A 250-Q resistor and a 4-µF capacitor are connected in series across a sinusoidal a.c. supply for which the angular frequency o is 1250 rad/s. The only other component connected across the supply is a 200-2 resistor. The supply voltage is 64 V r.m.s. 26. Calculate the total current drawn from the supply in amps. A 0.64 В 0.58 С 0.52 D 0.49 27. Calculate the phase angle between supply voltage and supply current in degrees.

Q: For the following circuit, if BDC =200, the value of IC is Vee +15 V Rc 4.7 kf R 47 k RE 10 k VEE…

A:

Q: Given circuit The maximum values are determined as, Vos = 25 V Ves = 25 V Ves-OFF = -4 V Small…

A:

Q: Lp = 50 mH ell N₂=20 N₁ = 80 ell L k=0.8

A: To find:Find the value of Ls, for the given mutual inductance.

Q: Question 13 For the circuit shown, the following mesh currents are given: IA = 1.24Z71.2° A IB =…

A:

Q: QUESTION 1 A 1µF capacitor, a 150mH ideal inductor, and a 1.2k ohm resistor are connected in series…

A:

Q: QUESTION 14 A 900NF capacitor, a 200mH inductor and an 8200 resistor are connected in parallel with…

A:

Q: Determine the maximum peak-to-peak ripple current of previous problem by using the next equations,…

A: To determine the maximum peak-to-peak ripple current ((Imax​)), we can use the given equations.…

Q: The circuit below has values: VT = 120 Vac, f = 24.595 kHz, L1 = 130 mH, L2 = 132 mH, and L3 = 214…

A: The given circuit is a series connection of three inductors.The inductive reactance of the inductor…

Q: The circuit below has values: VT = 120 Vac, f = 24.595 kHz, L1 = 130 mH, L2 = 132 mH, and L3 = 214…

A: Redrawing the circuit by marking the current and the known values from the given points:

Q: Determine the equivalent inductance of the following circuit 10 mH ll 60 mH el 25 mH 20 mH a o ll ll…

A:

Q: Consider the parallel RLC circuit of Figure 2 with the source a 1-kHz sinusoid having an amplitude…

A: Redraw the given circuit as shown in Figure 1.

Q: What is the frequency of the input signal if the measured capacitive reactance is equal to 28 Q.…

A:

Q: 2. Convert the following values from microfarads to picofarads: a. 0.1 μF b. 0.0025 μF

A: a) Given data, Capacitance is 0.1 μF.

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).