A and B are cross-sections of two pipes with water flowing. These pipes look like To measure the pressure difference between A and B by connecting a U manometer is requested. The heights in the U manometer are given in inches (1 inoh -25 4 mm) inee Meil-05O ka /m 2 ond

Q: A horizontal pipe carries oil with a specific gravity of 0.86.  Two pressure gauges placed along the…

A: Given The specific gravity of oil is x=0.86. The pressure at two ends of the pipe is P1=135 psig…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

A:

Q: What is the specific gravity of the liquid in the left leg of the U-tube manometer shown in Figure…

A:

Q: A U-tube manometer employs a special fluid having specific gravity of 8.25. One side of the…

A: Note:As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: The system shown in the figure is used to accurately measure the pressure changes when the pressure…

A:

Q: Which of the following three control volumes would be the most suitable for calculating pressure at…

A: Introduction A control volume is a volume in space that is of particular importance for a certain…

Q: Sl unit of dynamic viscosity is O a. Stokes O b. Poise c. m²/s O d. Ns/m

A: Dynamic viscosity is a property of fluid which gives a measure of the resistance to flow.

Q: A jet impinges on a splitter block. The incoming jet is horizontal and has a flow rate of Q = 8000…

A:

Q: The U-Tube manometer is widely used to measure the difference in pressure between two containers or…

A:

Q: If the viscosity of water at 70°C is 0.42 centipoise and its relative density is 0.978, determine…

A: Given data: μ=0.42 centipoiseRD=0.978 Need to determine the absolute viscosity is Pa-s and its…

Q: A manometer shows a vacuum of 260 mm Hg. What will be the value of this pressure in KPa in the form…

A: Given data, Manometric reading, Pm,v = 260 mm Hg vacuum = - 260 mm Hg Atmospheric pressure, Patm =…

Q: The U-Tube manometer is widely used to measure the difference in pressure between two containers or…

A:

Q: What is the pipe pressure (pa)? Given the S for Mercury is 13 and S for fluid =0.6 Patm Air fluid 30…

A:

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.