A beam of light in air hits a stack of three slides with thicknesses of 2d, d and d and refractive indexes of 2n, n and n, respectively at an incident angle of 60° as seen in the figure. 60 no 2d 2n n. What is the angle 0 when the light exits the stack? O 60° O 120° O None of these О 300 O 90°

Q: 2. Determine the appropriate value of frequency for a square wave generator (in Hz) to measure the…

A:

Q: cal angle Ior total internal renection in a certain sub- stance is exactly 45 degrees. What is the…

A:

Q: QUESTION 3 The frequency spectrum of a square wave is shown below. A=3.15 kHz, D= 2.65 V, E-12.07 V.…

A:

Q: True or Flase Photonics is the base for the field of optics.

A: Before we can answer the question, we need to understand what photonics and optics are. Photonics is…

Q: A particle on a ring has the following wave function: Y=1/(2n) e-7i¢ What is the smallest value of…

A: SOLUTION  GIVEN               Ψ = 1/(2π)1/2  e-7iΦ         Calculate…

Q: The wavelength of possible stationary wave for an integer in a cubic system of size L is Oj= // 4nj…

A: Given data, Size is given L Let number of integer is nj

Q: 75-ohm transmission line of 2m length is connected to a half-wave dipole antenna at the transmitting…

A: Transmission Line:

Q: How does the refractive index differ with applied electromagnetic radiation?

A: REFRACTIVE INDEX; The refractive index shows how much the path of light got bent or refracted when…

Q: 1. Determine the appropriate value of frequency for a square wave generator (in Hz) to measure the…

A: In this question,  We need to determine the frequency of the Series RC circuit to measure the time…

Q: 1. Calculate the wavelength of a signal, if the speed of wave equals to 700 m/s and 111 000 000…

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.