A balanced, three-phase, four-wire, 650V system is supplying a balanced load connected in star with Z = 10 + i 15 2 per phase. A three-phase wattmeter (measuring total three-phase power) is connected to the supply and an ammeter is connected to one of the phases. Ammeter What is the reading on the ammeter? I = A Wattmeter What is the reading on the wattmeter? P = kW

A balanced, three-phase, four-wire, 650V system is supplying a balanced load connected in star with Z = 10 + i 15 2 per phase. A three-phase wattmeter (measuring total three-phase power) is connected to the supply and an ammeter is connected to one of the phases. Ammeter What is the reading on the ammeter? I = A Wattmeter What is the reading on the wattmeter? P = kW

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

B5
A 3 phase delta source is connected to a balanced delta load with a power factor of 0.37. The phase voltage is 181V RMS and the line current is 7A RMS. Calculate the total real power of this circuit. Enter your answer in Watts but do not enter the unit. Round to the nearest whole Watt.
In a 3-phase power measurement by two wattmeter method, both the wattmeter's shows identical readings. The power factor of the load is Select one: O a. Unity Ob.0.8 leading O C. Zero d. 0.8 lagging
I need the answer as soon as possible. Solve step by step correctly.
In a two-wattmeter method of measuring power in a balanced 3 phase circuit the ratio of the Watt meter reading is 1:2 the circuit power factor is?
Two wattmeters were connected to measure the power of a balanced three phase load. If the readings were 622 Watts and 402.6 watts, what is the total reactive power of the load is in VARS.
In the two-wattmeter method of power measurement for a three-phase load, the readings of the wattmeter are 2000 W and 1000 W. What is the power factor of the load?
i need the answer quickly
Three equal non-inductive resistances are connected in star across a balanced 400 V, 60 Hz system. A single phase wattmeter is connected on the system with its current coil in line 1 and potential coil in lines 1 and 3.This wattmeter registers 900 W. If the line 2 is accidentally open circuited, what will be the wattmeter reading under this condition?
In three phase star connected alternator, the phase voltage is given as: EPh=3sinwt+sin3wt+0.5sin5wt Find the phase voltage for the 60 degree phase spread.
3
Arrange a simple three-phase system in your workplace and measure the power consumed by the load. You may use wattmeter or any other digital meter, while measuring three-phase power. The connection diagram is shown in Figure 3. Your report should show details of the three-phase load and connection diagram relating to the power you have measured. This work should be evidenced by photograph in the report. W₁ IR SS R W₂ ly IB eyn Z₂ Z₁ eRN Z3 B Figure 3: Three phase system with wattmeter connection. eBN