A 3-phase, Hz, 5 km lon supplies 475 kW at 22 kV, 0.6 p.f. lagging. Tl line resistance is 4 2 per phase and line inductance is 10 mH per phase. Calculate th Reactance of the Line, Current flowing throu the transmission line, Sending end voltage, Voltage regulation and Efficiency of transmission. Inductive Reactance Current flowing through the transmission lin

A 3-phase, Hz, 5 km lon supplies 475 kW at 22 kV, 0.6 p.f. lagging. Tl line resistance is 4 2 per phase and line inductance is 10 mH per phase. Calculate th Reactance of the Line, Current flowing throu the transmission line, Sending end voltage, Voltage regulation and Efficiency of transmission. Inductive Reactance Current flowing through the transmission lin

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

If value of voltage Vs is 20kv and VR is 15 kv with load angle of 20 degrees. Value of line reactance is 5(ohm) Find value of active power and reactive power at receiving end of line.
A 3-phase, 60 Hz, 20 km long overhead line supplies 525 kW at 11 kV, 0.6 p.f. lagging. The line resistance is 5.5 per phase and line inductance is 10 mH per phase. Calculate the Reactance of the Line, Current flowing through the transmission line, Sending end voltage, Voltage regulation and Efficiency of transmission. Inductive Reactance Current flowing through the transmission line Sending end Voltage Voltage Regulation of Transmission line Transmission line efficiency
Q3) A balanced 3-phase load of 30 MW is supplied at 132 kV, 50 Hz and 0-85 p.f. lagging by means of a transmission line. The series impedance of a single conductor is (20 + j52) ohms and the total phase-neutral admittance is 315 x 10-6 Siemen. Using nominal T method, determine sending end voltage.
e r:EE • Ooredoo I. moodle.nct.edu.om a Question T Not answered Marked out of 4.00 P Flag question A 3-phase, 60 Hz, 50 km long overhead line supplies 575 kW at 11 kV, 0.8 p.f. lagging. The line resistance is 4.5 Q per phase and line inductance is 10 mH per phase. Calculate the Reactance of the Line, Current flowing through the transmission line, Sending end voltage, Voltage regulation and Efficiency of transmission. Inductive Reactance Current flowing through the transmission line Sending end Voltage Voltage Regulation of Transmission line Transmission line efficiency + 7
A 3-ph, 60 Hz, 200 km long, 220 kV transmission line has per km per phase constants of resistance 0.033 Ω, inductive reactance 0.33 Ω, capacitive susceptance 3.3x10 -6 mho. The load at the receiving end of the line is 500 MW at 0.95 power factor leading and voltage has dropped to 209 kV. Using the PI model, calculate the voltage, current and power factor at the sending end. Please answer in typing format solution please only typing format Please I will like it please reply to
[Ans. 0.174 HF) A three phase 50 Hz fully transposed line has conductors equilaterally spaced at 3 metres. The conductor diameter is 3 cm. Determine the capacitance to neutral per km per phase. (Gorakhpur Univ. Transmission of Electric Power 1975] [Ans. 0.0105 µFI - UI
Problem 1 a- Explain the meaning of the term "bundle conductor transmission line" and discuss the effects of its use on the electrical performance of a high voltage electric transmission line. b- Consider an experimental 1800 kV three phase bundle-conductor line with parameters A= 0.95 and B=j 70. Determine the value of the parameter C of the line. Assume that the line is delivering 2,000 MVA at receiving end whose voltage of 1750 kV and unity power factor. Determine the sending end voltage of the line. d- C- Determine the sending end current of the line.
Question 1) A 154 kV transmission line has a length of 100 km. The line and the conductors are given in Figure 1. The line is operated at f= 50 Hz. For both old and new lines calculate; a. GMD and GMR. b. Inductance of the line in Henries (H). c. Series Impedance (Z) of the line in Ohms. d. *Compare the results for both lines and comment on the results. e. *If the distance between the two neighbouring conductors is increase from 13 meters to 15 meters what would be the parameters in part a.,b. and c. comment on the results. New Line's Conductors 13 m 13 m Old Line's Conductors d r = 2 cm d = 40 cm r = 2 cm Figure 1
A 3-phase overhead transmission line is being supported by three disc insulators. The potentials across top unit and middle unit are 9 kV and 11 kV respectively. Calculate: a. The ratio of capacitance between pin and earth to the self-capacitance of each unit. b. The line voltage. c. String efficiency. JAns: a. 0.22 b. 35.444 kV c. 76%]
A three-phase transmission line and a telephone line are supported on the same towers a shown in the figure. The power line carries a 60-Hz balanced current of 200-A per phase . the telephone line is located directly below phase b. assuming balanced three-phase currents in the power line, find the voltage per kilometer induced in the telephone line. 3.6 m 3.6 m Dal Da2 Del De 4 m 11.2 m-
H. W.: A 3-phase overhead transmission line is being supported by three disc insulators. The potentials across top unit and middle unit are 9 kV and 11 kV respectively. Calculate: a. The ratio of capacitance between pin and earth to the mutual capacitance of each unit. b. The line voltage. c. String efficiency. [Ans: a. 0.22 b. 61.35 kV c. 76%]
Assuming the voltage at the utility bus is 13.5 kV and the PV plant supplies 4.8 MW of power at 0.95 power factor lagging. Draw the diagram of the system and determine i) the per-phase voltage and current at the POI at the PV plant ii) the reactive power delivered and that which is lost in the line. Assume the line is modelled as a short line.