A balanced load of 30 MW is supplied at 132 kV, 50 Hz and 0.85 p.f. lagging by means of a transmission line. The series impedance of a single conductor is (20 + j52) ohms and the total phases-neutral admittance is 315 micro-siemens. Shunt leakage may be neglected. Using the nominal T approximation, calculate the line voltage at the sending end of the line. 133 kV 145 kV 149 KV 147 kV 140 kV 143 kV 138 kV 135 kV

A balanced load of 30 MW is supplied at 132 kV, 50 Hz and 0.85 p.f. lagging by means of a transmission line. The series impedance of a single conductor is (20 + j52) ohms and the total phases-neutral admittance is 315 micro-siemens. Shunt leakage may be neglected. Using the nominal T approximation, calculate the line voltage at the sending end of the line. 133 kV 145 kV 149 KV 147 kV 140 kV 143 kV 138 kV 135 kV

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A three-phase transposed line is composed of one ACSR 1,431,000 cmil, 47/7 Bobolink conductor per phase with flat horizontal spacing of 11 meters as shown in Figure (a). The conductors have a diameter of 3.625 cm and a GMR of 1.439 cm. The line is to be replaced by a three-conductor bundle of ACSR 477,000 cmil, 26/7 Hawk conductors having the same cross-sectional area of aluminum as the single-conductor line (Figure (b)). The conductors have a diameter of 2.1793 cm and a GMR of 0.8839 cm. The new line will also have a flat horizontal configuration, but it is to be operated at a higher voltage and therefore the phase spacing is increased to 14 m as measured from the center of the bundles as shown in Figure (b). The spacing between the conductors in the bundle is 45 cm. Determine the inductance and capacitance for both lines. Calculate the percentage change in the capacitance and inductance for both lines. Interpret these changes.
In a 3-phase overhead system, each line is suspended by a string of 3 insulators. The voltage across the top unit (i.e. near the tower) and middle unit are 10 kV and 11 kV respectively. Calculate (i) the ratio of shunt capacitance to self capacitance of each insulator, (ii) the string efficiency and (iii) line voltage
A three-phase 630 kV, 50 Hz, 400 km completely transposed long transmission line, has the following positive sequence impedance and admittance parameters. z = 0.015 + j 0.25 0/km y = j 4 x 10-6 S/km Identical shunt reactors are connected from each phase conductor to neutral at both ends of the line providing 80% compensation during light load conditions. The reactors are removed during heavy load conditions. Full load is 0.75 kA at 0.95 lagging power factor and at 600 kV. Assuming the sending end voltage remains constant. Determine the following: 1. Using the equivalent r circuit find the exact ABCD parameters of the transmission line.
A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of the line is 0.5 Ω/km and the resistance is 0.3 Ω/km. Calculate the efficiency and regulation of the line for .8 lagging power factor.
3-phase single circuit bundled conductor line with two sub-conductors per phase has horizontalspacing with 6.1 m between the centre lines of adjacent phases. The distance between the subconductorsof each phase is 30.5 cm and each sub-conductor has a diameter of 2.54 cm. Find theinductance per phase per km. [0.988 mh]
A short single phase transmission line has a loop impedance of (0.2+j1.2) ohm. At what leading power factor the voltage regulation will be zero ?
[Ans. 0.174 HF) A three phase 50 Hz fully transposed line has conductors equilaterally spaced at 3 metres. The conductor diameter is 3 cm. Determine the capacitance to neutral per km per phase. (Gorakhpur Univ. Transmission of Electric Power 1975] [Ans. 0.0105 µFI - UI
Shunt capacitors are installed at the receiving end to improve the line performance of a transmission line having an A constant approximately equal to 0.9950 and a B constant of 36.2266. The line delivers 200 MVA 0.80 lagging power factor at 220 kV. Determine the receiving total real power when the sending end voltage is 220 kV.
Discuss the desirable properties of insulators. Explain the causes of insulator failure due to electrical breakdown. Each line of a three-phase system is suspended by a string of three identical insulators of self-capacitance C farad. The shunt capacitance of connecting metal work of each insulator to earth is 20.7 % of C while for line it is 13.8 % of C. Calculate the string efficiency of the system if a guard ring increases the capacitance to the line of metal work of the lowest insulator to 0.25 C.
A 3-phase overhead transmission line is being supported by three disc insulators. The potentials across top unit and middle unit are 9 kV and 11 kV respectively. Calculate: a. The ratio of capacitance between pin and earth to the self-capacitance of each unit. b. The line voltage. c. String efficiency. JAns: a. 0.22 b. 35.444 kV c. 76%]
If a 3-phase short circuit occurs in one of the two circuit of transmission line at point F, and the shunt impedance of the short circuit is j0.1 pu. Determine the maximum time when a short circuit can still be cleared. So=0.8+j0.3 Xd'= 0.2, XL1=XL2= 0.6, XT1=0.12, Xr2= 0.1, L1 V= 1.0 T1 L2 F T2 .XL= 0.1 Хс- 0.1. S1 S2 SL= 0.6+j0.3
please help solve this question A 100 km Three-Phase 50 Hz transposed transmission line is composed of bundle of three ACSR, 1,431,000 cmil, 47/7 Bobolink conductors as shown in Figure 2 (a). The Three-Phases (bundled Conductors) have flat horizontal spacing of 11 meters as shown in the Figure 2(a). The conductors have a diameter of 3.8 cm and a GMR of 1.5 cm. The Line is going to be replaced with a six conductor bundle of ACSR, 477,000 cmil, 26/7 Hawk conductors. The conductors have a diameter of 2.5 cm and a GMR of 0.9 cm. The new line will have a horisontal phase spacing of 14 meters as it is going to be operated at higher Voltage rating. The new line is shown in Figure 2 (b). The spacing between the bundles in Figure 2 (a) and (b) is 45 cm. Determine,a) The capacitance for each case and the percentage change in capacitanceb) The inductive reactance for each line and the percentage change.c) The inductance for each case and the percentage change ininductance