A balanced delta connected load of 15 + J18 Q per phase is connected at the end of a three-phase line as shown in Figure 2.25. The line impedance is 14-j2 Q per phase. The line is supplied from a three-phase source with a line-to-line voltage of 207.85 V rms. Taking Van as reference, determine the following: (a) Current in phase a. (b) Total complex power supplied from the source. (c) Magnitude of the line-to-line voltage at the load terminal.

Q: In a three-phase system, the per-unit symmetrical components of the phase currents are IO = 0.5 , I9…

A:

Q: (2) (z) Just to make sure as a preliminary question... if the base quantity is XB and the actual…

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want…

Q: Three zones of a single-phase circuit are identified shown in Figure below. The zones are connected…

A:

Q: Three single-phase step-up transformers rated at 50 MVA, 13.2 kV/80 kV are connected in delta-wye on…

A: The objective of the question is to calculate the secondary line voltage, the currents in the…

Q: A three-phase, 230 V, 72 kVA, 0.9 pf (lagging) load is supplied by three 29 kVA, 1330/230 V, 60 Hz…

A: Given, The single line diagram is shown below, Where,Feeder impedance, ZF=0.003+j0.015 Ω/phaseLine…

Q: Three single-phase step-up transformers rated at 50 MVA, 13.2 kV/80 kV are connected in delta-wye on…

A: Three single-phase step up transformers rated at S1−ϕ=50 MVA, 13.2 kV/80 kV are connected in…

Q: Example 60 MVA, 13.8 kV a balance three phase load with 0.8 lagging power factor. Determine for the…

A:

Q: What can you say about the flow of power as a function of time between a balanced three-phase source…

A: Concept: A definition of a function is that a relation from a set of inputs to a set of possible…

Q: Three single-phase distribution transformers, each rated for 18 kVA, 20000/220 volts, are connected…

A: Three single-phase distribution transformers are connected in a Dy three-phase bank. Rated power…

Q: Two single phase transformers A and B with equal turns ratio have reactance of j3.2 and j19.2…

A:

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.