A barge with a crane for loading and unloading is 18m long, 9m wide and 3m high. The weight of the barge and crane lies on the vertical center line 8m from the bottom of the barge for any position of the crane. Determine the maximum horizontal distance that the crane could swing a load of 11,000kg out to one side from the center line of the barge at deck level so that no part of the base of the scow may leave the water

Q: 4. A frustum of a cone (SG-0.45), 6m high with 4m diameter at the top and 2m at the bottom floats in…

A: r (radius at bottom) = 2/2 = 1m R (radius at top) = 4/2 = 2m R = r + m * h (    {here m is change in…

Q: ASSIGNMENT: A loaded scow has a draft of 1. m in fresh water, when upright. The scow is 6 m wide, 12…

A:

Q: A loaded scow has a draft of 1.80 meters in freshwater when erect. The scow is 6 meters wide and 12…

A: For stable condition BM>BC   or GM>O .....1  GM=BM-BGBM=IminVfluid

Q: For item #3. What is the moment due to the reaction force at A? 192.5 KN-m 157.5 KN-m 175.0 KN-m…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: O-m steel tape was suspended in three equal spans und 3 kg during a measurement of a line. The tape…

A:

Q: A barge with a crane for loading and unloading is 18m long, 9m wide and 3m high. The weight of the…

A:

Q: PROBLEM C: The 3.0 meters high by 4.0 meters wide billboard is receiving a wind pressure of 1.60…

A: Given: The height of the billboard is 3 m. The width of the billboard is 4 m. The wind pressure is…

Q: Question 3 An 8 m long beam is supported by a column at each end and has a dead load of 3 kN/m, and…

A: Solution: Given: DL = 3 kN/m LL = 1000 kg = 9.81 kN Span = 8 m

Q: It is desirable to draw a diagram of the axial, shear and flexural anchor force of the following…

A:

Q: basic equations and forces analysis are needed for reservoir and pipe folw.

A: The artificial or natural storage of water with help of dam is known as a reservoir.

Q: Due in 1 hr Please show complete figure and solution thanks!! Question: A rectangular scow 9.0m wide…

A: principle of buoyancy:Weight of water displaced = Volume of water displaced * density of water *…

Q: 5.The values of Y1 and Y2 of the trapezoidal load are Y 1 V Y 2 16.67 kN 4m 13.33 kN a)Y,=8kN/m,…

A: 5. Simply Supported Beam with Trapezoidal Load  From the shear force diagram, reaction at supports…

Q: A beam AB 10 meters long has supports at its ends A and B. It carries a point load of 5 kN at 3…

A: Given, Two point loads, = 5kN, 5kN

Q: When the barge lists 10° and determine the righting or overturning couple

A: Given data Sg=1.026 Let the depth of underwater portion be y V=6×18×y m3 For floating,…

Q: Pj = 4.0 kN P2 = 8.0 kN 1.0 m B 4.0 m- - 1.0 m-

A:

Q: 4. A frustum of a cone (SG=0.45), 6m high with 4m diameter at the top and 2m at the bottom floats in…

A: SG of cone =0.45 SG of water=1.05 Height,h=6m R1=4/2=2m R2=2/2=1 m concrete volume=2 m3…

Q: 3) A beam carries uniformly distributed load of 60 kg/m rests on three supports spaced 1.2 m apart.…

A: Determine the overhange length (x) such that all support reaction shall be the same.

Q: A column fails at a buckling load of 8 kN when both ends are fixed. If both the fixed ends are…

A:

Q: The resultant of three parallel loads (one is missing) is 13.6 kg acting up at 2 m to the right c A.…

A:

Q: A rectangular scow with a height of 7ft, width of 18ft and length of 32ft, being loaded with…

A:

Q: 1). Determine the adjusted load for all columns A B 480 KN 0.600 2200 KN 480 KN D 2200 KN G J 500 KN…

A: The size of column is 0.600×0.600. Length of foundation =0.3+4.5+4.8+0.3=9.9 Width of foundation…

Q: Determine the ultimate load in kN using LFRD given a dead load of 12 kN and a live load of 13 kN.

A: Calculation of Ultimate dead load ( Pu ) by LFRD as follows:    Given data :  Dead load is 12 kN…

Q: 1. Portal Method The frame shown is subjected to lateral loads as shown. Supports S, T, U V, W and X…

A:

Q: To accommodate the rise and fall of the tide, a walkway from a pier to a float is supported by two…

A: RA = 1470 N

Q: rectangular barge with 6750 m² horizontal cross-

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 6 kN/m 4 kN/m 2 m -1.5m- What is the concentrated load of the rectangular loading as shown in the…

A:

Q: A barge of constant rectangular section has a length of 50m, a breadth of 12.5m and a draft of 3.2m…

A: Metacentre =It is the point where line of action of buoyant force intersect  each other before and…

Q: 15 kN 5 kN/m 80 kN-m -5 m- If the 5kN/m uniformly distributed load will be transformed into a…

A: To find  Resultant force  Moment about C Distance of Resultant force R from point A

Q: Calculate the dead load of a 23 x 30 cm reinforced concrete beam that is 5 m long. The beam has a…

A: Dead Load A load (weight) that doesn't fluctuate appreciably over time is said to be dead. The idea…

Q: 2. Cantilever Method: The frame shown is subjected to lateral loads as shown. Supports S, T, U V, W…

A:

Q: What is the minimum "B" for the base of a dam 30m high if upward pressure beneath the dam is assumed…

A:

Q: A beam of 10 m long is simply supported at the ends. It carries a UDL of 10 kN/m upto a distance of…

A: Given, A beam,

Q: Calculate the dead load of a 23 x 30 cm reinforced concrete beam that is 5 m long. The beam has a…

A: Dead Load A load (weight) that doesn't fluctuate appreciably over time is said to be dead. The idea…

Q: Draw the shear force and bending moment diagram for the following loading diagram as given below. 9…

A: It is asked to draw shear force and bending moment diagram.

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?