A 50 Hz, 2 pole turbo generator rated 100 MVA, 33 kV has an inertia constant of 4 MJ/MVA. If the mechanical input is suddenly raised to 70 MW for an electrical load of 40 MW, then the rotor acceleration is

A 50 Hz, 2 pole turbo generator rated 100 MVA, 33 kV has an inertia constant of 4 MJ/MVA. If the mechanical input is suddenly raised to 70 MW for an electrical load of 40 MW, then the rotor acceleration is

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter39: Synchronous Motor Operation

Section: Chapter Questions

Problem 14SQ: Induction motors and welding transformers require magnetizing current, which causes a. lagging power...

See similar textbooks

Related questions

Q: An ideal dc generator has regulation of 40% O 20% 30% O Zero

Q: Calculate the rotor reactance per phase of an 8 pole, 50Hz, 3Ø induction motor which develops a…

Q: A 4-pole DC generator has 1,000 turns on its rotor. It is being turned by a prime mover at 4,000 RPM…

Q: The voltage regulation of alternator can be regulated by changing its rotational speed. O True O…

Q: A four-pole induction motor drives a load at 2575 rpm. This is to be accomplished by using an…

Q: Problem #3: A 4-pole dc generator has 124 simplex lap coils each having two turns. The flux per pole…

A: In the question, Find the induced emf across the brush of DC machine?

Q: In a DC machine, the reversal of currentrom one direction to opposite direction is done by O…

A: In this we will write about reversal of current in dc machine....

Q: An isolated 50 Hz synchronous generator is rated at 15 MW which is also maximum continuous power…

A: An isolated 50 Hz synchronous generator rated at 15 MW, Droop=5%, Three loads of 4 MW each at 50 Hz,…

Q: A 25 MVA, 4-pole, 50 Hz turbo-alternator has an inertia constant H = 5 kW sec/kVA. The stored…

A: Given: A turbo alternator has, Power rating, S = 25 MVA Inertia constant, H = 5 kW sec/kVA

Q: If two 3-phase induction machines are mechanically coupled with each other. The two machines are…

A: The induction motors are coupled here mechanically. The speed will same for both machines because of…

Q: A 220V, 60Hz, 4 pole induction motor has a rotor power developed of 78KW and a rotor power input of…

Q: Calculate the rotor reactance per phase of an 8 pole, 50Hz, 30 induction motor which develops a…

Q: The power supplied to a three-phase induction motor is 20kW and the stator losses are 1000W. If the…

Q: small 4-pole generator with a six-turn rotor coil generates the following voltage wave: e = 169.706…

Q: AC Machine Fundamentals A three-phase Y-connected 60 Hz two-pole synchronous machine has a stator…

Q: Permanent-split capacitor motor is in effect a 2-phase motor and at no load could attain the…

A: True and false? Permanent-split capacitor motor is in effect a 2-phase motor and at no load could…

Q: Q3 A three-phase induction motor has the following data: 50 hp and V440 and 50HZ operating at full…

A: first calculate total active and reactive power before and after compensation . reactive power…

Q: two-pole dc generator is built with nine turns per coil, 48 coils, and is wave-wound. The field…

A: In this question we will find dc generator induced Emf ...

Q: A 6 pole DC lap wound generator has 41 armature conductors with flux per pole is 23 mWb and the…

Q: A 6 pole DC wave wound generator has 28 armature conductors with flux per pole is 23 mWb and the…

A: Given that A poles P = 6 DC wave wound generator Parallel paths A= 2 Conductors z= 28 flux per…

Q: tors with fiux per pole is 21 mwbD and the e m.f generated is 63 V, then the speed of the machine is…

Q: Electrical Machines A 4-pole single-phase induction motor is rotating in a clockwise direction at a…

A: Given- 4-pole single phase induction motor, Number of poles P=4, Frequency f=50 Hz, N=1000 rpm,…

Q: The generated or induced AC voltage is independent to the speed of the rotor. O True O False

A: Correct option is False we know they average Emf induced per conductor is (PFN) /60 volts Here P is…

Q: A single-phase motor is rated 5HP, 75% pf and 220V. What is the approximate size of capacitor needed…

Q: A self-excited DC generator delivers 10kW at terminal voltage of 250V. Its armature resistance is…

A: It is given that: Vt=250 VRa=0.2 ΩRf=50 ΩM=0.02 HPout=10 KW=10000 W

Q: A separately excited dc generator generates 230 V when driven at 1200 rpm of the field flux is…

