A bar of gold is in thermal contact with a bar of silver of the same length and area as shown in the figure. One end of the compound bar is maintained at 80.0°C while the opposite end is at 30.0°C. When the energy transfer reaches a steady state, what is the temperature (in °C) at the junction? 80.0°C Au Ag 30.0°C Insulation 204 Thomeonoos Cole 90.7 20.2 51.2 30.5 100.2

A bar of gold is in thermal contact with a bar of silver of the same length and area as shown in the figure. One end of the compound bar is maintained at 80.0°C while the opposite end is at 30.0°C. When the energy transfer reaches a steady state, what is the temperature (in °C) at the junction? 80.0°C Au Ag 30.0°C Insulation 204 Thomeonoos Cole 90.7 20.2 51.2 30.5 100.2

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 155-g aluminum cylinder is removed from a liquid nitrogenbath, where it has been cooled to -196 °C. The cylinder is immediately placed in an insulated cup containing 80.0 g of water at15.0 °C. What is the equilibrium temperature of this system? Ifyour answer is 0 °C, determine the amount of water that has frozen.The average specific heat of aluminum over this temperature rangeis 653 J>1kg # K2
question below
A 670 kg meteorite made up of mostly aluminum, approaches the Earth. The initial temperature of the meteorite is -15.0°C and moves with a speed of 14.0km/s. When the meteorite collides with the Earth, half of its energy goes to Earth while the rest causes an increase in the internal energy of the meteorite which causes a momentary elevation of its temperature. Determine the final temperature of the meteorite if all the aluminum turns into gas. Assume the specific heat capacity for the liquid and gaseous aluminum is 1.17 X103J/kg* oC.
A 0.065-kg ice cube at -30.0°C is placed in 0.375 kg of 35.0°C water in a very well-insulated container. The latent heat of fusion for water is Lf = 79.8 kcal/kg Chart attached. What is the final temperature of the water, in degrees Celsius?
A 2.6 kg lump of aluminum is heated to 96°C and then dropped into 10.0 kg of water at 5.0°C. Assuming that the lump-water system is thermally isolated, what is the system's equilibrium temperature? Assume the specific heats of water and aluminum are 4186 and 900 J/kg-K, respectively. Number Units the tolerance is +/-2%
What mass of water at 28.0°C must be allowed to come to thermal equilibrium with a 1.70-kg cube of aluminum initially at 150°C to lower the temperature of the aluminum to 62.0°C? Assume any water turned to steam subsequently recondenses. kg
Lead pellets, each of mass 1.60 g, are heated to 200°C. How many pellets must be added to 451 g of water that is initially at 20.0°C to make the equilibrium temperature 25.0°C? Neglect any energy transfer to or from the container.
A 117-g cube of ice at 0°C is dropped into 1.0 kg of water that was originally at 79°C. What is the final temperature of the water after the ice has melted?
temperature is 330 K. Find the heat loss per unit area and the temperature of the junction of the fire brick and insulating brick? RO 5. In Sohar Petroleum Company, a steam pipeline, with 150 mm ID and 160 mm OD carries steam. The pipeline is surrounded with a layer of heat insulating material (K=0.08 W/m.k) of thickness 100 mm. The temperature drops from 392.8 K to 313 K across the insulating surface. Determine the rate of heat loss per 1 m length of pipe line. ID = 1Somm 160 mm OD,h-loo mm .K=0.08w/m.k %3D 「-392.8 ん/ 12 = 313k = 313 K 2.
U7
Equal masses of substance A at 98.1°C and substance B at 26.2°C are placed in a well-insulated container of negligible mass and allowed to come to equilibrium. If the equilibrium temperature is 77.4°C, which substance has the larger specific heat? a) substance A b) The answer depends on the exact initial temperatures. c) More information is required. d) The specific heats are identical.
A jet of steam at 100°C is applied to a 2.00 kg block of ice at 0°C. How many grams of steam would be required to completely melt the ice assuming a complete transfer of thermal energy? nA d bloow olle boutaig erd 15000 lo yolla an ai e W lobin bna 1900 lo yolla ns e losbinom 4