Answered: A 50-microfarad is connected in series…

A 50-microfarad is connected in series with a coil having 50 ohms resistance and 150 mH inductance. The source voltage is 100 sin (ωt – 120°) V. What is the maximum reactive power? Ans: ___ Var

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: 6. What is the effect of load inductance on the ripple current? 7. effect of chonnine

A: Effects of load Inductance on ripple current :

Q: Protection Schemes for Series Capacitor (compensation )

A: Series compensation is a tool to improve the performance of Transmission lines. It consist of…

Q: 3. Two circuit elements in series consume 60 VAR when connected to a 120 – V, 60 – Hz source. If the…

A: Total supply voltage = 120 V. pf is 0.6 . Input VAR = 60. Input watt = 60/tan(x). So watt = 60/tan…

Q: 1- Name the given circuit . 2- Find The PIV. 3- Find Current trough load resistance.

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: 2.A series R -L-C circuit is to be made resonance when connected to a 200 – volt 500 cycle source.…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function…

Q: Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an…

A: The given circuit isWe need to find The formula for the total impedance, Ztot.The formula for the…

Q: An inductor is attached to an AC voltage source. Which change will result in a halving of the…

A: Write the current in the circuit, it=vtZhere,Z= 2πfL A). if voltage will half and frequency will be…

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the output voltage…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: For the given data to limit 20Vrm

Q: A supply of 240V-50HZ feeds a highly inductive load of 502 througlH thyristor bridge that is…

A: The solution can be achieved as follows.

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the PIV of the…

Q: When a capacitor is discharged through a resistor, the discharge curve is exponential Sinusoidal…

A: Equation for discharging of capacitor is given by, v=voe-tΤ. Here, vo is initial voltage, v is…

Q: By convention, the sign of reactive power to an inductance is and the sign of reactive power to a…

Q: QUESTION 19 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in series. What is the…

Q: An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is…

A: (a) Write the given values. Vrms=22.2 VL=0.29 mHf=1 kHz

Q: the shunt capacitance is a capacitor O a. Between a phase and the ground O b. between phases and a…

Q: In a series LR circuit, the reactance of the inductance is 520 ohm. What will be the value of the…

A: If an inductor of inductance L H is present in a series circuit and if the frequency of the ac…

Q: Reactive Power Compensation Regulation, capacitive reactive power should not exceed what percent of…

A: Reactive Power Compensation Since the major load in power systems is an inductive load that…

Q: A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the…

A: In an AC-series R-C circuit, the impedance of C=10 μF capacitor is equal to R=47 Ω resistor. We need…

Q: Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a…

A: In this question, We need to choose the correct options What is power factor of the circuit. We…

Q: 15µF capacitor and a 470 ohm resistor are connected in series with a function generator. The supply…

Q: 1. What capacitance when connected in series with a 5000 resistor will limit the current drawn from…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Figure Q5 shows a parallel dipper circuit. Sketch the output waveform to for one 5. complete cycle.…

A: According to question: During positive half cycle when input voltage Vi<5.3V then the diode is…

Q: Due to mutual inductance between two coils, there is an induced emf in one coil due to a change in…

A: Answer:True

Q: In the given circuit, a step down transformer with an RMS voltage as 110V / 11-0-11 V is used with…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Q6) The waveform of the voltage obtained after rectification is of a -----nature and therefore…

A: AC signal has both positive and negative half cycle where as dc has only positive voltages.…

Q: An inductor and a 470 ohm resistor are connected in series with a function generator. The current is…

A: Given, Resistor and inductor are connected in series. Resistance (R)= 470 ohm Current flows…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A 50-microfarad is connected in series with a coil having 50 ohms resistance and 150 mH inductance. The source voltage is 100 sin (ωt – 120°) V. What is the maximum reactive power? Ans: ___ Var

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
List the five capacitor replacement rules.
Calibri (Body) -11 by AaBbCcDx AaBbCcD AaBbC AaBbCc AaB AaBbCc. mat Painter BIU 1Normal 1No Spaci. Heading 1 Heading 2 Title Subtitle Chang Styles d Font Paragraph Styles IMPEDANCE QUIZ # 2 1. What capacitance when connected in series with a 500Q resistor will limit the current drawn from a 48-mV 465-kHz source to 20µA? * a. 144pF b. 145pF c. 146pF d. 147pF MY ANSWER: c.146pF 2. What is the total impedance at 20kHz of a series circuit consisting of a 1.5mH inductance, a 100Q resistance, and a 0.08uF capacitance? * a. 1340 41.7 b. 1930 L-37.2" C. 920 290 d. 530 2-12.6°
I am getting the output of the clamper circuit wrong, how will this circuit be output ? circuit question : Set the input voltage signal to a sinusoid with 100 Hz frequency and 20V peak-to-peak amplitude with C=1μF. Obtain and plot the input and output voltage waveforms.
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
Please address the question in the attached photo. Thank you.
A 15µF capacitor and a 470 ohm resistor are connected in series with a function generator. The supply voltage is 50V RMS 40Hz. Find the reactive power for this circuit.
A supply of 240V-50HZ feeds a highly inductive load of 502 through thyristor bridge that is half-controlled. What is the load power factor when the firing angle delay is 45°? A. 0.6565 B. 0.5566 C. 0.6655 D. 0.5656 1igatio
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
the secondary voltage of the transformer of the circuit in the figure is Vs= 45 Sin wt volt, for a frequency of 60Hz. The diodes are silicon with Vd= 0.68 volts. Determine the value of the filter capacitor C1 so that the ripple voltage is not greater than 0.35 volts.