A A1 20 in. 25 in. 25 in. – M OB o D Eo P2 35 in. A2 C P1

Q: a) Determine the normal force at point D. Express your answer in kilopounds to three significant…

A:

Q: A horizontal beam is supported by an inclined strut and carries a load of 15 kN at joint AD CB D in…

A:

Q: P 3 m * 3 m 50 mm 50 mm 20 mm 20 mm 150 mm N/A A The T-shaped beam shown above is supporting a…

A: Maximum bending stress is given by σmax= MmaxI*ymax  locate the Neutral axis from bottom we have y =…

Q: olem 4.7 The truss is made of three A-36 steel members, each having a cross-sectional area o ▼ Part…

A:

Q: Consider the beam shown below. Take P = 5 kip and w = 1.7 kip/ft. Point E is just to the right of…

A: Solution:Given Data:The concentrated load acting on the beam is P=5kipThe intensity of uniformly…

Q: The following solid aluminum bar (E = 10,000 ksi; α = 11.70E-06/F) is located between two fixed…

A: Detailed solution is given belowSlight difference in answers due to rounding off Explanation:Step…

Q: There is a P = 188 KN load applied in the mid-span of the below simply supported beam with the given…

A:

Q: Question 1. Determine the tension force in member C and its angle e for equilibrium. The forces are…

A:

Q: The rigid bars AC and BCD are supported by pins at A and B and by a steel rod at D. There is a…

A:

Q: 1.3-1 A hollow circular post ABC (see figure) supports a load P₁ = 7.5 kN acting at the top. A…

A: ###Determination for hollow Circular post ### Parta) Normal Stress in part AB Partb)  if Normal…

Q: The wedge in (Figure 1) has a negligible weight and a coefficient of static friction μ = 0.5 with…

A: Given, μk=0.5to determine,Determine the angle so that it is self locking

Q: A symmetrical beam cross section is shown below. The centroid is in the exact centre of the section.…

A:

Q: Week 5, Question 2: Using the force method, calculate the bending moment at B for the statically…

A: A frame is pinned at A and E, also a point load of 12kN is applied at B,To determine the moment at…

Q: The 1.25-in diameter steel shaft BC is built into the rigid wall at C and supported by a smooth…

A:

Q: Questions a/b c₁₂=c 200 10 E 5 0.291 m 20 40 289 10 0.312 200 0.323 0.328 10 1. 6.3 kNm torque is…

A: For given data:Torque = 6.3 kN-mLength of the shaft = 3mCross-sectional area, a= 5090 mm2Modulus of…

Q: A single axial load of magnitude P is applied at end C of the steel rod ABC. Knowing that E 30 x 106…

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.