**Problem Statement:**A 83.3-N backpack is hung from the middle of an aluminum wire, as shown in the diagram below. The temperature of the wire then drops by 15.4°C. Find the tension in the wire at the lower temperature. Assume that the distance between the supports does not change, and ignore any thermal stress.**Diagram:**- The diagram illustrates an aluminum wire with length \( L_0 \) suspended horizontally between two fixed supports.- A backpack weighing 83.3 N is hung from the middle of this wire, causing a symmetrical sag.- The distances from the points where the backpack is hung to each support are both labeled as 3.00 meters.**Solution:**- You are asked to calculate the tension in the wire after a temperature decrease of 15.4°C.- The number provided for input is "710" with units selectable as Newtons (N).Note: Calculating the tension involves understanding thermal expansion and the principles of physics related to forces in wires.

Given:- The weight of the backpack is W = 83.3 M The temperature of the wire then drops by the ∆T…

A 83.3-N backpack is hung from the middle of an aluminum wire, as the drawing shows. The temperature of the wire then drops by 15.4 C°. Find the tension in the wire at the lower temperature. Assume that the distance between the supports does not change, and ignore any thermal stress. Number i 710 Lo T 3.00⁰ Units N Lo 3.00⁰

A 83.3-N backpack is hung from the middle of an aluminum wire, as the drawing shows. The temperature of the wire then drops by 15.4 C°. Find the tension in the wire at the lower temperature. Assume that the distance between the supports does not change, and ignore any thermal stress. Number i 710 Lo T 3.00⁰ Units N Lo 3.00⁰

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

F4
A block of iron (c=448.00 J/kj°C) initially at temperature 6.00°C is dropped into an insulated container filled with 15.71kg of water ( cwater=4186.00 J/kg°C) at 93.00°C. They come to equilibrium at a final temperature of 39.00°C. Determine the mass of the iron block. _____kg Determine the magnitude of thermal energy Q transferred between the two substances. ______kJ
Q1/ A volume of the vessel A is 0.3 m' contains ammonia at 25 °C, 90% quality. The pressure of cylinder B will be floated at 200 kPa, cylinder B in the beginning is empty. The air is flowed into cylinder B when the valve is opened and reaches to equilibrium state of 200 kPa, 25 °C. Determine the heat transfer during the process.
A2.9 kg lump of aluminum is heated to 95°C and then dropped into 10.0 kg of water at 5.0°C. Assuming that the lump-water system is thermally isolated, what is the system's equilibrium temperature? Assume the specific heats of water and aluminum are 4186 and 900 J/kg-K, respectively. Number i Units
n, A thermometer is taken from a room where the temperature is 24°C| to the outdoors, where the temperature is –12°C.. After one minute the thermometer reads 11°C. (a) What will the reading on the thermometer be after 4 more minutes? (b) When will the thermometer read –11°C? minutes after it was taken to the outdoors.
A solid cylindrical bar conducts heat at a rate of 25 W from a hot to a cold reservoir under steady state conditions. If both the length and the diameter of this bar are doubled, the rate at which it will conduct heat between these reservoirs will be O 12.5 W. O 200 W. O 100 W. O 25 W. O 50 W.
B2
The density of ice and water are 917 kg/m³ and 1000 kg/m³. The latent heat for the transition between ice and water is 334 kJ/kg. Calculate the slope of the tangent of the coexistence curve of ice and water at T = 253 K. Select one: dP O a. dT O b. O c. O d. dP dT dP dT dP dT = -165 atm/K = -168 Pa/K = - 175 Pa/K = -143 atm/K
7B. A 98.2 g copper rod is cooled from 80°C to 25°C by tossing it into a very large swimming pool at 25°C. The temperature of the pool is not appreciably changed in the process. Compute ASys, ASur and ASniv- (Treat the copper rod as the system.) Some possibly useful data for Cu: C,m-24.44 J K 'mol 'univ p.m
In this problem you will consider the effect that thermal expansion due to temperature will have on Archimedes' principle. Take the densities of water and copper at 0ºC to be 1.00 × 103 kg/m3 and 8.90 × 103 kg/m3, respectively. a. Calculate the fraction of a copper block’s weight that is supported by the buoyant force at 0°C. b. Calculate the fraction of a copper block’s weight that is supported by the buoyant force at 95°C. Assume the volume expansion coefficient of copper is βC = 5.10 × 10-5 1/°C.
Answer in m
A steel rod (p=7860 kg/m³) has a length of 3.75 m. It is bolted at both ends between immobile supports. Initially there is no tension in the rod, because the rod just fits between the supports. Find the tension that develops when the rod loses 3190 J of heat. Number ! Units N