A 500-g sample of iron is heated to 50.0°C and placed on a very large block of ice, which is uniformly at a temperature of 0.00°C. Assume no heat is gained from or loss to the surroundings during this process. The two substances gradually come to thermal equilibrium. Note: "Very large" mean that the ice doesn't melt through and the melted ice doesn't run off. What is the mass (in kg) of ice that melts?

A 500-g sample of iron is heated to 50.0°C and placed on a very large block of ice, which is uniformly at a temperature of 0.00°C. Assume no heat is gained from or loss to the surroundings during this process. The two substances gradually come to thermal equilibrium. Note: "Very large" mean that the ice doesn't melt through and the melted ice doesn't run off. What is the mass (in kg) of ice that melts?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter2: The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 60P: A sample of neon gas (Ne, molar mass M=20.2 g/mol) at a temperature of 13.0 is put into a steel...

See similar textbooks

Similar questions

For a temperature increase of 10 at constant volume, what is the heat absorbed by (a) 3.0 mol of a dilute monatomic gas; (b) 0.50 mol of a dilute diatomic gas; and (c) 15 mol of a dilute polyatomic gas?
A Carnot refrigerator exhausts heat to the air, which is at a temperature of 25 . How much is used by the refrigerator if it freezes 1.5 g of water per second? Assume the water is at 0 .
Consider the latent heat of fusion and the latent heat of vaporization for H2O, 3.33 105 J/kg and 2.256 106 J/kg, respectively. How much heat is needed to a. melt 2.00 kg of ice and b. vaporize 2.00 kg of water? Assume the temperatures of the ice and steam are at the melting point and vaporization point, respectively. (a). UsingEq21.9, Q = mLF = (2.00 kg) (3.33l05 J/kg) = 6.66105 J (b).UsingEq21.10. Q = mLV = (2.00kg) (2.256106 J/kg) = 14.51106 J
An ideal gas initially at 300 K undergoes an isobaric expansion at 2.50 kPa. If the volume increases from 1.00 m3 to 3.00 m3 and 12.5 kJ is transferred to the gas by heat, what are (a) the change in its internal energy and (b) its final temperature?
The insulated cylinder shown below is closed at both ends and contains an insulating piston that is flee to move on frictionless bearings. The piston divides the chamber into two compartments containing gases A and B. Originally, each compartment has a volume of 5.0102 m3 and contains a monatomic ideal gas at a temperature of and a pressure of 1.0 atm. (a) How many moles of gas are in each compartment? (b) Heat Q is slowly added to A so that it expands and B is compressed until the pressure of both gases is 3.0 atm. Use the fact that the compression of B is adiabatic to determine the final volume of both gases. (c) What are their final temperatures? (d) What is the value of Q?
Most automobiles have a coolant reservoir to catch radiator fluid than may overflow when 1he engine is hot. A radiator is made of copper and is filled to its 16.0L capacity when at 10.0C. What volume of radiator fluid will overflow when the radiator and fluid reach their 95.0C operating temperature, given that the fluid’s volume coefficient of expansion is =400106/C ? Note that this coefficient is approximate, because most car radiators have operating temperatures of greater than 95.0C.
A sample of neon gas (Ne, molar mass M=20.2 g/mol) at a temperature of 13.0 is put into a steel container of mass 47.2 g that's at a temperature of 40.0 . The final temperature is 28.0 . (No heat is exchanged with the surroundings, and you can neglect any change in the volume of the container.) What is the mass of the sample of neon?
A system consisting of 20.0 mol of a monoatomic ideal gas is cooled at constant pressure from a volume of 50.0 L to 10.0 L. The initial temperature was 300 K. What is the change in entropy of the gas?
Why are there two specific heats for gases Cp and Cv , yet only one given for solid?
When 400 J of heat are slowly added to 10 mol of an ideal monatomic gas, its temperature rises by 10 . What is the work done on the gas?
A company advertises that it delivers helium at a gauge pressure of 1.72107 Pa in a cylinder of volume 43.8 L. How many balloons can be inflated to a volume of 4.00 L with that amount of helium? Assume the pressure inside the balloons is 1.72105 Pa and the temperature in the cylinder and the balloons is 25.0 .
In car racing, one advantage of mixing liquid nitrous oxide (N2O) with air is that the boiling of the "nitrous" absorbs latent heat of vaporization and thus cools the air and ultimately the fuel-air mixture, allowing more fuel-air mixture to go into each cylinder. As a very rough look at this process, suppose 1.0 mol of nitrous oxide gas at its boiling point, 88 , is mixed with 4.0 mol of air (assumed diatomic) at 30 . What is the final temperature of the mixture? Use the measured heat capacity of N2O at 25 , which is 30.4J/mol . (The primary advantage of nitrous oxide is that it consists of 1/3 oxygen, which is more than air contains, so it supplies more oxygen >to bum the fuel. Another advantage is that its decomposition into nitrogen and oxygen releases energy in the cylinder.)