A 50m tape was used to measure a square lot that was 0.05m too short. If the area of the lot is 5000m², what is the error in the computed area? Show complete solution 3 decimal places all final answers

A 50m tape was used to measure a square lot that was 0.05m too short. If the area of the lot is 5000m², what is the error in the computed area? Show complete solution 3 decimal places all final answers

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Tisha owned a rectangular lot in their province. The given values below are the sides and…

Q: Determine the area bounded by a straight road and an irregular boundary using the data given below:…

Q: 1. If the relative error in measuring an area of 320m^2 was 0.03, calculate the absolute error for…

Q: Using the figure and table below, solve the following: NOTE: Express your answers to 4 decimal…

Q: Determine the area bounded by a straight road and an irregular boundary using the data given below:…

Q: The correct distance between points C and D is 213.5m. If a 100-m tape that is 0.025m too long is…

A: Given data Correc distance between C and D (Lc) = 213.5 m Correct tape length (l) = 100m Tape is…

Q: The area of a triangular lot is needed to be computed. The sides of triangle ABC were measured as…

Q: A rectangular lot was being measured using a 30-m metallic tape which was 6 mm too long. The…

Q: In a rectangle with interior angles 95, 91, 92 and 93 degrees. Determine the value that should be…

Q: The area of a rectangular field was found to be 3000 sq. m. after a precise measurement using a 60…

Q: The sides of a rectangular piece of land are measured several times. Only 2 sides are measured since…

A: Given data-

Q: A metallic tape which was originally 30 m is found to be 29.91 m long. If the tape is to be used in…

A: And the sub topic is correction due to incorrect length of tape. L=true length of tape( Designated…

Q: 2. On a map with a scale of 1 cm = 290 m, the measured length of a concrete fence is 0.33 m.…

Q: The two sides of a rectangular lot were measured with certain estimated probable errors as follows:…

A: From the given data :W=253.36mL=624.15mew=±0.06meL=±0.08mso,

Q: Q5: An aerial photograph has a scale of 1:10,000. On the photo, the length of a field is measured as…

Q: For a highway curve with R= 1000 m, I = 16°30', and Pl station = 3 +264.759 m, calculate the…

A: R = 1000 m I = 16o30'

Q: Determine the area bounded by a straight road and an irregular boundary using the data given below:…

Q: Show complete solution. Round off answers to 2 decimal places. Do not forget to include the units.…

Q: Show complete solution On a photograph drawn to a scale of 1:5000, the dimensions of three sides of…

A: Area of triangle on the photoA=ss-as-bs-c s=a+b+c2=4.15+8.98+6.452=9.79

Q: Show complete solution. Round off answers to 2 decimal places. Do not forget to include the units.…

Q: Find dimension A as shown in the figure below. Round answer to the nearest tenth. 425.0 260.00…

A: The dimension A can be calculated using simple geometry : 1) Hypotenuse Right angled triangle rule…

Q: A 100-m tape that is "x" m. too long was used to measure two points and the result is 420.307m. It…

A: True length of tape,TL =(100+x) mNominal length of tape, NL = 100 mMeasured distance between two…

Q: A rectangular lot was measured using a 50m steel tape which was later found to be 15mm too short.…

Q: Do not copy the answer here in bartleby. Give clear solutions UPVOTE WILL BE GIVEN. Please write…

Q: The length of a water course passing through the fields was measured with 30 m steel tape and the…

A: The Length of Gunter’s chain is 66 ft long. It consists of 100 links and the length of each link is…

Q: 400 350 Lot Area Computation 300 250 NORTHINGS (m) EASTINGS (m) 200 159.970 340.650 150 139.370…

Q: The correct distance between points C and D is 213.5m. If a 100-m tape that is 0.025m too long is…

Q: Point A is between points B and C. The distances of B and C from point A are 1000m and 2000m…

Q: Given the following information: sum of squared errors = 470.60, sum of (yi-ybar)^2= 1623 what…

A: As we can see in the question sum of squared error and sum of squared total is given. So we have to…

Q: A 30 m. steel tape is 2 mm too long at 20°€. A rectangle is measured with this tape. The sides are…

Q: The error in measuring the radius of a 5cm circular rod was 0.2%. If the cross-sectional area of the…

A: given- Error in measuring radius= 0.2% radius=R=5 cm area=A % error in area needs to be find out.

