A 4-ft diameter spherical tank is subjected to an internal pressure of 34 psf. If the wall thickness is 0.33", determine the tangential stress of the wall in psi.

Q: 00 0 021 0 043 0 25 0 1280

A:

Q: Which percentile is typically for designing lower-limit dimensions? - 95th 5th 50th 99th

A:

Q: Compute Ix (I sub x, in inches4, round-off to 2 decimal places) for the region shown.

A:

Q: 10) in the following figure, if h2-10" and h1=5", then, the angle of taper equal 10" Ⓒa. 60⁰ Hand…

A: These are small blocks of alloy steel. Used in the manufacturing shops as length standards. Not to…

Q: What are the two dimensions that are not placed on the field of a drawing? A zero and a 45 degree…

A: The following things needs to be mentioned on the field of drawing: ◆ The diameter or radius of…

Q: Problem 1: a) Draw the free body diagram of the member ABC? b) Determine the reaction forces at the…

A:

Q: Draw the front, Side and top

A: We need to draw three orthographic projection views.

Q: why is the angle 26.56 and then you use 22.56

A:

Q: 20 30 R15 5-Ø10 R10 Ø40 10 40 40 Figure 1

A:

Q: In the following figure, add the largest equal coordinate tolerances so that if two parts are…

A: Maximum distance between mating hole centers, d = 0.5 mmLets assume the equal coordinate tolerance…

Q: What is the precision measurement of 1 7/8 inch

A: PRECISION IS DEGREE TO WHICH REPEATED MEASUREMENTS UNDER THE SAME CONDITIONS SHOW THE SAME RESULTS.

Q: Determine smaller diameter, All dimensions are in mm) 110.916 091 S 100.916 80.916 mm cant be…

A: The smaller diameter is 80.916 mm.

Q: how does the angle alpha make the angle with t

A: This question is based on the concept of force and Free body diagram

Q: Express the results of the following multiplications and divisions to the proper number of…

A:

Q: is 60 left or right?

A: The horizontal reaction at A: 60 kN (Right)......(Option D)

Q: elow are incomplete views of the parts or figures. Complete them by drawing the lines of…

A: According to the given dataAn orthographic projection view is given.We need to findmissing view of…

Q: Find the angle Ɵ for the given figure

A: Given: To determine: The angle θ

Q: The horsepower (hp) that a shaft can safely transmit varies jointly with its speed (in revolutions…

A:

Q: Give the horizontal and vertical distances from the upper left corner of this part to the center of…

A: The depth and dimension for the slot is 0.243 and for chamfer 0.089 depth. Hole A X…

Q: question: The degrees of freedom of the calculation package in the figure?

A:

Q: need help finding dimension x and y in the casting shown 2.80 cm 5.20 cm 6.00 cm 2.50 cm E 7.20 cm

A: Draw a diagram for the given problem.

Q: Determine larger diameter, for the figure below. All dimensions are in mm) 110.916 Ø40 091 108.517…

A: The larger diameter is 130.916 mm.

Q: Create a table showing wrench sizes in metric and U.S. units.

A: Following are the wrench sizes in metric and U.S. units.

Numerical Calculations

In the mid-20th century, the availability and the growth in power of digital computers led to the increase in the mathematical model in the field of engineering and science. The analysis of these detailed models needs to be increased.