A beam is simply supported at A, B, C and D. AB=CD=8 m, BC=12 m. Pins are inserted in span BC, 3 m from B and C respectively. AB has a uniformly distributed load of 4kN/m, and CD a uniformly distributed load of 6 kN/m, with a point load of 10 kN applied at the center of span BC. Determine the reaction at A. 275 a. c. 37 7 55 b. d. 3 Determine the reaction at D. a. 53 b. 355 7 C. d. 113 8 177 8 215 3

A beam is simply supported at A, B, C and D. AB=CD=8 m, BC=12 m. Pins are inserted in span BC, 3 m from B and C respectively. AB has a uniformly distributed load of 4kN/m, and CD a uniformly distributed load of 6 kN/m, with a point load of 10 kN applied at the center of span BC. Determine the reaction at A. 275 a. c. 37 7 55 b. d. 3 Determine the reaction at D. a. 53 b. 355 7 C. d. 113 8 177 8 215 3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the forces in all bars of the truss. Indicate tension/compression. Any methods will do
Thery of Structure (Space Truss)PLEASE SHOW COMPLETE SOLUTION AND FBD.100 % GUARANTEE THUMBS UP!GOD BLESS!
answer Reaction at F and N only
Consider the 21-member truss shown; determine the zero-force members and force in each member then state if they are in tension or compression.(Support on point B and C are pinned and roller, respectively)
Determine the forces in members CD, CJ, and DJ.
I need a clear answer by hand, not by keyboard | dybala
Please answer. Thank you!
Determine (approximately) the force in each member of the truss. Assume the diagonals can support either a tensile or compressive force.
A truss is a structure composed of slender members that are connected at their ends. Planar trusses lie in a single plane and are often used to support roofs and bridges. In designing a truss's members and connections, three assumptions are made: All loadings are applied at the joints. The members are connected by smooth pins. All members in a truss are straight. Each member acts as a two-force member and the forces at the ends of the member must be directed along the member's axis. Because trusses consist of two-force members, each member is either in tension (being pulled apart) or in compression (being pushed together). Part A Which of the following are planar trusses?
I. Determine the force in each member of the truss shown by the method of joints. E 20 k 12 ft D C 12 ft 5 k B A |-5 ft-5 ft- ft- -14 ft