(a) A body of weight 45 N is placed on a rough horizontal plane. To just move the body on the horizontal plane, a push of 25 N inclined at 11° to the horizontal plane is required. Find the coefficient of friction.

Q: a 2kg book is pushed against a vertical wall by a horizontal force P. The coefficient of friction…

A: As per given question A 2kg book is pushed against a vertical wall by a horizontal force P. The…

Q: Situation 2: Find the minimum force P required to just pull out box B. Also, find the tension of the…

A:

Q: Plz don't use chat gpt plz

A: Step 1: Given Refrigerator mass(M) =  105 kgMan Mass (m) = 70 kg.a). if the coefficient of static…

Q: The coefficient of friction between 200 Ib homogeneous cylinder and the horizontal plane is 0.4 as…

A: Write the expression of friction force in case of slipping.   Fk=μkN=μkW   But, in this case…

Q: A block of mass 14 kg is resting on a table is pulled by a force of 100 N. The coefficient of…

A: Given     Mass, m = 14 kg     Force, F = 100 N

Q: Determine the force P required to lift the M-kg steel crate which rests against a 5° wedge on a side…

A: Given dataM=95 kgμcw=0.45μws=0.35μcs=0.38g=9.806 m/s2To find P

Q: The mass of A is 30 kg and the mass of B is 5 kg. The coefficient of kinetic friction between A and…

A: The mass of ball at B is .The mass of ball at A is The angle is The coefficient of kinetic friction…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.