A bar of 80 mm diameter and 800 mm Length is subjected to an axial load of 200 kN. It elongates by 0.30 mm and the diameter decreases by 0.01 mm. What is the Poisson's ratio of the material of the bar?

A bar of 80 mm diameter and 800 mm Length is subjected to an axial load of 200 kN. It elongates by 0.30 mm and the diameter decreases by 0.01 mm. What is the Poisson's ratio of the material of the bar?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An 18-m-long steel wire of 10-mm diameter is to be used in the manufacture of a prestressed concretebeam. It is observed that the wire stretches 55 mm when a tensile force P is applied. Knowing that E=250GPa, determine (a) the magnitude of the force P, (b) the corresponding normal stress in the wire
Determine the stress developed in bronze and steel tube after the application of load P. Use Eg = 83 GPa and Es = 200 GPa. P = 50 KN Bronze Steel Tube A = 6361.73 mm? A = 1492.26 mm? E = 83 GPa E = 200 GPa L= 1.50 m L= 1.50 m 90 mm 100 mm
From the given illustration below, the force acting on B is equal to 25 kN, on C = 20 kN, and on D = 30 kN. If the cross sectional area of the material is 600 sg.mm, what is the maximum stress in the bar? FINAL EXAM 一- A B FINAL EXAM
A hollow steel rod has a length of 1m. The outside diameter of the rod is 0.2m and the inner diameter is 0.18m. The rod is compressed axially with a load of 200kN. The modulus of elasticity and the Poisson's ratio of the rod are 200GPa and 0.3 respectively. Determine the decrease in length of rod.
Must solve the entire question. Dont solve partially.
two decimaal places
A cylinder is made of steel plate is intended to be used as a container for compressed air. The dimensions of the cylinder are L=2m, D=60cm, and t = 0.005m. If the ultimate tensile stress of the steel is 400 N/mm², Young's modulus is 200000 MPa and Poisson's ratio is 0.25. 1- Determine the maximum air pressure that can be stored in the cylinder (use factor of safety = 2) 2- Determine the change in the volume of the cylinder due to storing maximum pressure.
A bar of 400 mm length and a uniform cross-section 20 mm diameter is subjected to tensile load of 50 kN, assuming E = 200 GPa the elongation of bar is
* Your answer is incorrect. A solid plastic rod has a diameter of d = 21 mm and a length of L = 600 mm. An axial load of P = 24 kN is applied to the rod as shown. The elastic modulus is E = 2.6 GPa and Poisson's ratio for this material is v= 0.37. Determine the magnitude of the change in the rod diameter Ad for the given load. Answer: Ad= i -0.21 L mm
help
A 100mm* 40 mm* 20 mm steel block is subjected to a hydrostatic pressure of 10MPa. The Young's modulus and Poisson's ratio of the material are 150 GPa and 0.1 respectively. Determine change in volume of the block.
Urgently needed. .