A 5-liter flask contains nitrogen (N2) in the gas phase at 3 bar and 90 ° C. Through a process at Constant volume cools down to 30 ° C. Calculate the following: a) Number of moles of N2 inside the flask. Consider N2 as an ideal gas b) I calculate the heat removed for the cooling of N2 contained in the flask

Q: A sealed 10-liter vessel contains a certain amount of ethanol. The vapor density above the liquid is…

A: Enthalpy change of vaporization is calculated by calusius clapeyron equation :

Q: What does not correspond to the molar heat of fusion?

A: According to the first law of thermodynamics, the total heat change of a system at constant pressure…

Q: Suppose 10.0g of dry ice (solid CO2) were placed in an empty 400mL steel cylinder. What pressure…

A: Mass of CO2 = 10 g Molar mass of CO2 = 44 g/ mol R= 0.082 L atm mol-1K-1 Temperature = 35° = 308.15…

Q: energy is removed from sample?

A:

Q: What amount of heat (in kJ) is required to convert 16.1 g of an unknown liquid (MM = 83.21 g/mol) at…

A: Answer:- This question is answered by using the simple concept of calculation of heat required using…

Q: Calculate the heat, in kJ, exchanged in the conversion of 20.0 g of steam at 104 °C to water at 10.5…

A:

Q: Give typed solution Calculate the amount of energy in kJ used when 33.3 g of ice at 0.0 deg C is…

A:

Q: Gases produced by a chemical reaction can easily be collected over water. To determine the pressure…

A:

Q: Calculate the ASsys when 15.0 g of ice at -12.0 °C is converted into water vapor at 105.0°C and at a…

A: Answer:

Q: Why must boiling points be corrected for barometric pressure? Explain.

A:

Q: What is the partial pressure of CO2 at 468.2 K in a 25.0 L fuel combustion vessel if it contains…

A: Since we need to find only the partial pressure of CO2, therefore we only need to consider its…

Q: A phase diagram shows the states of a substance as a function of and pressure; volume volume;…

A: The correct option has to be identified.

Q: What amount of heat (in kJ) is required to convert 13.0 g of an unknown liquid (MM = 83.21 g/mol) at…

A: Answer

Q: It was determined that 63.5 kJ of heat is needed to vaporize enough aniline (CsHsNH2) liquid at its…

A: First of all, we need to calculate the number of moles of aniline which is vaporized. Volume of…

Q: a)What is the heat capacity of liquid n-hexane at 48.0C ? b) What is the heat capacity of gaseous…

A:

Q: An autoclave is used to sterilize surgical equipment. Itis far more effective than steam produced…

A: In autoclave, the sterilization process is done using high pressure and steam, which kill…

Q: a 31.7-g sample of water at 300. K is mixed with 50.8 g water at 320. K. calculate the final…

A: The temperature of 31.7 g of a water sample is = 300. K The temperature of 50.8 g of a water sample…

Q: 1. Mass of flask, foil, rubber band 66.3842_ g 2. Temperature of boiling water 95.60 wou 3.…

A: Acc. to Ideal gas Equation P*V = n * R *…

Q: Why is it important that the heat capacity, latent heat of fusion and latent heat of vaporization of…

A: Heat capacity is the anount of heat required to  increase a particular amount of the substance.…

Q: The following is a table of water vapor pressure in millibar (mbar) vs Temp in °C. In your own…

A: We are given the vapor pressure of water in mbar at different temperature(oC) values in increasing…

Q: If 42.0 kJ of heat is added to a 32.0-g sample of liquid methaneunder 1 atm of pressure at a…

A: Since the heat added is very high (42000 J). And since the temperature of the methane was already…

Q: true or false The heat of fusion of Au at constant pressure is approximately equal to the heat of…

A: This question is related to the thermodynamics. The given statement is in regard to the relation…

Q: 7. In a 6.00 L pressure cooker, water is brought to a boil. If the final temperature is 115 °C at…

A: Formula: PV = nRT Where, P = pressure in bar             V = volume in L             n = number of…

Q: The following liquids have about the same molar mass. The vapor pressure of each was measured in the…

A: Stronger the intermolecular forces of attraction , more is the boiling point.

Q: fountains, an explorer notes that the water for tea is boiling vigc table below to estimate the…

A: High in the mountains, an explorer notes that the water for tea is boiling vigorously at a…

Q: A 0.1586-g sample of aluminum-zinc alloy is placed in the same apparatus that was used last week.…

A: Given:  Volume of H2 is produced = 106.5 ml = 0.1065 L Temperature of the beaker = 21°C = (21+273) =…

Q: The phase diagram below is that of Au-Ag system. 1100 1050 1000 950 900 960°C 0 10 20 30 L 2 L+a 50…

A: The objective of this question is to calculate the maximum temperature at which a 90% gold alloy…

Q: The following is a table of water vapor pressure in millibar (mbar) vs Temp in oC.  In your own…

A: We are given the vapor pressure of water (in mbar) at different temperature values in increasing…

Q: A certain liquid has a vapor pressue of 476.0 torr at 35.0°C and a vapor pressue of 700.0 torr at…

A:

Q: Determine enthalpy of vaporization graphically using the Clausius-Clapeyron equation. The vapor…

A: (a) The Clasius-Clapeyron equation for the liquid-vapor boundary is    is the enthalpy of…

Q: A heating curve of one gram of a pure solid at 1 atm is shown to the right. Which factor affects the…

A: A pure solid is heated. In the given heating curve, Segment AB represents all solid (heat is…

Q: Use the observation in the first column to answer the question in the second column. oft observation…

A: Enthalpy of vaporization is the amount of heat required to convert liquid into gas. Vapour pressure…

Q: What is the heat energy required to change 10 grams of liquid water at 0ºC to 100ºC?

A: Given,  Mass of liquid water= 10 grams Initial temperature= T1= 0 °C Final temperature = T2 = 100 °C…

Q: The following information is given for silicon at 1 atm: Th=2355.00°C Tm 1410.00°C Specific heat…

A: Amount of heat needed can be calculated by summation of heat needed for the individual conversions.