Q: Determine the area bounded by a straight road and an irregular boundary using the data given below:…

Q: Using Simpson's Rule, calculate the volume of cut required for a road construction for a national…

A: Stake 1 2 3 4 5 6 7 8 9 NGL 81.3 82.5 83.8 84.1 87.25 85.8 84.6 83.5 83.0 Formation Level (F.L)…

Q: Station Cut End Area (ft2) 10+00 240 11+00 362 12+00 443 13+00 406 14+00 261 15+00 101 For the…

A: Given data - Length (L) = 100 ft Find out - Calculate the volume of excavation between stations…

Q: Determine the area bounded by a straight road and an irregular boundary using the data given below:…

Q: Hermie was asked to estimate the perimeter of the Einstein building. He paced the length and the…

Q: he area of the shaded triangle in the below figure, if you know the radius of circular curve…

A: First find angle of the circular arc with the help of length of curve

Q: 2. On a map with a scale of 1 cm = 290 m, the measured length of a concrete fence is 0.33 m.…

A: Given data, Measured length of concrete fence = 0.33 m Scale : 1cm = 290 m To find out the…

Q: Determine the area bounded by a straight road and an irregular boundary using the data given below:…

A: h1=5.8h2=4.08h3=7.84h4=7.92h5=6.02h6=4.2h7=7.75 d = station interval = 30

Q: Express your final answers in two decimal places. 3. What is the most probable value of a…

Q: where did you solve to get 784.8?

A: In the given problem, the mass of the object, say m, at point C is 80 kg.The weight of the object,…

Q: determine the area of his lot which is shown below. use a combination of the Trapezoidal Rule and…

Q: A rectangular lot was measured using a 50m steel tape which was later found to be 15mm too short.…

Q: Triangle ABC has the following data: AB= 15.2, BC= 16.6 and CA= 19.3. Find the area. Express your…

Question

A 50m tape was used to measure a square lot that was 0.05m too short. If the area of the lot is 5000m², what is the error in the computed area?

Show complete solution
3 decimal places all final answers

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

You are required to measure the area of a site by tape only. The needed length measurements are provided as below: В A H. F E Sides Length A 12 30 25 25 22 20 25 H. 35 20 Attach your calculation and write down your final answer (the area).
Determine the area bounded by a straight road and an irregular boundary using the data given below: STATION OFFSETS 0+000 8.89 0+020 6.66 0+040 7 0+060 6.15 0+080 8.58 0+100 6.39 Use the best method applicable. Round your answer to 3 decimal places. Add your answer
You are required to measure the area of a site by tape only. The measurements are provided as below: A Sides Length (m) A 10 B 15 F 20 G 28 30 C 35 D 18 3.
Determine the area bounded by a straight road and an irregular boundary using the data given below: STATION OFFSETS 0+000 7.03 0+030 6.94 0+060 8.86 0+090 7.88 0+120 5.22 0+150 7.11 0+180 8.35 Use the best method applicable. Round your answer to 3 decimal places.
1. Complete the differential level notes shown below, perform the customary arithmetic check, provide a detailed sketch on every instrument set-up, and a detailed solution. BACKSIGHT FORESIGHT STA HI ELEV HAIR RDGS MEAN RDG HAIR RDGS MEAN RDG S 3.258 BM20 3.015 532.1234 2.833 1.289 3.584 TP1 1.114 3.319 1.002 3.189 5.964 6.647 ТР. 5.714 6.556 5.568 6.412 4.845 3.478 ТР, 4.602 3.268 4.469 3.001 0.846 2.298 ТРа 0.739 2.048 0.698 1.885 2.222 BM21 2.111 2.000
Area Calculation Given the following coordinate values, compute the area in square feet. N1 = 1000.0000 E1= 1000.0000 N2 = 1187.9385 N3 928.1309 E3= 1218.4040 N1= 1000.0000 E2 1068.4040 example answer E11000.0000 Round final answer to nearest "whole foot" Don't enter commas as all answers are greater than 1000 square feet and D2L will view the comma as an extra number and mark your answer incorrect. Also, don't enter fractions of a foot - no decimal place either. 29253 A
A 50 m tape was used to measure a square lot that was 0.05 m too short. If the area of the lot is 5000 m², what is the error in the computed area? a. 11.005 m² b. 10.015 m² c. 9.004 m² d. 12.003 m²
Express your final answers in two decimal places. 3. What is the most probable value of a rectangular lot having the width and length of 239.01 + 0.03 m and 497.22 + 0.03 m? Express your final answer in cm².
ASAP PLEASE. RATE WILL BE GIVEN ACCORDINGLY.
A 50m tape was used to measure a line DE. The adjusted distance of line DE is 120.23m long. If the tape is 0.04m too short, what is the measured distance? Show complete solution Use 3 decimals
Answer it clearly and in detail.
A rectangular lot was measured using a 100ft metallic tape which was 0.02 ft too long. The recorded distance were 231.20 ft long by 121.5o ft wide. Determine the error due to the erroneous length of the tape and actual area? (Use 3 decimal points)