A 2kW stainless-steel electrical kettle with capacity 2 liters is used to obtain steam from tap water. The ambient temperature of the water is 20°C, heat of vaporization of water is 2256 kJ/kg and specific heat coefficient of water is 4287 J/kg°C. Thermal resistance of the kettle is 10W/°C. a. How long it will the water to reach the boiling temperature? b. How long it will take to obtain 500 g steam?

A 2kW stainless-steel electrical kettle with capacity 2 liters is used to obtain steam from tap water. The ambient temperature of the water is 20°C, heat of vaporization of water is 2256 kJ/kg and specific heat coefficient of water is 4287 J/kg°C. Thermal resistance of the kettle is 10W/°C. a. How long it will the water to reach the boiling temperature? b. How long it will take to obtain 500 g steam?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

5- Determine the mathematical expressions for current and voltage of capacitor following the closing of the switch. Draw the voltage and current curve. $1 R2 Hilt Vs 20 V 4KQ w R3 10KQ R1 w L C
What is the commercial status of the different types of solar thermal systems? (150 words)
We measured the current that appeared on the plotted screen as shown in the figure by means of three different ammeters connected in a row, the first of the de Ersteval type, the second of the moving iron type, and the third of the type equipped with a rectifier bridge. Find the reading of each scale, then find the percentage of error in the measurement if the scales are for measuring sine values النيار MA T AM 1 الزمن t
Match The following. Energy derived from organic waste Choose. Energy from interior of earth Choose.
Discuss the prime mover and the conversion of power energy for thermal station
explain in a summarized form the procedures for the calculation of elements for the construction of a PROTOTYPE OF PIEZOELECTRIC TILE FOR THE GENERATION OF ELECTRIC ENERGY THROUGH THE PEDESTRIAN TRAFFIC
2. Choose at least 3 different types of water heater, provide description and illustration.
low voltage systems An AG 1 heater has 230 V and 10 kW on its label. So which of the following shows the 230 V value? a) Effective Voltage b) Maximum Voltage c)Peak Voltage d) Average Voltage
Nichrome wire is used in some radiative heaters. What length of Nichrome wire, having a cross-sectional area of 5.00mm2, is needed if the operating temperature is 500oC ?
Consider the circuit shown in figure 2-8. the circuit operates at 60 hz, the rms of the voltage is 120 volts, the resistor has a value of 40 ohm, the inductor is 0.1592 H, and the capacitance is 33.16 UF. a) Find the impedance of the inductor and the capacitor. b) Find the current in each leg of the circuit and the total current from the source. c) Draw a phasor diagram showing the source voltage and all the currents. d) Find the total impedance of the RLC parallel combination
A soldering iron is rated at 50 watts when connected to a 250 V supply. If the soldering iron takes 5 minutes to heat to a working temperature of 190°C from 20°C, find its mass. assuming it to be made of copper. Given specific heat capacity of copper is 390 J/kg°C
Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the condensers are disconnected, how much energy can the charged condensers provide if connected across each other with like polarities together? Ans. 0.052 J