AA physical quantity having both magnitude and direction is a scalar.(True] / (False)Joule is the SI unit for both work and energy.[True][False][True] / [False]CThe speedometer of a car measures instantaneous speedFor an isolated system, the total final energy is less than the total initial (True] / [False]energyAMPLE

A is false Physical quantity having both magnitude and direction is called vector quantity. B is…

A A physical quantity having both magnitude and direction is a scalar. Joule is the SI unit for both work and energy. C The speedometer of a car measures instantaneous speed For an isolated system, the total final energy is less than the total initial energy

A A physical quantity having both magnitude and direction is a scalar. Joule is the SI unit for both work and energy. C The speedometer of a car measures instantaneous speed For an isolated system, the total final energy is less than the total initial energy

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

h You set up a ramp as depicted to practice your skateboard skills. The ramp is a wooden board L=10.0 m long and is propped up between the ground level at one end and h=0.5 m at the other end. You approach the ramp from the right (higher ground) at 11 m/s. How fast are you once you get past the ramp (lower ground)? Assume your mass is 100 kg and friction is negligible.
A model car of mass 2.0 kg slides down a frictionless ramp into a spring with a spring constant k = 1850 N/m. a) The spring experiences a maximum compression of 20 cm. Determine the height of the initial release point. b) Calculate the speed of the model car when the spring has been compressed 10 cm.
Truck brakes can fail if they get too hot. In some mountainous areas, ramps of loose gravel are constructed to stop runaway trucks that have lost their brakes. The combination of a slight upward slope and a large coefficient of rolling friction as the truck tires sink into the gravel brings the truck safely to a halt. Suppose a gravel ramp slopes upward at 6.0° and the coefficient of rolling friction is 0.32. Part A Use work and energy to find the length of a ramp that will stop a 15,000 kg truck that enters the ramp at 35 m/s. Express your answer to two significant figures and include the appropriate units. HẢ l = Value Units Submit Request Answer
A box is under the influence of two (and only two) forces. Julio is pulling the box to the left. A conservative force (exerted by something other than Julio) is pulling the box to the right. Julio moved the box a distance of 0.35 meters to the left. Which of the following statements correctly describes the physics of the situation as he moved the box? O The potential energy of the system decreased as the conservative force did negative work. O It is impossible to know without more information. O The potential energy of the system increased as the conservative force did negative work. O The potential energy of the system increased as the conservative force did positive work. O The potential energy of the system decreased as the conservative force did positive work.
A. A large speaker that you are planning to use, has a huge diaphragm connected to a spring, the force required to compress this speakers spring is given by F = 1000x + 50 x³. Where x is the displacement from its unstretched length. Determine the work required W to compress a spring by 0.1 m. Where W = S F dx.
You are unloading a refrigerator from a delivery van. The ramp on the van is 5.0 m long, and its top end is 1.4 m above the ground. As the refrigerator moves down the ramp, you are on the down side of the ramp trying to slow the motion by pushing horizontally against the refrigerator with a force of 230 N . Part A How much work do you do on the refrigerator during its trip down the ramp? Express your answer with the appropriate units.
Hooke's law describes an ideal spring. Many real springs are better described by the restoring force (FSp), -kAs-q(As), where g is a constant. Consider a spring with k = 200 N/m and q = 750 N/m³. ▼ Part A How much work must you do to compress this spring 15 cm? Note that, by Newton's third law, the work you do on the spring is the negative of the work done by the spring. Express your answer with the appropriate units. ▸ View Available Hint(s) Submit W = Value ▾ Part B 0! HÅ ᎪᎳ . Units By what percent has the cubic term increased the work over what would be needed to compress an ideal spring? Express your answer as a percentage. ▸ View Available Hint(s) ΠΫΕΙ ΑΣΦ ? → ? %
In the high jump, the kinetic energy of an athlete is transformed into gravitational potential energy without the aid of a pole. Part A With what minimum speed must athlete leave the ground in order to lift his center of mass 1.95 m and cross the bar with a speed of 0.70 m/s ? Express your answer to two significant figures and include the appropriate units. V = μÅ O Value Units Submit Request Answer ?
A uniform board of length L and mass M lies near a boundary that separates two regions. In region 1, the coefficient of kinetic friction between the board and the surface is μ1, and in region 2, the coefficient is μ2. The positive direction is shown in the figure. Find the net work W done by friction in pulling the board directly from region 1 to region 2. Assume that the board moves at a constant velocity.b Express your answer in terms of M, g, L, μ1, and μ2. What is the total work done by the external force in pulling the board from region 1 to region 2? (Again, assume that the board moves at constant velocity.) Express your answer in terms of M, g, L, μ1, and μ2.
Three different objects, all with different masses, are initially at rest at the bottom of a set of steps. Each step is of uniform height d. The mass of each object is a multiple of the base mass m: object 1 has mass 4.60m, object 2 has mass 1.71m, and object 3 has mass m. When the objects are at the bottom of the steps, define the total gravitational potential energy of the three-object system to be zero. If the objects are then relocated as shown, what is the new total potential energy of the system? Each answer requires the numerical coefficient to an algebraic 3 expression. Each algebraic expression is given using some combination of the variables m, g, and d, where g is the acceleration due to gravity. Enter only the numerical coefficient. (Example: If the answer is 1.23mgd, just enter 1.23) Ug.system = mgd
To stretch an ideal spring 8.00 cm from its unstretched length, 17.0 J of work must be done. Part C How much work must be done to compress this spring 4.00 cm from its unstretched length? Express your answer with the appropriate units. W = Value Units Submit Request Answer Part D What force is needed to compress the spring this distance? Express your answer with the appropriate units. HẢ ? F = Value Units Submit Request Answer
A bead is used to demonstrate the inter-conversion of kinetic and potential energies in a model roller coaster track. The bead is released at point A with certain speed. Assume that there is no energy loss, which of the following statements is NOT ALWAYS TRUE? A It has the highest kinetic energy at point C if the bead can pass point В. Mechanical energy is always conserved. Kinetic energy and potential energy is inter-changing. The velocity of the bead at point B is greater than that at point A.