A 30 m. tape was standardized and was found to be 0.0022 m. too long than the standard length at an observed temperature of 55 deg Celcius and a pull of 15 kg. The same tape was used to measure a certain distance and was recorded to be 670.89 m. long at an observed temperature of 64 deg Celcius and a pull of 15 kg. Coefficient of linear expansion is 0.0000116/deg Celcius. Determine the total correction.

A 30 m. tape was standardized and was found to be 0.0022 m. too long than the standard length at an observed temperature of 55 deg Celcius and a pull of 15 kg. The same tape was used to measure a certain distance and was recorded to be 670.89 m. long at an observed temperature of 64 deg Celcius and a pull of 15 kg. Coefficient of linear expansion is 0.0000116/deg Celcius. Determine the total correction.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q3. When a fluid flows over a surface, the shear stress 7 (N/m²) at the surface is given by the expression du t = μ₁ dy surface where is the viscosity (Ns/m²), u is the velocity parallel to the surface (m/s), and y is the distance normal to the surface (cm). Measurements of the velocity of an air stream flowing above a surface are made with an LDV (laser Doppler velocimeter). The following values were obtained: y 0.0 1.0 2.0 3.0 0.00 55.56 88.89 100.00 u 4.0 111.56 At the local temperature, µ = 0.00024 Ns/m². Calculate (a) du / dy at the surface based on third order polynomial, (b) the corresponding values of the shear stress at the surface, c) the shear force acting on a flat plate 10 cm long and 5 cm wide.
As fast as possible ??
please answer the question in the picture with complete and accurate solution.
In Figure below if a metlic c:ube of a 1 2 inch side length weighing 46 kg, floats at a two layer fluids mercury and sea water. Detennine the position of the block at mercury- water interface when it has reached equilibrium. (mass density of sea water ; 63.92623 lb/fts) and for mercurv : 845 lb/ftS).
I need the answer as soon as possible
This subject is Surveying Lecture. Show your solution step by step
SITUATION: A steel tape with coefficient of linear expansion of 0.0000116 per °C is known to be 50 m long at 20°C. The tape was used to measure a line which was found to be 532.28 m long and when the temperature was 35°C. Zoom image Find the temperature correction for the measured line. 0.0691 0.0861 O 0.0816 0.0619
(a) What is the dimension of an area moment of inertia?(b) If the thickness of a piezoelectric cantilever beam increases, does the natural frequencyincrease or decrease?(c) Both the thickness and width of a piezoelectric cantilever beam can change the natural frequency. Which parameter (thickness or width) will lead to the natural frequency change more significantly? Briefly explain your answer.
A line was found to be 2,395.25 m long when measured with a 30 m tape under a steady pull of 3 kg. at a mean temperature of 30°C. The tape was held in the air and supported at both ends and at every one third of the tape. Determine the correct length of the line if the tape used is of standard length at 20°C under a pull of 5 kg. Assume the cross-sectional area of tape to be 0.02 cm2, Elastic Modulus as 2.10 x 106kg/cm2, weighs 0.05 kg/m, and a Coefficient of Thermal Expansion to be 0.0000116/°C.
3)
I need the answer as soon as possible
Please refer to the figure below. Determine the magnitude of the resultant couple at point D in Ib-ft. 20 1ы 200 kg 250 N 20 kN m 2 FT 200 kg