A 50m steel tape weighs 0.05 kg/m and is supported at its end points and at the 10m and 30m marks. If a pull of5 kg is applied, determine the following. a. Correction due to sag between the 0m and 10m marks, 10m and 30m marks, and the 30m and 50m marks. b. Correction due to sag for one tape length c. Correct distance between the ends of the tape

A 50m steel tape weighs 0.05 kg/m and is supported at its end points and at the 10m and 30m marks. If a pull of5 kg is applied, determine the following. a. Correction due to sag between the 0m and 10m marks, 10m and 30m marks, and the 30m and 50m marks. b. Correction due to sag for one tape length c. Correct distance between the ends of the tape

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

draw the FBD of joint B
Figure Q3 shows the copper shaft subjected to the axial loads. Determine the displacement of end A with respect to end D. The diameters of each segment are daB = 75mm, dâc = 50mm, and dcp = 25mm. Take Ecu 3D 126GPa. (C02, СЗ, РО1, WP1) %3D 1250mm 1875mm 1500mm 10kN 30KN 5kN C 15KN 10kN A В
ASAP
b=4a allowable stress 300MPa Sizing the beam Note: Shear and Moment Diagrams should be drawn Note: Show the calculations in detail
A short rectangular column 300 mm on one side and 400 mm on the other side is reinforced with 8-16-mm-diameter longitudinal bars equally distributed to the shorter sides of the column. Use fc = 21 MPa and fy = 420 Mpa. Calculate the required spacing in mm of laterial ties 10-mm-diameter A. 300 B. 250 C. 450 D. None of the above
kindly please help me answer this question, please be accurate and detailed when it comes to the solution. thank you.
ASAP Dont round off initial values pls, round off final ans only tyy
Que. 2 A steel plate is 30 cm wide and 10 mm thick. A rivet of nominal diameter 18 mm is driven. The net sectional area of the plate is L 1.95 10mm
Six 7/8-in-diameter rivets fasten the plate in Figure below to the fixed member. Determine the average shearing stress caused in each rivet by the 15 kips loads. What additional loads P can be applied before the shearing stress in any rivet exceeds 9100 psi?
4. The plate shown in the figure is fastened to thefixed member by seven 10-mm-diameter rivets.Compute the value of the loads P so that theaverage shearing stress in any rivet does notexceed 70 MPa.