A 3 phase AC motor is operating at no load. A three equal power factor correction capacitors are connected in parallel with each phase of voltages supplied of the motor. The magnitude of Q of the power factor correction is equal to the magnitude of Q of the motor. What is resultant power factor? O Neither leading nor lagging. O Lagging O Leading

A 3 phase AC motor is operating at no load. A three equal power factor correction capacitors are connected in parallel with each phase of voltages supplied of the motor. The magnitude of Q of the power factor correction is equal to the magnitude of Q of the motor. What is resultant power factor? O Neither leading nor lagging. O Lagging O Leading

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In DC machines the number of parallel paths for a wave winding generator is Select one: O a. Three O b. Two OC. Half the number of poles O d. Equal to Number of Poles
The frequency of rotor current in an induction motor is slip times the frequency of stator current. slip times the frequency of supply, One by slip times the frequency of stator current. One by slip times the frequency of supply
and t A common base of 100 MVA and 25 KV is selected. What is the current base (Ig) Select one: O a. 4 KA O b. None of these O c. 6.25 kA O d. 2.309 KA A 100-MVA, 60-kV, three-phase synchronous generator has a synchronous reactance of armature resistance. The generator is operating with an excitation per phase E= 47.116 power before losing synchronism (stability limit). and the armature c Thus, the maximum generated power is Pmax =
V1 = 170 V f1 = 100 Hz 1) A single-phase load has an active power of P = 2 kW at V1 V @f1Hz and the power factor is cosφ = 0.75. This motor is compensated to cosφ = 0.85 using a parallel capacitor current before compensation?
Full solutions for the question with explanation
Please solve this problem step by step and illustrate your answer properly. Write your answer in a piece of paper please. Box the final answer.
10- What is the ratio of rotor input power to rotor copper loss in an induction motor? a) 1/(1-S) b) 1 - S c) 1/S d) S 11- If the frequency of 3-phase supply to the stator of a 3-phase induction motor is increased, then synchronous speed a) Increased b) Decreased c) Remain unchanged d) None of the above
ICua_RWaUpXC0w/ -------Source and its rotor trom 26 Hz source. The motor will run at الاجابة تكون بكتابة رقم صحيح و يدون وحدات * (2) ihi The efficiency of the 1 phase induction motor could be better increased-4 * by adding a permanently capacitor in series with the starting winding O adding a permanently 2 capacitors in series with the starting winding none of the mentioned all the mentioned O 4 2aio عدم إرسال كلمات المرور دبر نماذج Go ogle مطلقا. A e University of Basrah J
In a three-phase induction motor the maximum torque occurs at 20% slip and the equivalent resistance of the secondary is 0.04Ω per phase. Find the equivalent load resistance and the load voltage and the load current. Output power is 20 kW.
65. A three-phase, 440 V, 60 Hz supply is connected to a three-phase, wye-connected induction motor and synchronous motor. The impedance per phase of the induction motor is (1.5 + j2.5)N. The synchronous motor is over-excited and draws 100 A at 0.8 power factor. What is the combined power factor of the load? A. 0.99 lagging B. 0.99 leading C. 0.51 lagging D. 0.51 leading
In a synchronous generator, a DC current is applied to the rotor windingList two advantages of this arrangement.
3.4 The rotor power output of 3-phase induction motor is 15 k. The rotor copper losses at a slip of 4% will be (a) 600 W (c) 650 W (b) 625 W (d) 700 W