A balloon rises from the ground with a constant acceleration of 4 ft per sec2. Five seconds later, a stone is thrown vertically up from the launching site. What must be the minimum initial velocity of the stone for it to just touch the balloon? Note that the balloon and stone have the same velocity at contact.

Q: A stone weighing 45 N to one end of a cord 0.90 m long. The stone is then whirled in a vertical…

A: Consider the given data Weight of the stone=45 Nlength of the cord=0.90mBreaking strength of the…

Q: 05 kg chunk of ice is sliding at 14.0 m/s on the floor ice-covered valley when it collides with and…

A:

Q: The disk shown in (Figure 1) has a weight of 10 lb and rolls without slipping on the horizontal…

A:

Q: Please solve 3,4,5 ASAP AND I WILL RATE THE ANSWER, THANKS.

A: Given- The ramp is subdivided into equally three equally spaced steps H=5m g=10m/s2 For the second…

Q: The freight cars A and B have a mass of 20 Mg and 15 Mg, respectively. Determine the velocity of A…

A: Coefficient of restitution

Q: Mass of crate: 100 kg μk: 0.25 Determine the speed of the crate when x = 1.5 m. k = 2 kN/m 10 m 45°

A:

Q: Figure P9-84 represent the steel shaft of a machine. The gears mounted on the arrow produce the…

A:

Q: A 100 g ball moves in a vertical circle on a 1.09 m -long string. If the speed at the top is 5.00…

A: Step 1: Step 2: Step 3: Step 4:

Q: The coefficient of kinetic friction between the 10-kg box and the inclined is u = 0.05. The velocity…

A:

Q: A 75 g, 34-cm-long rod hangs vertically on a frictionless, horizontall traveling horizontally at 2.5…

A:

Q: A 5 cm diameter horizontal jet of water with a velocity of 30 m/s strikes a flat plate that is…

A: Assumptions: The flow is steady, frictionless, and incompressible water is discharged to the…

Q: • 1. Mario throws a stone vertically upward with a speed of 25m/s from the top of a tower 75 m high.…

A: Given data- Initial velocityu= 25 m/sHeight of tower h= 75 m

Q: During operation the jack hammer strikes the concrete surface with a force which is indicated in the…

A:

Q: A 100 kg block is resting on a smooth inclined surface. Determine the value of T to maintain…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.