A beam of which points C, E and G are (Roller), and point B is (Hinge), Points B and F are (Pin), and the beam is affected by two forces: 1.2 kips/ft (Live Load) and 2 kips/ft (Dead Load). Find the lines of influence that support the reaction forces at points B, C, E, and G. Tip: The distribution position of the live load can be appropriately selected, and the static load is the self-weight of the structure itself, so the whole beam is evenly distributed

A beam of which points C, E and G are (Roller), and point B is (Hinge), Points B and F are (Pin), and the beam is affected by two forces: 1.2 kips/ft (Live Load) and 2 kips/ft (Dead Load). Find the lines of influence that support the reaction forces at points B, C, E, and G. Tip: The distribution position of the live load can be appropriately selected, and the static load is the self-weight of the structure itself, so the whole beam is evenly distributed

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

What's the solution
How about numbers 21,22,23,24,and 28?
9. The beam loaded as shown is supported by a hinge at A and a roller at B. Find the reactions in the supports. 800 N/m -2 m -3 m 200 N/m
Illustrate the Influence Line and calculate the maximum negative live shear at point C in kN subjected to 7 kN/m uniform live load, 90 kN live load and beam mass of 18 kg/m. Set L= 4 m, support A is pin and support B is roller. |A B L 3 m -1.5 m→
Please answer a to e.
The Beam AB has a length of 10 m. The concentrated load acts at the midspan. Using equations of static equilibrium, determine the Moment at Point A.
pls answer problem 2 and 3 only
Asap thank you.a. Ordinate of the influence line of RC at point Db. Ordinate of the influence line of RE at point Bc. Ordinate of the influence line of MD at point F.
The beam sown in Figure 1 is subjected to uniform live load of 3.2 kN/m and a dead load of 2.5 kN/m and a single live load of 80 kN. Determine: a. The influence line for moment at E. b. The influence line for shear at E. c. The maximum positive moment created by these loads at E. d. The maximum positive shear at E. Assume A and C are roller, B is a short link, D is a pin. |B E 4 m + 4m 3 m 3 m Figure 1