A = 250 mm²- 300 mm 300 kN A = 400 mm²- 300 mm 600 kN 4.5 mm B B

Q: The bear cross section shown below has been proposed for a short pedestrian bridge. The cross…

A: Determonation of shear stress at H

Q: Only answer A. Explain why the obtained answer makes sense.

A: This question is related to the Strength of the material from Civil Engineering. As per question…

Q: Part A Determine the distance ī to the centroid of the beam's cross-sectional area. Set a = 70 mm ,…

A:

Q: The piece of rubber is originally rectangular. Calculate the average shear strain Yxy at A if the…

A: Given data in question Cross section 400 mm and 300 mmDisplacements 3 mm and 2 mmTo find out Average…

Q: Please calculate the deflection-y at point 5, and the deflection-x at point 2 based on the following…

A: ####Calculation of deflection Y at 5 and Deflection X at 2 Using Unit load Method of Analysis ####

Q: For the beam and loading shown, use discontinuity functions to compute (a) the slope of the beam at…

A: From the given beam and loading shown it is required to compute the slope of the beam at B and the…

Q: Two blocks of rubber, each 80 mm long by 40 mm wide by 20 mm thick, are bonded to a rigid support…

A: Given data : Length of each block = 80 mm width of each block = 40mm Thickness of each block = 20 mm…

Q: Calculate the moment of inertia about the x-axis. dx 4" 14.0 y y = b – kx² 14"

A: Given - For the given section in rectangle formb = 14in.h=18in.For the given section in parabolic…

Q: 0.0079 0.0032 0.0016 Let D= 0.0032 0.0063 0.0032 be a flexibility matrix, with flexibility measured…

A:

Q: locate the centroid of the beam section shown

A: To Determine Centroid of the T-beam section.

Q: Replace the forces acting on the bar by a resultant force and a couple moment about point A. Specify…

A:

Length and Length related Variables

Length can de defined as the measurement or extent of physical quantities or objects from one terminal to another terminal. Stone age humans used finger length, step length, and so on to measure the size or displacement of an object. Nowadays, depending on how precise the measurement requires to be and the object’s size is measured, we use measuring devices for measurements like rulers and steel tape. Most people have used a ruler or tape measure to measure a particular distance or the size of an object. For more precise measurements of tiny objects, the development of measurement tools such as the Vernier caliper, which permits us to measure dimensions within 1/1000 of an inch. In the last few decades, electronic distance measuring instruments (EDMI) have been implemented that permit us to measure distances from a few feet to many miles with reasonable accuracy.