(a) A 3-phase, 50 Hz, 220 kV overhead transmission line is 300 km long. Per kminductance and capacitance of the line per phase are 1 mH and 0.01 µF, respectively.Assuming the line to be lossless, find the propagation constant per km, characteristicimpedance, velocity of propagation of current and voltage waves along the line, andthe wavelength of those waves.(b) A 15 kV, 1500 rpm, 3-phase, round rotor synchronous generator has a synchronousreactance of 10 N per phase. With the rated voltage at its terminals, the machine isoperating at unity power factor with a load angle, 8 = 8max/3, where &max is themaximum possible load angle of the generator. What is the internal line to line emfof the generator?(c) Solve the following equations by Newton-Raphson method. Take an initial guess ofx1 = 1.5 and x2 = 3.5.xỉ + x1x2 = 10X2 + 3x1x = 57

We are authorized to answer only 1 question at a time, since you have not mentioned which question…

(a) A 3-phase, 50 Hz, 220 kV overhead transmission line is 300 km long. Per km inductance and capacitance of the line per phase are 1 mH and 0.01 uF, respectively. Assuming the line to be lossless, find the propagation constant per km, characteristic impedance, velocity of propagation of current and voltage waves along the line, and the wavelength of those waves.

(a) A 3-phase, 50 Hz, 220 kV overhead transmission line is 300 km long. Per km inductance and capacitance of the line per phase are 1 mH and 0.01 uF, respectively. Assuming the line to be lossless, find the propagation constant per km, characteristic impedance, velocity of propagation of current and voltage waves along the line, and the wavelength of those waves.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Electromgneetic waves
A lossless transmission with characteristic impedance of Z0 = 1002 and length = 52cm The line was terminated with a load of Zy= 30 + j502. According to what is given, a) The reflection coefficient in the load and the voltage standing wave ratio on the line (GDDO) Find out. b) Find the impedance and admittance at the line input. (for f = 750MHZ) c) For f = 750MHZ, the impedance and admittance values 2cm away from the load. (It will be assumed that = 20.)
A lossless transmission line with characteristic impedance of Z0 = 1000 and length l = 52cm was terminated with a load of Zy- 30 + j500. Based on the given, a) Find the reflection coefficient at the load and the standing wave ratio of the voltage on the line (GDDO). B) Find the impedance and admittance at the line input. (For f = 750MHZ) c) For f = 750MHZ, find the impedance and admittance values 2cm away from the load. (2 = 10 will be accepted.)
A Three-Phase, 50 Hz, 220 KV Transmission Line consists of conductors of 1.2 cm radius spaced 2 meters at the corners of an equilateral triangle. Calculate the Corona Power Loss per km of the line at a Temperature of 20ºC and Barometric Pressure of 72.2 cm of Hg. Take the Surface Factor of the conductor as 0.96
3 A 3-phase, 50 Hz transmission line 100 km long, Load current i 5A at 0-9 p.f.lagging and at 110 kV. The resistance and reactance of the line per phase per km are 0-2 Q and 0-42 respectively, while capacitance admittance is 2-5 * × 10- 6 siemen/km/phase. then magnitude of V1 is
A 46 -km long, 55 Hz, single-phase, 2-wire, transmission line is composed of 22 -mm diameter solid conductors. If the separation between conductors is 2.9 m., What is the total inductance of the line in (mH)?
The capacitance per unit length and the characteristic impedance of a lossless transmission line is C and Zo, respectively. Find the velocity of a travelling wave on the transmission line.
Answer all subpart I will thumbs up... Consider a three-phase single circuit transmission line 362 km long, rated voltage 200kV, 125 MW load and unity power factor. a)Calculate the incident and reflected waves on the source and load sides b)Calculate the voltage on the source side (phase-neutral and phase-phase) c)Calculate the wavelength and its propagation speed Given the following table: R = 0.1069 ohm/km L = 1.3549 mH/km C = 0.0085 microfared/km G = 0
Electrical Engineering A losless line assumed to be infinitely long and of unknown characteristic impedance Z,, when connected to a lossless line of characteristic impedance 10092, produces a standing wave ratio of value 2 in the 1002 line. The same line (of unknown impedance) when connected to a line with the characteristic impedance 202 produces a standing wave ratio of value 2.5 in the 2012 line. Find: 1) possible values of the reflection coefficient from the connection between the 10092 and Z, lines; 2) possible values of the reflection coefficient from the connection between the 20 and Z.
For a transmission line: a) Draw the lumped-element circuit model. b) State what each element of the model (R, L, G, C) physically represents. c) For lossy and lossless media, express the characteristic impedance and phase velocity of the transmission line in terms of R, L, G, C.
A lossless transmission line (TL) has a characteristic impedance of Zo= 250 N, a load impedance of ZR = 125 – j150 N and its operating frequency is fo Smith chart to evaluate the following parameters: 150 MHz. Use 1) The load admittance YR. 2) The reflection coefficient [Kr|ZOR 3) The voltage standing wave ratio (VSWR). Then calculate the maximum and minimum impedance in this TL, (Zmax and Zmin). 4) The distance from load to the nearest maximum (dmax) and minimum voltage positions (dmin) (in meter). 5) Find Zd at a distance away from a load by d= 3.3 2. Then calculate Zd using TL equation.
A 3-phase overhead transmission line has its conductors arranged at the cor- ners of an equilateral triangle of 2 m side. Calculate the capacitance of each line conductor per km. Given that diameter of each conductor is 1-25 cm.