A beam fixed at both the ends is subjected to a uniformly distributed load w' on its right half portion as shown in figure. At collapse, formation of three plastic hinges takes place. Two of the three plastic hinges are formed at A and C respectively. The distance of third plastic hinge from end C is L (round off to three decimal places). اث Location of plastic, hinge formation L B W Location of plastic hinge formation

Q: Using Method of consistent deformation, solve for: 1. Vertical reaction at B 2. Vertical reaction at…

A:

Q: Rigid bar BC is supported by aluminum rod (1) and bronze rod (2), as shown in the figure.  Aluminum…

A: Given data in question  Aluminum permissible stress Beonze permissible stress Distance  Area…

Q: A structural steel beam 8.00 m long is placed between two rigid supports when the temperature is…

A: Given Data: The length of a structural beam is, L=8.00 m The initial temperature of the steel beam…

Q: 2. Determine the shearing stress in each of the four walls of a portion of a structural aluminum…

A: Given, Torque =3 kN-m=26.55 kip-in Dimension=100×51 mm=3.93×2 in Wall thickness=4 mm=0.15 in.

Q: Problem 3. A 30-kg uniform plate is in equilibrium in the position shown, supported by a pin at O…

A:

Q: 1. The state of stress in a solid is defined by: 01 = 20, 02 = -40, ơ3 = -10, T12 = 0, t23 =-15, 713…

A: Given data, σ1=20Ksiσ3=-10Ksiθ=60

Q: A plane element removed from a thin-walled cylindrical shell loaded in torsion is subject to the…

A:

Q: 1. The member is loaded as shown. The diameter of the member is 32 mm. 1) Calculate all internal…

A:

Q: 3-63* At a point on the outside surface of a steel (v 0.30) thin-walled pressure vessel the strain…

A:

Pressure and Stress