A 5 μF condenser is connected in series with a coil having inductance of 50 mH. If a 50 V source operating at resonance frequency causes a circuit current of 10 mA. What is the Q factor of the coil. (upto 2 decimals) A B 0.01-0.03 0.014-0.031 0.017-0.036

A 5 μF condenser is connected in series with a coil having inductance of 50 mH. If a 50 V source operating at resonance frequency causes a circuit current of 10 mA. What is the Q factor of the coil. (upto 2 decimals) A B 0.01-0.03 0.014-0.031 0.017-0.036

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Draw the output waveform of each circuit in Figure. Assume the RC time constant is much greater than…

Q: You read 10 Vpk on the oscilloscope across a resistor in a series RC circuit. With a 15 Vpk AC…

A: Current in resistor and capacitor is same as thay are connected in series with each other. Take…

Q: A 70 capacitor is connected in series with a coil with an ohmic (effectiv resistance of 4 Q and an…

Q: a student is doing work on circuit in which he employs a voltage af 60 sin(314t+60) by observing…

A: The form factor of an AC sinusoidal wave is the ratio of RMS value of the wave to average value of…

Q: 6mh inductor and a 0.001uf capacitor are placed in series. Calculate the impedance at 100 MHz.…

Q: Calculate the total current in the circuit below if the circuit is powered by the sine wave voltage…

Q: 7- Determine the current direction in each of the following coils: TI S A S quib-

A: for the given coils that would around a iron bar it is asked to find the current direction

Q: Refer to the figure, find the mesh currents (a) I1, (b) I2, and (c) I3.

A: The given circuit is shown as,

Q: 24. What is the impedance of a series combination of a 50-2 resistor, a 5.0-uF5.0-µF capacitor, and…

Q: How many H must the inductance L be for the reactive power to be zero in 1. the circuit in the…

A: Circuit diagram is given as,

Q: what is the DTFT of sin(n)/n

Q: 2.A series R -L-C circuit is to be made resonance when connected to a 200 – volt 500 cycle source.…

Q: degree. modulating voltage change by During AM, the phase angle of the

A: AM refers to the amplitude modulation

Q: An AM modolation Wave form Signal Ooy's Cos 10000 Tt 8+ 4Cos 1000 Tnt + 4 Cos 2000 TC t) %3D )…

A: We need to analyse the given amplitude modulated signal .

Q: If whole number ratio in Lissajous pattern is Nx:Ny=2:3 and fx=1kHz, then fy= 666.667 Hz O 1.5 kHz…

Q: Define the following terms for an series RLC circuits a. Resonant frequency b. Power factor C.…

A: In the given questions we need to discuss about the resonant frequency, Power factor and phasor…

Q: For an inductor in a sine-wave ac circuit, VL lags iL by 90 VL and iL are in phase VL leads iL by…

Q: What is the phase angle between voltage and current in a series cuircuit consisting of an…

A: In this question, We need to determine the phase angle between voltage and current in series RL…

Q: 02 : For two of the following networks DRAW the Labled V. ED 4 Ge 0V: Comnlete design as required…

A: It is simple diode circuit .diode will be ON in forword direction .

Q: What is (j205-j307+j47)-1

A: Given data: X=j205-j307+j47-1

Q: Q5) the following waveform is the inductor current of the boost converter, the ripple current is…

Q: Q.9) Analyze the following astable circuit. Draw the wave forms V. Va . Not gate Do Not gate Vo R-…

A: Initially the capacitor will charge and when the capacitor will be fully charged no current will…

Q: iangular waveform with a peak-to-peak voltage of 2 V and a period of I ms is applied to 10. the…

Q: Handbes lit odi dguou odboot avidson H.W: od vd babiv R₂ = Re A Wien Bridge Oscillator circuit is…

Q: Choose correct answer Inductance of the coil is given by a. L = NΦ / T b. L = IΦ / N c. L = NΦI d. L…

A: inductance of the coil given by L= N∅I WHERE, N=NUMBER OF TURNS IN COIL ∅=FLUX

Q: If a millivoltmeter is having a coil with a temperature coefficient of 5 mO/C, then the compensation…

A: The solution is provided in the following section:

Q: . A coil has an impedance of 75.4 when connected a across a source of 60 Hz. The same coil yields an…

A: In this question we need to find the inductance of coil

Q: Determine all values of resistors and capacitor for the triangular waveform generator whose output…