Q: The rotor of a 4-pole ac generator is wound with a 200 turns coil. If the flux per pole is 5 mWb and…

A: Given: An AC generator with, Number of pole, P = 4 Number of turns, N = 200 Flux, φ=5 mWb Speed, Ns…

Q: A basic, single loop, 2 pole generator is rotating at a speed of 2160 RPM. The output frequency of…

A: In this question We need to choose the correct options What is frequency if speed and number of pole…

Q: Power available at the shaft of a 3-phase induction motor is calculated by Rotor output- Friction &…

Q: A basic one-loop dc generator is rotated at 60 rps. How many times each second does the dc output…

A: The frequency of the generator is given as: f=60rev/s The induced voltage for three rotations of the…

Concept explainers

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.

Question

A 50 Hz, 2 pole turbo generator rated
100 MVA, 33 kV has an inertia constant
of 4 MJ/MVA. If the mechanical input
is suddenly raised to 70 MW for an
electrical load of 40 MW, then the rotor
acceleration is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

please help asap
The rotor of a 4-pole ac generator is wound with a 200 turns coil. If the flux per pole is 5 mWb and the rotor runs at a speed of 1500 rpm, the rms value of the induced voltage for this AC generator is nearly?
The voltage generated across one inductor of an alternator is 8.11V. There are 120 slots and 4 turns in every coil. The conductors are all in series and connected in double layer lap windings distributed sinusoidally in several slots. The coil pitch is 10 slots, frequency is 60 Hz and synchronous speed is 720 rpm. Calculate the line-to-line generated voltage if the alternator windings are connected wye.
Please i want the answer son as possible
The shaft of a three-phase synchronous generator is rotating at 1500 RPM synchronous speed. This generator is supplying a load of 15.2 KW, 0.8 PF lagging, with an efficiency of 83.5 %. The copper losses are neglected. Calculate the sum PF&w + Pcore + Pstray , and the induced torque by this generator. Select one: O a. PF&w + Pcore + Pstray = 3003.6 W, and Tind = 92.3 N.m. O b. PF&w + Pcore + Pstrav = 3597 W, and tind = 104.9 N.m. O c. PEgw + Pcore + Pstray = 2508 W, and tind = 104.9 N.m. O d. PF&w + Pcore + Pstray = 2508 W, and tind = 92.3 N.m. O e. None
A synchronous generator has 12 slots per pole. If each coil spans 7 slot pitches, what is the value of the pitch factor ? Answer
A sinusoidal flux 0.2Wb (max) links with 55 turns of a transformer secondary coil. Calculate the r.m.s. value to the induced emf in the secondary coil. The supply frequency is 60Hz.
A synchronous generator runs at 250 rpm and generators at 60HZ. There are 240 slots each containing 5 conductors arranged in full-pitched winding for three-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load distributed sinusoidally over the pole pitch is 2.5 x106 Maxwell. What is the emf induced in each winding and the terminal voltage?
Find the rms value of the induced emf per phase of a 10 pole, three phase, 50 Hz alternator with 2 slots per pole per phase and 4 conductors per slot in two layers. The coil span is 150°. The flux per pole is 0.12 Wb (a) 994 (c) 1020 53. (b) 864 (d) 960
The shaft of a three-phase synchronous generator is rotating at 1800 RPM synchronous speed. This generator is supplying a load of 16.5 KW, 0.8 PF lagging, with an efficiency of 85 %. The copper losses are neglected. Calculate the sum Pf&w + Pcore + Pstray , and the induced torque by this generator. Select one: O a. None O b. PF&w + Pcore + Pstray = 2475 W, and tind = 87.5 N.m. c. PE&w + Pcore + Pstray = 2911.7 W, and tind = 87.5 N.m. O d. Pf&w + Pcore + Pstray = 2475 W, and tind = 102.9 N.m. O e. Pfgw + Pcore + Pstray = 3425.5 W, and tind = 102.9 N.m. Clear my choice
Calculate the r.m.s. value of the induced e.m.f. per phase of a 10-pole, 3-phase, 50Hz alternator with 2 slots per pole per phase and 4 conductors per slot in two layers. The coil span is 150°.the flux per pole has a fundamental component of 0.12Wb and a third harmonic component.
A 50 Hz alternator stator is delta connected with each winding having 40 turns of wire. The rotor is supplying 0.148 Wb of flux in the center of the pole face. What is the RMS value of the output voltage if the measured line to neutral