.7g/cm3Stress at upper end, σt= 8×107 N/m2We know…

Q: Young's modulus for copper is thousands of times greater than that of rubber. Two meter-sticks have…

A: Young's modulus for copper is greater than that of rubber.  Ycopper > Yrubber   The…

Q: An aluminium (p = 2.7g/cm³) wire is suspended from the ceiling and hangs vertically. How long must…

A: Given : For aluminium, ρ = 2.7 g/cm3  Since, 1 g = 10-3 kg       &        1 cm = 10-2 m ⇒ ρ =…

Q: A femur bone of length 30 cm and diameter 2.5 cm is subjected to a compressive tress of 1.5 *10…

A: Given: Stress σ=1.5×108N/m2Young's modulus (Y)=1.5×1010N/mLength L=30cmDiameter d=2.5cm

Q: ) A 54 kg diver is at the end of a diving board. That is 3.8 m long and has a mass of 26 kg. What is…

A:

Q: The figure shows the stress-strain curve for a material. The scale of the stress axis is set by s =…

A: To calculate the Young's modulus and the approximate yield strength for the material. Given data-…

Q: The screwgate carabiner is left open as it is loaded by a rope as shown. Calculate the stress state…

A: Stress is defined as force per unit area.  σ=FA Where F is a force and A is cross-section area.

Q: The mass of the uniform bar AB is100 gram. Calculate the couple C required for equilibrium if the…

A: Draw the free body diagram of the bar AB.

Q: 0.02 1 1.4 0.5 0.04 2 2.8 1 0.06 3 4.2 1.5 0.08 4 5.6 2 0.1 5 7 2.5

A: Solution:

Q: A mass of 35.0 kg is suspended from a steel wire of diameter 1.00 mm and length 11.3 m. How much…

A: Given that,Mass : m = 35 (kg)Diameter of wire : d = 1 (mm)   Length of the wire : L = 11.3 (m)The…

Q: The figure shows the stress-strain curve for a material. The scale of the stress axis is set by s =…

A: Given, stress s=290×106 N/m2s=2.90×102×106 N/m2s=2.90×108 N/m2 strain ε=0.0040

Q: 10) A femur bone of length 30 cm and diameter 2.5 cm is subjected to a compressive tress of 1.5 *10…

A:

Q: EXample 2: the ankle joint therefore pushes upward on the bottom of the tibia with the force of 2800…

A: Given : R1=1.3 cmR2=2.5 cm

Q: The figure shows the stress-strain curve for a material. The scale of the stress axis is set by s=…

A: The stress-strain curve is shown below.

Q: A steel cable 1.70 m in length and with cross-sectional radius 0.380 mm is used to suspend from the…

A: Length of cable (L) = 1.70 m cross sectional radisu (r) = 0.38 mm mass (m) = 20 kg angular speed =…

Q: The figure shows the stress-strain curve for a material. The scale of the stress axis is set by…

A: Given :  scale of the stress axis is set  as s=320 in a unit of 106N/m2 ε=0.0090

Q: The figure shows the stress-strain curve for a material. The scale of the stress axis is set by s =…

A:

Q: A wall climber of mass 85 kg dangles at the end of a rope. The rope has a diameter of 9.6 mm, and is…

A: mass= 85 Kg Length, L= 21 m radius, r= 4.8 mm ∆L= 3.2 cm

Q: (25) A biomechanical model of the bones and biceps muscles of a person's arm supporting a mass m=2…

A: Given: The mass of the supporting block is m = 2 kg The area of the cross-section of the tendon is A…

Q: Two bands of different composition were found in a room. Th have the same thickness and length, but…

A:

Q: A 10.2 m long wire with a cross-sectional area of 0.126 cm2 stretches by 0.196 cm when a tensile…

A: The given values are, L=10.2 mA=0.126 cm2=0.126×10-4 m2∆L=0.196 cm=0.196×10-2 mF=6250 N

Q: A wire has 20 x 10^10 N/msquared young modulus. Its diameter is 1mm that can handle a tension of 0.2…

A: Given data- young modulus= 20×1010 N/m2 1mm diameter can handle a tension of 0.2 kN.

Q: Assume Young's modulus of a femure bone of an effective diameter 2.5 cm is 1.5 x1010 N/m2. The bone…

A: Given: A femur bone of an effective diameter 2.5 cm and it's Young's modulus = 1.5 × 1010 N/m2.…

Q: The figure shows the stress-strain curve for a material. The scale of the stress axis is set by s =…

A:

Q: An aluminum wire 1.50 m long has a diameter of 0.750 mm.  If a force of 60.0 N is suspended from the…

A:

Q: After a fall, a 86 kg rock climber finds himself dangling from the end of a rope that had been 16 m…

A:

Q: After a fall, a 80 kg rock climber finds himself dangling from the end of a rope that had been 14m…

A:

Q: An Aluminum cable of length 3.5 m has 15,000 N tensile force acting on it, if the wire is only…

A: Given, The length of the alumunium cable, L=3.5 m The tensile force acting, F=15000 N Length by…

Q: 14) An object put on a table with four legs. Both the table and the object together have the same…

A: Since we only answer up to 1 question, we’ll answer the first question. Please resubmit the…

Q: A vertical steel girder with a crosssectional area of 0.15 m2 has a 1550 kg sign hanging from its…

A: Given: Area of cross section A of the steel girder is 0.15 m2. Mass M hanging at the end is of 1550…

Q: To stretch a relaxed biceps muscle 2.5 cm requires a force of 25 N. Find the Young's modulus for the…

A: We must ascertain the muscular tissue's Young's modulus. We are aware that the biceps muscle can be…

Q: Humans can bite with a force of approximately 792 N. If a human tooth has the Young's modulus of…

A: Force exerted (F) = 792 N Cross sectional area (A) = 1.3 cm2= 0.00013 m2Length of bone (L) = 1.7cm =…

Q: Two solid cylindrical rods AB and BC are welded together at B and loaded as shown. Both rods AB and…

A: Given that: Diameter: D= 50 mm