Q: The frequency of the induced emf in an induction motor is Greater than the supply…

A: The frequency of induced emf depends on the rotor frequency of the induction motor. The slip vale is…

Q: Given the following apparent power, what is the reactive power, in VAR? S = 2-4.2j VA

Q: 3) Pure Inductance in Series Frequency = 60HZ EL1 = E2 = E13 = %3D ET = 2kV

A: Redrawing the circuit by marking the current and the voltages in the circuit:

Q: for the circuit shown below: The upper reference threshold 10v vin 5 simwt 02.5 O-2.5 02.4 O-2.4…

Q: A load has 50 kw active power with 0.8 power factor to make load power factor with 0.9 power factor.…

A: Given values are - P=50kWcosϕ1=0.8cosϕ2=0.9

Q: The transient reactance is smaller than the subtransient reactance.

A: According to the question we have to explain about the given statement is true or false. the given…

Q: Home worlc: Sketch the single side spectrum for the same funetion. フム 16

A: Single sided spectrum:

Q: Find the average value of the voltage in the figure m 5V ov+ O 1.59 V O 63.7 V O 6.37 V O 10.5 V

A: Given a waveform Asked to find average value of the voltage Maximum value(Vm) = 5V

Q: A 16 Voltage is applied to the circuit with a 47 ohms resistor connected in series with a 10uF…

A: Value of load resistance Value of capacitance Frequency is given as f = 500 Hz Voltage applied to…

Q: Determine: a) the phase angle of any harmonic components present (relative to the fundamental).

A: Given: Waveform equation: V=100sin(100πt)+50sin(200πt)

Q: Two inductors, one with an inductive reactance of 10 Q, and the second with an inductive reactance…

A: Given two parallel connected inductor having inductive reactance, XL1=j10 ΩXL2=j20 Ω

Q: A reactor of resistance 50 ohms and inductance of 150 mH is connected in parallel with a capacitor,…

A: Condition for resonance is capacitive reactance should be equal to inductive reactance. So,…

Question

A 5 μF condenser is connected in series with a coil having inductance of 50 mH. If a 50 V
source operating at resonance frequency causes a circuit current of 10 mA. What is the
Q factor of the coil. (upto 2 decimals)
A
B 0.014-0.031
C
0.01-0.03
D
0.017-0.036
0.019-0.032

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data:

VIEW

Step 2: Determining the quality factor:

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

27
Find the resistance in the RL circuit of Figure 23-23, given that the inductance is 0.15 H andthe characteristic time is 6.2 ms.
12V Ealculate Ve (B- 150). SV 100
An RLC series circuit has a power factor of 84%. The resistor has a voltage drop of 96 volts. What is the total voltage applied to the circuit? 10giaton0o of 18. 0 The inductor has an induc-
YOUT HI Determine Vout for the following circuit if VIN-12VRMS, the applied frequency of the voltage source is F= 122Hz, R-78092 and C=0.0000015517F Note: Round your answer to 4 decimal places Answer:
28. A tuning coil of negligible resistance is to limit the current through it to a 50 mA when 35 V is applied across it at 500 kHz. Find its inductance.
A 22 nF capacitor C and a 4700 ohm resistor R are connected in series to an ac signal generator. The generator frequency is adjusted so that the voltage amplitude across both R and C is equal. This occurs at O 0.65 mHz O 1.539 kHz O 1.539 MHz O 213.6 Hz
What frequency components are seen at the Adder output in the figure?
Question 3 A step-up chopper has input voltage of 225 V and output voltage of 385 V. If the non- conducting time of thyristor is 60 µs, compute the pulse width of output voltage. In case the pulse width is 3/4th for constant frequency operation, find the new output voltage.
If the voltage per division on the Scope screen shown below is set to 100mV/div, what is the peak-to-peak magnitude of the voltage? O a. 200.0 mV cross out O b. 50.0 mV cross out O c. 300.0 mV cross out O d. 150.0 mV cross out O e. 600.0 mV cross out
9. For the following circuit, determine either the phase lead or phase lag degrees (determine which one it is) as well as the output voltage for the following frequencies. a) 1 Hz b) 150 Hz c) 800HZ d) 6KHZ R= 4K. C-0.04uF Vour- 0.22
Determine the angular frequency of oscillation for a resistor, inductor, capacitor (RLC) series circuit