A 6-pole motor turns at 1080 rpm when connected to a 60 Hz voltage source. Most nearly, what is the angular velocity of the slip? OA. 27/3 rad/s OB. TT rad/s OC. 27 rad/s D. 477 rad/s 4π

Q: In an induction motor, if the rotor is locked, then the rotor frequency of induction motor will be:…

A: Given: In an induction motor, the rotor is locked.

Q: The synchronous speed of the rotor is 2100 and the percentage is 0.02% and that the synchronous…

A: In this question,  We need to determine the synchronous speed of the field?

Q: At starting of an Induction motor, the frequency of the rotor induced voltage would be

A: Mutual Induction:  Whenever flux in one coil links with the second coil, an EMF is induced in the…

Q: Discuss the significance of SCR in designing an alternator

A: In this we will write about short circuit ratio..

Q: If rotor of an induction motor turns at synchronous speed, the frequency of the rotor will be zero.…

A: In this question we need to verify the given statement is true or false.

Q: The O smaller O larger the number of poles used in a stepper motor, the better the resolution

A: here we have to give relation between the number of poles and resolution.

Q: Angular speed of a DC motor running at a speed of 1200rpm is

A: To determine angular speed (in rad/sec) from the speed given in rpm

Q: 17. A small single phase, 240 V induction motor is tested in parallel with 160 N resistor. The motor…

A: It is given that: V=240 VR=160 ΩIm=2 AIT=3 A

Q: the efficiency of the 1 phase induction motor could be better increased by adding a permanently…

A:

Q: In an induction motor, if the rotor is locked, then the rotor frequency of induction motor will be:…

A: Given that  The rotor of the induction motor is locked. Then the rotor frequency of the induction…

Q: A 6-pole motor turns at 1080 rpm when connected to a 60 Hz voltage source. Most nearly, what is the…

A: Given: An induction motor has P=6Nr=1080 rpmf=60 Hz

Q: A three phase induction motor operating at a slip of 5 % develops 20 kw rotor output power. What is…

A: The rotor copper loss in the above given operating conditions is calculated as shown below:

Q: Need asap. If the generated voltage of a separately excited generator is 100 v at 1200 rpm at what…

A: The solution can be achieved as follows.

Q: Draw and label both the power and control circuit of a 3 phase DOL induction machine starter

A:

Q: A voltmeter gives 120 oscillations per minute when connected to the rotor of an induction motor.…

A: Given that voltmeter is connected to rotor of induction motor and gives 120 oscillations per minute.…

Q: For alternator having fractional pitch winding of 11/15 the coil span is O 4.28 O 2.30 O 72.00 O…

A:

Q: A synchronous machine is generating power of 2.6 MW, If the machine can deliver a maximum power of…

A: Given: P=2.6 MWPem=3.7 MW

Q: A synchronous machine is generating power of 2.8 MW, If the machine can deliver a maximum power of…

A: We need to find out power angle,lxx

Q: I need the curve between the power factor and mechanical load in synchronous motor

A: The relation between Power factor and mechanical load is given by inverted V- curve of motor. It is…

Q: If the voltage is 400v its 3 phase its frequency is 50hz it has 4 poles per phase its running speed…

A: Step 1:

Q: When the supply voltage to an induction motor is reduced by 10%, the maximum torque will decrease by…

A: Given, The supply voltage to an induction motor is reduced by 10%. V2=0.9V1

Q: A centre zero ammeter connected in the rotor circuit of a 6-pole 50 Hz induction motor makes 30…

A: Given- 6-pole 50 Hz induction motor, No. of poles p=6, frequency f=50 Hz, 30 oscillations in 1…

Q: The rotor power output of three phase induction motor is 15 kW. What would be the rotor copper loss…

A: Given the rotor power output of three phase induction motor is, Rotor Po/p=15 kW Slip, s = 4 % =…

Q: LA 6-pole, 50 Hz single-phase inductor motor runs at a speed of 950 rpm. The frequency / frequencies…

A: Given -  frequency f = 50 Hz, Pole P = 6, Motor speed Nr= 900 rpm.   To find - Frequencies of…

Q: At start the slip of an induction motor is equal to O 0.75 00 O 0.5

A: At starting the rotor speed of induction motor is zero. Nr=0 Let a induction motor with synchronous…

Q: False True The speed of d.c shunt motor is decreased if the field current is increased Wave windings…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A 4-pole induction motor, supplied by a slightly unbalanced three-phase 50 Hz source, is rotating at…

A: Given an induction motor with, Total number of pole, P=4. Frequency, f=50 Hz. Rotor speed, Nr=1440…

Q: The voltage at induction motor rotor oscillates 180 times per minute. The stator frequency is 60 Hz.…

A: Given, Rotor oscillates 180 times per minute. Rotor frequency, f'=18060=3 Hz. Stator frequency, f=60…

Q: A 3-phase induction motor has a slip value of 0.02 and a slip frequency of 50Hz. What is the…

A: Given data  A 3-phase induction motor slip s =  0.02 and  Supply frequency f= 50Hz. the frequency of…

Q: If the speed of an Induction machine is 100 rad/sec, the speed in rpm is

A: aacording to question we need to calculate the value of speed in rpm from rad/s.

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.